A lettuce moisture detection method based on terahertz time-domain spectroscopy

ABSTRACT: For non-destructive detection of water stress in lettuce, terahertz time-domain spectroscopy (THz-TDS) was used to quantitatively analyze water content in lettuce. Four gradient lettuce water contents were used . Spectral data of lettuce were collected by a THz-TDS system, and denoised using the S-G derivative, Savitzky-Golay (S-G) smoothing and normalization filtering. The fitting effect of the pretreatment method was better than that of regression fitting, and the S-G derivative fitting effect was obtained. Then a calibration set and a verification set were divided by the Kennan-Stone algorithm, sample set partitioning based on joint X-Y distance (SPXY) algorithm, and the random sampling (RS) algorithm, and the parameters of RS were optimized by regression fitting. The stability competitive adaptive reweighted sampling, iteratively retained information variables and interval combination optimization were used to select characteristic wavelengths, and then continuous projection was used on basis of the three algorithms above. After the successive projection algorithm was re-screened, partial least squares regression was used into modeling. The regression coefficients Rc 2 and RMSEC reach 0.8962 and 412.5% respectively, and Rp 2 and RMSEP of the verification set are 0.8757 and 528.9% respectively.

Serial Combination Optimization Method of Packet Transport Network

Packet transport network (PTN) has problems such as waste of resources and low network stability due to the excessive complexity of the existing network or improper network architecture design. The optimization of the transport networks can not only make the network structure more reasonable but also reduce all kinds of unexpected scenarios in the network operation, improving the network efficiency and reducing the failure rate. This research will be optimized from three aspects. (1) In order to solve the problem of the same active and standby routing in the existing network, an optimization algorithm for the same active and standby routing of LSP is proposed. The essence of the optimization algorithm is to search the existing routing using the K -shortest path (KSP) between two network nodes as protection routing for LSP protection. (2) Aiming at the link with a high CIR bandwidth occupancy rate, a method is completed without adding optical fibers and other physical resources; an optimization method for the committed information rate bandwidth occupancy rate based on the KSP algorithm is proposed. (3) When the PTN ring formation rate is low, the security of the PTN is seriously reduced. In order to solve the problem of low ring formation rate in the network, this paper proposes a ring formation rate optimization scheme for PTN access layer equipment based on network elements accounting income. Through the experimental verification on the mobile PTN in one city, Hubei Province, the combination optimization method can improve the network LSP protection rate by 24%, the CIR bandwidth occupancy rate is reduced by 13.82%, and the nonring forming rate was reduced by 17.9%. This method improved network stability, reducing the risk of failure in service transportation effectively.

Forecasting Chinese Wind Power Installed Capacity Using a Novel Grey Model with Parameters Combination Optimization

The intermittent and uncertain characteristics of wind generation have brought new challenges for the hosting capacity and the integration of large-scale wind power into the power system. Consequently, reasonable forecasting wind power installed capacity (WPIC) is the most effective and applicable solution to meet this challenge. However, the single parameter optimization of the conventional grey model has some limitations in improving its modeling ability. To this end, a novel grey prediction model with parameters combination optimization is proposed in this paper. Firstly, considering the modeling mechanism and process, the order of accumulation generation of the grey prediction model is optimized by Particle Swarm Optimization (PSO) Algorithm. Secondly, as different orders of accumulation generation correspond to different parameter matrixes, the background value coefficient of the grey prediction model is optimized based on the optimal accumulation order. Finally, the novel model of combinational optimization is employed to simulate and forecast Chinese WPIC, and the comprehensive error of the novel model is only 1.34%, which is superior to the other three grey prediction models (2.82%, 1.68%, and 2.60%, respectively). The forecast shows that China’s WPIC will keep growing in the next five years, and some reasonable suggestions are put forward from the standpoint of the practitioners and governments.

Mapping the Growing Stem Volume of the Coniferous Plantations in North China Using Multispectral Data from Integrated GF-2 and Sentinel-2 Images and an Optimized Feature Variable Selection Method

Accurate measurement of forest growing stem volume (GSV) is important for forest resource management and ecosystem dynamics monitoring. Optical remote sensing imagery has great application prospects in forest GSV estimation on regional and global scales as it is easily accessible, has a wide coverage, and mature technology. However, their application is limited by cloud coverage, data stripes, atmospheric effects, and satellite sensor errors. Combining multi-sensor data can reduce such limitations as it increases the data availability, but also causes the multi-dimensional problem that increases the difficulty of feature selection. In this study, GaoFen-2 (GF-2) and Sentinel-2 images were integrated, and feature variables and data scenarios were derived by a proposed adaptive feature variable combination optimization (AFCO) program for estimating the GSV of coniferous plantations. The AFCO algorithm was compared to four traditional feature variable selection methods, namely, random forest (RF), stepwise random forest (SRF), fast iterative feature selection method for k-nearest neighbors (KNN-FIFS), and the feature variable screening and combination optimization procedure based on the distance correlation coefficient and k-nearest neighbors (DC-FSCK). The comparison indicated that the AFCO program not only considered the combination effect of feature variables, but also optimized the selection of the first feature variable, error threshold, and selection of the estimation model. Furthermore, we selected feature variables from three datasets (GF-2, Sentinel-2, and the integrated data) following the AFCO and four other feature selection methods and used the k-nearest neighbors (KNN) and random forest regression (RFR) to estimate the GSV of coniferous plantations in northern China. The results indicated that the integrated data improved the GSV estimation accuracy of coniferous plantations, with relative root mean square errors (RMSErs) of 15.0% and 19.6%, which were lower than those of GF-2 and Sentinel-2 data, respectively. In particular, the texture feature variables derived from GF-2 red band image have a significant impact on GSV estimation performance of the integrated dataset. For most data scenarios, the AFCO algorithm gained more accurate GSV estimates, as the RMSErs were 30.0%, 23.7%, 17.7%, and 17.5% lower than those of RF, SRF, KNN-FIFS, and DC-FSCK, respectively. The GSV distribution map obtained by the AFCO method and RFR model matched the field observations well. This study provides some insight into the application of optical images, optimization of the feature variable combination, and modeling algorithm selection for estimating the GSV of coniferous plantations.

Layout Methods for Integrated Energy Supply Service Stations from the Perspective of Combination Optimization

Integrated energy supply service stations (IES) are a new type of transportation energy infrastructure offering the advantages of comprehensive functions and intensive land use while providing more convenient and efficient energy supply services. Through the analysis of service station characteristics, this study regards the IES as a spatially superimposed combination of various energy supply services, proposes a layout method from the perspective of combination optimization, and establishes a station optimization model for energy supply stations. This method aims to further coordinate and optimize the combination of various energy supply stations to achieve global optimization of the energy supply service system. Finally, this study uses a hypothetical situation for example analysis to verify the validity and rationality of the method. The layout plan proposed in this study has important theoretical and practical significance for how to achieve the optimal layout of an IES.