Dynamic inversion of planar-chiral response of terahertz metasurface based on critical transition of checkerboard structures

Dynamic inversion of the planar-chiral responses of a metasurface is experimentally demonstrated in the terahertz regime. To realize this inversion, the critical transition of the checkerboard-like metallic structures is used. Resonant structures with planar chirality and their complementary enantiomeric patterns are embedded in the checkerboard. Using vanadium dioxide as a variable resistance, the metasurface is implemented in the terahertz regime. The responses of the metasurface to circularly polarized waves are then characterized by terahertz time-domain spectroscopy. Further, the sign of the circular conversion dichroism, which is closely related to the handedness of the planar chirality of the metasurface, is observed to be inverted at 0.64 THz by varying the temperature. Such invertible planar-chiral responses can be applied practically to the handedness-invertible chiral mirrors.

A lettuce moisture detection method based on terahertz time-domain spectroscopy

ABSTRACT: For non-destructive detection of water stress in lettuce, terahertz time-domain spectroscopy (THz-TDS) was used to quantitatively analyze water content in lettuce. Four gradient lettuce water contents were used . Spectral data of lettuce were collected by a THz-TDS system, and denoised using the S-G derivative, Savitzky-Golay (S-G) smoothing and normalization filtering. The fitting effect of the pretreatment method was better than that of regression fitting, and the S-G derivative fitting effect was obtained. Then a calibration set and a verification set were divided by the Kennan-Stone algorithm, sample set partitioning based on joint X-Y distance (SPXY) algorithm, and the random sampling (RS) algorithm, and the parameters of RS were optimized by regression fitting. The stability competitive adaptive reweighted sampling, iteratively retained information variables and interval combination optimization were used to select characteristic wavelengths, and then continuous projection was used on basis of the three algorithms above. After the successive projection algorithm was re-screened, partial least squares regression was used into modeling. The regression coefficients Rc 2 and RMSEC reach 0.8962 and 412.5% respectively, and Rp 2 and RMSEP of the verification set are 0.8757 and 528.9% respectively.

Optical Properties of Crystalline Lactose Fluidized with Dilutions of Various Substances in the Terahertz Frequency Range

Lactose is a commonly used component of pharmaceutical medications in tablet form. It was previously shown that lactose changes conformationally after saturation in fluidized beds with active pharmaceutical ingredients obtained by repeated dilution of antibodies to interferon-gamma in combination with an external intensive vibration treatment. Moreover, it was revealed that these solutions are self-organized dispersed systems in which nano-objects are formed. Their biological activity and mechanism of action were previously established as well. The current work was dedicated to investigating the optical properties of fluidized lactose powders in the terahertz frequency range. Spectral analyses of powders of crystalline lactose saturated in fluidized beds with a diluted solution of either glycine buffer, antibodies to interferon-gamma, or water were carried out, intact lactose served as a control. All powders were tableted before testing. In the course of the study, the macroscopic parameters of the tablets were established, at which they had a stable shape and their THz optical properties had no parasitic diffraction losses. These tablets were analyzed using terahertz time-domain spectroscopy in the frequency range of 0.2–2.6 THz. The differentiation between the spectra was conducted using a principal component analysis. The differences between intact lactose and the lactose saturated with any of studied solutions were demonstrated. Additionally, lactose saturated with solutions of multiple dilutions of a substance (antibodies or glycine buffer) differed not only from intact lactose, but also from lactose saturated with a diluted solution of water. Moreover, discrimination of lactose formulations saturated with different substances (antibodies or glycine buffer) was also possible. Additionally, intact lactose differed from lactose saturated with diluted water. The methods reported could be useful for the quality control of the medications based on the technology of repeated dilution of an original substance.

Ex-situ Spectroscopic Characterization of Residual Effects of Thermomechanical Loading on Polyurea

The residual effect of thermally and mechanically loaded polyurea samples was investigated in this study using terahertz time-domain spectroscopy (THz-TDS), operating in the transmission mode. Samples of different thicknesses were submerged in liquid nitrogen and reached cryogenic isothermal condition before equilibrating at room temperature. Another set of samples were extracted from quasi-statically loaded strips. All samples were then interrogated using THz-TDS since terahertz waves exhibit nonionizing interactions with polymers, eliminating the need for any post-loading preparatory steps of the samples. The time-domain terahertz signals were used to extract the optical and electrical properties as a function of sample thickness and loading conditions. The residual effect was prominent in the mechanically loaded samples compared to a nearly negligible presence in thermally loaded ones. On average, the thermally loaded polyurea results were subtle compared to the results of the unloaded samples, whereas samples that were mechanically stretched showed a considerable difference. Spectral analysis reported the frequency-dependent, complex refractive index of virgin and loaded polyurea as a function of thickness and spectral peaks associated with fundamental vibrational modes of the polyurea structure. The spectral peaks were in good agreement with previous research while elucidating the residual effect via the disappearance of three peaks in the low terahertz regime for mechanically loaded samples. In general, the refractive index was dependent on the loading conditions. Terahertz spectroscopy was shown to be a promising tool for future in situ and in operando investigations of field-dependent polymer responses.

Terahertz Spectral Properties of 5-Substituted Uracils

Applications of terahertz time-domain spectroscopy (THz-TDS) in the fields of chemistry and biomedicine have recently received increased attention. Specifically, THz-TDS is particularly effective for the identification of alkaloid molecules, because it can distinguish the vibration types of base molecules in the THz band and provide a direct characteristic spectrum for the configuration and conformation of biomolecules. However, when THz-TDS technology is used to identify alkaloid molecules, most of them are concentrated in the 0.1–3.0 THz band, limiting the amount of information that can be obtained. In this work, a wide-spectrum THz-TDS system was independently built to explore the absorption spectra of uracil and its 5-substituents in the range of 1.3–6.0 THz. We found that, in the THz band, uracil and its 5-substituents have similar absorption peaks near 4.9 and 3.3 THz, while the 5-substituents have an additional absorption peak in the range of 1.5–2.5 THz. This absorption peak is red-shifted as the relative atomic mass of the 5-substituted atoms increases. Gaussian software was adopted to calculate the absorption spectra of the samples. The simulation conclusions were in good agreement with the experimental results, revealing that the vibration of the base molecule at low frequencies can be attributed to the inter-molecular vibration. This work demonstrates that THz-TDS technology can be used to accurately identify biomolecules with similar molecular structures, reflecting the importance of molecular structure in biological activity.

Terahertz-Based Method for Accurate Characterization of Early Water Absorption Properties of Epoxy Resins and Rapid Detection of Water Absorption

Moisture is detrimental to the performance of epoxy resin material for electrical equipment in long-term operation and insulation. Therefore, moisture absorption is one of the critical indicators for insulation of the material. However, some relevant test methods, e.g., the direct weighing method, are time-consuming, and it usually takes months to complete a test. For this, it is necessary to have some modification to save the test time. Firstly, the study analyzes the present prediction method (according to ISO 62:2008). Under the same accuracy, the time required is reduced from 104 days to 71 days. Subsequently, the Langmuir curve-fitting method for water absorption of epoxy resin is analyzed, and the initial values of diffusion coefficient, bonding coefficient, and de-bonding coefficient are determined based on the results of molecular simulation, relevant experiment, and literature review. With the optimized prediction model, it takes only 1.5 days (reduced by 98% as compared with the standard prediction method) to determine the moisture absorbability. Then, the factors influencing the prediction accuracy are discussed. The results have shown that the fluctuation of balance at the initial stage will affect the test precision significantly. Accordingly, this study proposes a quantitative characterization method for initial trace moisture based on the terahertz method, by which the trace moisture in epoxy resin is represented precisely through the established terahertz time-domain spectroscopy system. When this method is used to predict the moisture absorbability, the experimental time may be further shortened by 33% to 1 day. For the whole water absorption cycle curve, the error is less than 5%.