Dynamic resistance and total loss in a three-tape REBCO stack carrying DC currents in perpendicular AC magnetic fields at 77 K

In many high-temperature superconducting (HTS) applications, HTS coated conductors carry a DC current under an external AC magnetic field. In such operating conditions, dynamic resistance will occur when the traversing magnetic flux across the HTS conductors. Consequently, AC loss within the superconductors is composed of the dynamic loss component arising from dynamic resistance and the magnetization loss component due to the AC external magnetic field. In this work, the dynamic resistance and the total loss in a three-tape HTS coated conductor stack were measured at 77 K under perpendicular AC magnetic fields up to 80 mT and DC currents (Idc) up to the critical current (Ic). The stack was assembled from three serial-connected 4 mm wide Superpower wires. The measured dynamic resistance results for the stack were well supported by the results from 2D H-formulation finite element modelling (FEM) and broadly agree with the analytical values for stacks. The FEM analysis shows asymmetric transport DC current profiles in the central region of the superconductor. We attribute the result to the superposition of DC currents and the induced subcritical currents which explains why the measured magnetization loss values increase with DC current levels at low magnetic field. The onset of dynamic loss for the stack for low i (Idc/ Ic) values is much slower when compared to that of the single tape and hence the contribution of the dynamic loss component to the total loss in the stack is much smaller than that of the single tape. Dynamic loss in the stack becomes comparable to the magnetization loss at i = 0.5 and becomes greater than the magnetization loss at i = 0.7. Both magnetization loss and dynamic loss in the stack are smaller than those of the single tape due to shielding effects.

Laminar and turbulent plasmoid ejection in a laboratory Parker Spiral current sheet

Quasi-periodic plasmoid formation at the tip of magnetic streamer structures is observed to occur in experiments on the Big Red Ball as well as in simulations of these experiments performed with the extended magnetohydrodynamics code, NIMROD. This plasmoid formation is found to occur on a characteristic time scale dependent on pressure gradients and magnetic curvature in both experiment and simulation. Single mode, or laminar, plasmoids exist when the pressure gradient is modest, but give way to turbulent plasmoid ejection when the system drive is higher, which produces plasmoids of many sizes. However, a critical pressure gradient is also observed, below which plasmoids are never formed. A simple heuristic model of this plasmoid formation process is presented and suggested to be a consequence of a dynamic loss of equilibrium in the high- $\beta$ region of the helmet streamer. This model is capable of explaining the periodicity of plasmoids observed in the experiment and simulations, and produces plasmoid periods of 90 minutes when applied to two-dimensional models of solar streamers with a height of $3R_\odot$ . This is consistent with the location and frequency at which periodic plasma blobs have been observed to form by Large Angle and Spectrometric Coronograph and Sun Earth Connection Coronal and Heliospheric Investigation instruments.

Detecting Multielement Algorithmically Generated Domain Names Based on Adaptive Embedding Model

With the development of detection algorithms on malicious dynamic domain names, domain generation algorithms have developed to be more stealthy. The use of multiple elements for generating domains will lead to higher detection difficulty. To effectively improve the detection accuracy of algorithmically generated domain names based on multiple elements, a domain name syntax model is proposed, which analyzes the multiple elements in domain names and their syntactic relationship, and an adaptive embedding method is proposed to achieve effective element parsing of domain names. A parallel convolutional model based on the feature selection module combined with an improved dynamic loss function based on curriculum learning is proposed, which can achieve effective detection on multielement malicious domain names. A series of experiments are designed and the proposed model is compared with five previous algorithms. The experimental results denote that the detection accuracy of the proposed model for multiple-element malicious domain names is significantly higher than that of the comparison algorithms and also has good adaptability to other types of malicious domain names.

Numerical Modeling of Dynamic Loss in HTS-Coated Conductors Under Perpendicular Magnetic Fields

© 2017 IEEE. High-Tc superconducting (HTS)-coated conductors are a promising option for the next-generation power devices. However, their thin-film geometry incurs dynamic loss when exposed to a perpendicular external ac magnetic field, which is difficult to predicate and estimate. In this paper, we propose and verify a numerical simulation model to predict the dynamic loss in HTS-thin-coated conductors by taking into account their Jc-B dependence and I-V characteristics. The model has been tested on a SuperPower YBCO-coated conductor, and we observed a linear increase of dynamic loss along the increasing field amplitude after the threshold field. Our simulation results agree closely with experimental measurements as well as an analytical model. Furthermore, the model can predict the nonlinear increase of dynamic loss at high current, while the analytical model deviates from the measurement results and still shows a linear correlation between the dynamic loss and the external magnetic field. In addition, we have used this model to simulate the distributions of magnetic field and current density when dynamic loss occurs. Results clearly show the flux traversing the coated conductor, which causes dynamic loss. These distributions have also been used to analyze the change of dynamic loss when either the transport current or the magnetic field increase individually, while the other factor remains constant. The simulation analysis on dynamic loss is done for the first time in this paper, and our results clearly demonstrate how dynamic loss changes as well as its dependence on transport current and magnetic field. © 2018 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works.

Numerical Modeling of Dynamic Loss in HTS-Coated Conductors Under Perpendicular Magnetic Fields

© 2017 IEEE. High-Tc superconducting (HTS)-coated conductors are a promising option for the next-generation power devices. However, their thin-film geometry incurs dynamic loss when exposed to a perpendicular external ac magnetic field, which is difficult to predicate and estimate. In this paper, we propose and verify a numerical simulation model to predict the dynamic loss in HTS-thin-coated conductors by taking into account their Jc-B dependence and I-V characteristics. The model has been tested on a SuperPower YBCO-coated conductor, and we observed a linear increase of dynamic loss along the increasing field amplitude after the threshold field. Our simulation results agree closely with experimental measurements as well as an analytical model. Furthermore, the model can predict the nonlinear increase of dynamic loss at high current, while the analytical model deviates from the measurement results and still shows a linear correlation between the dynamic loss and the external magnetic field. In addition, we have used this model to simulate the distributions of magnetic field and current density when dynamic loss occurs. Results clearly show the flux traversing the coated conductor, which causes dynamic loss. These distributions have also been used to analyze the change of dynamic loss when either the transport current or the magnetic field increase individually, while the other factor remains constant. The simulation analysis on dynamic loss is done for the first time in this paper, and our results clearly demonstrate how dynamic loss changes as well as its dependence on transport current and magnetic field. © 2018 IEEE. Personal use of this material is permitted. Permission from IEEE must be obtained for all other uses, in any current or future media, including reprinting/republishing this material for advertising or promotional purposes, creating new collective works, for resale or redistribution to servers or lists, or reuse of any copyrighted component of this work in other works.

Analysis of effect of modification of silica and carbon black co-filled rubber composite on mechanical properties

Silica and carbon black (CB) co-filled rubber composite was widely used for tire tread and other rubber products because of combined advantages of binary fillers, such as low hysteresis, good abrasion resistance, and reinforcement. Numerous studies have been focused on the filler–rubber interaction with the aim of obtaining optimum performances. To investigate the effect of modification on properties of rubber composite, modified silica and CB co-filled rubber composite was prepared with a multi-functional silane coupling agent, 2-aminoethyl-2-(3-triethoxysilylpropyl)aminoethyl disulfide (ATD). Such modification significantly enhanced the filler–rubber interaction and improved the filler dispersion. For the modified composites, the state of cure, hardness, tensile strength before and after aging, stress at 300% elongation, tear strength, abrasion resistance, rebound resilience, compression set, temperature rise, and the value of dynamic loss coefficient ranging from −20°C to 80°C were significantly improved, especially with low ATD dosage (3.0 phr). This modification provides an effective route to prepare silica and CB co-filled rubber composites with improved mechanical properties and dynamic mechanical properties.