ChemInform Abstract: SYMMETRICAL TRIAMINO-PER-O-METHYL-α-CYCLODEXTRIN: A HOST FOR PHOSPHATE ESTERS EXPLOITING BOTH HYDROPHOBIC AND ELECTROSTATIC INTERACTIONS IN AQUEOUS SOLUTION

1980 ◽  
Vol 11 (11) ◽  
Author(s):  
J. BOGER ◽  
J. R. KNOWLES
2016 ◽  
Vol 18 (27) ◽  
pp. 18255-18267 ◽  
Author(s):  
Eufrásia S. Pereira ◽  
Júlio C. S. Da Silva ◽  
Tiago A. S. Brandão ◽  
Willian R. Rocha

Ab initio molecular dynamics simulations revealed that phosphorane, an important intermediate in the hydrolysis of phosphate diesters, has a lifetime of ∼1 ps in aqueous solution. QTAIM and EDA analyses along the reaction coordinate show that the hydrolysis reaction of phosphate esters is driven mainly by electrostatic interactions.


2016 ◽  
Vol 73 (9) ◽  
pp. 2211-2221 ◽  
Author(s):  
Najoua Ben Douissa ◽  
Sonia Dridi-Dhaouadi ◽  
Mohamed Farouk Mhenni

Extracted cellulose from Posidonia oceanica was used as an adsorbent for removal of a cationic (Basic blue 9, BB) and anionic textile dye (Acid blue 25, AB) from aqueous solution in single dye system. Characterization of the extracted cellulose and extracted cellulose-dye systems were performed using several techniques such as Fourier transform infrared spectroscopy, X-ray photoelectron spectroscopy, zeta potential and Boehm acid–base titration method. Adsorption tests showed that the extracted cellulose presented higher adsorption of BB than AB in single dye system, revealing that electrostatic interactions are responsible, in the first instance, for the dye–adsorbent interaction. In single dye systems, the extracted cellulose presented the maximum adsorption capacities of BB and AB at 0.955 mmol.g−1 and 0.370 mmol.g−1, respectively. Adsorption experiments of AB dye on extracted cellulose saturated by BB dye exhibited the release of the latter dye from the sorbent which lead to dye–dye interaction in aqueous solution due to electrostatic attraction between both species. Interaction of BB and AB dyes were investigated using spectrophotometric analysis and results demonstrated the formation of a molecular complex detected at wavelengths 510 and 705 nm when anionic (AB) and cationic (BB) dye were taken in equimolar proportions. The adsorption isotherm of AB, taking into account the dye–dye interaction was investigated and showed that BB dye was released proportionately by AB equilibrium concentration. It was also observed that AB adsorption is widely enhanced when the formation of the molecular complex is disadvantaged.


Soft Matter ◽  
2015 ◽  
Vol 11 (38) ◽  
pp. 7494-7501 ◽  
Author(s):  
Xueyi Chang ◽  
Zhiyu Cheng ◽  
Biye Ren ◽  
Renfeng Dong ◽  
Jun Peng ◽  
...  

A voltage-responsive comb-like superamphiphilic block polymer PEG113-b-PAA30/FTMA was prepared based on the electrostatic interactions of a ferrocenyl surfactant (FTMA) and an oppositely charged poly-(ethylene glycol)-b-poly(acrylic acid) (PEG113-b-PAA30) in aqueous solution.


BIOPHYSICS ◽  
2009 ◽  
Vol 54 (2) ◽  
pp. 139-142
Author(s):  
V. P. Barannikov ◽  
V. G. Badelin ◽  
M. B. Berezin

2015 ◽  
Vol 103 (12) ◽  
Author(s):  
Sahar El-Sayed Abd El-Kader Sharaf El-Deen ◽  
Karam Fatwhi Allan ◽  
Mohamed Holeil ◽  
Gehan El-Sayed Abd El-Kader Sharaf El-Deen

AbstractIn this study, the adsorptive removal of selenium (IV) from aqueous solution by titanate nanoflower (TNF) was prepared via alkaline hydrothermal method. The morphology and crystal phase of the TNF were characterized by scanning electron microscopy (SEM), X-ray diffraction (XRD), energy dispersive X-ray spectroscope (EDX), selected area electron diffraction (SAED), thermogravimetric analysis (TGA), fourier transform infrared spectroscopy (FTIR) and specific surface area. This study was conducted to determine the influence of various operating parameters such as pH, adsorbate weight, initial anion concentration, contact time and solution temperature on the adsorptive removal of selenium (IV). Equilibrium adsorption data were analyzed using Freundlich, Langmuir and Dubinin–Radushkevich (D–R) isotherm models. The results demonstrated that the adsorption was well described by the Langmuir adsorption isotherm with the maximum adsorption capacity up to 46.52 mg/g at pH 3.5. The adsorption of Se(IV) anions onto the surface of TNF may proceed through outer sphere electrostatic interactions and/or inner-sphere complexation interaction. The kinetic data indicated that the adsorption fit well with the pseudo-second-order kinetic model. The thermodynamic parameters implied that the adsorption process was spontaneous and endothermic in nature.


2021 ◽  
Author(s):  
Fatemeh Sadegh ◽  
Nikolaos Politakos ◽  
Oihane Sanz ◽  
Ali Reza Modarresi-Alam ◽  
Radmila Tomovska

Abstract Composite Fenton nanocatalyst was prepared by water-based in situ creation of Fe3O4 nanoparticles integrated within self-assembly 3D reduced graphene oxide (rGO) aerogel. It was used for degradation of Acid Green 25 (AG-25) organic dye in aqueous solution, in presence of H2O2. By investigating the conditions that maximize the dye adsorption by the 3D composite, it was found that the pH of the solution should be adjusted between the pKa of the functional groups presented on the rGO surface (carboxylic acid) and that of the dye (sulfonic acid) to promote electrostatic interactions dye − 3D structure. Performed under these conditions, Fenton degradation of AG-25 in presence of H2O2 was completed in less than 30 min, including all the intermediate products, as demonstrated by MALDI-TOF-MS analysis of the aqueous solution after discoloration. Moreover, this was achieved in a solution with as high dye concentration as 0.5 mg/mL, with only 10 mg of 3D composite catalyst, at room temperature and without additional energy input. The high performance was attributed to the creation of charge transfer complex between the rGO and Fe3O4 nanoparticles throughout covalent bond C-O-Fe, the formation of which was promoted by the in situ synthesis procedure.


Sign in / Sign up

Export Citation Format

Share Document