Ion Implantation in the Surface Analysis of Solid Materials

1985 ◽  
pp. 33-47
Author(s):  
W. H. Gries
Keyword(s):  
Ion Implantation ◽  
Surface Analysis ◽  
Solid Materials

Surface analysis of polymers electrically improved by plasma-source ion-implantation

2002 ◽  
Vol 373 (7) ◽  
pp. 595-600 ◽  
Author(s):  
Yeonhee Lee ◽  
Seunghee Han ◽  
Hyuneui Lim ◽  
Youngwoo Kim ◽  
Haidong Kim
Keyword(s):  
Ion Implantation ◽  
Surface Analysis ◽  
Plasma Source ◽  
Plasma Source Ion Implantation

Electron Diffraction Analysis of Microtwin Structures in Regrown (III) Silicon

1982 ◽  
Vol 40 ◽  
pp. 460-461
Author(s):  
P. Ling ◽  
R. Gronsky ◽  
J. Washburn
Keyword(s):  
Electron Diffraction ◽  
Ion Implantation ◽  
Diffraction Analysis ◽  
Diffraction Pattern ◽  
Direct Consequence ◽  
The Other ◽  
Electron Diffraction Analysis ◽  
Defect Microstructures ◽  
Ion Implanted

The defect microstructures of Si arising from ion implantation and subsequent regrowth for a (111) substrate have been found to be dominated by microtwins. Figure 1(a) is a typical diffraction pattern of annealed ion-implanted (111) Si showing two groups of extra diffraction spots; one at positions (m, n integers), the other at adjacent positions between <000> and <220>. The object of the present paper is to show that these extra reflections are a direct consequence of the microtwins in the material.

Interlayer mixing in GaAs/AlxGa1-xAs heterostructures as a result of Se+ ion implantation

1988 ◽  
Vol 46 ◽  
pp. 908-909
Author(s):  
E.G. Bithell ◽  
W.M. Stobbs
Keyword(s):  
Ion Implantation ◽  
Diffusion Coefficients ◽  
Dark Field ◽  
Atomic Mass ◽  
Composition Profile ◽  
Semiconductor Heterostructures ◽  
Transmission Electron ◽  
Microscope Images ◽  
Damage Process ◽  
Electron Energy Loss

It is well known that the microstructural consequences of the ion implantation of semiconductor heterostructures can be severe: amorphisation of the damaged region is possible, and layer intermixing can result both from the original damage process and from the enhancement of the diffusion coefficients for the constituents of the original composition profile. A very large number of variables are involved (the atomic mass of the target, the mass and energy of the implant species, the flux and the total dose, the substrate temperature etc.) so that experimental data are needed despite the existence of relatively well developed models for the implantation process. A major difficulty is that conventional techniques (e.g. electron energy loss spectroscopy) have inadequate resolution for the quantification of any changes in the composition profile of fine scale multilayers. However we have demonstrated that the measurement of 002 dark field intensities in transmission electron microscope images of GaAs / AlxGa1_xAs heterostructures can allow the measurement of the local Al / Ga ratio.

Dynamic studies of silicide-mediated crystallization of amorphous silicon

1992 ◽  
Vol 50 (2) ◽  
pp. 1352-1353
Author(s):  
C. Hayzelden ◽  
J. L. Batstone
Keyword(s):  
Ion Implantation ◽  
Solid Phase ◽  
Metallic Phase ◽  
Single Crystal Substrate ◽  
Free Electrons ◽  
Melt Temperature ◽  
Transmission Electron ◽  
Crystal Substrate ◽  
High Resolution Tem

Epitaxial reordering of amorphous Si(a-Si) on an underlying single-crystal substrate occurs well below the melt temperature by the process of solid phase epitaxial growth (SPEG). Growth of crystalline Si(c-Si) is known to be enhanced by the presence of small amounts of a metallic phase, presumably due to an interaction of the free electrons of the metal with the covalent Si bonds near the growing interface. Ion implantation of Ni was shown to lower the crystallization temperature of an a-Si thin film by approximately 200°C. Using in situ transmission electron microscopy (TEM), precipitates of NiSi2 formed within the a-Si film during annealing, were observed to migrate, leaving a trail of epitaxial c-Si. High resolution TEM revealed an epitaxial NiSi2/Si(l11) interface which was Type A. We discuss here the enhanced nucleation of c-Si and subsequent silicide-mediated SPEG of Ni-implanted a-Si.Thin films of a-Si, 950 Å thick, were deposited onto Si(100) wafers capped with 1000Å of a-SiO2. Ion implantation produced sharply peaked Ni concentrations of 4×l020 and 2×l021 ions cm−3, in the center of the films.

Analysis of Silicon-On-Insulator Structures Formed By Oxygen Ion Implantation

1985 ◽  
Vol 43 ◽  
pp. 300-301
Author(s):  
N. Lewis ◽  
E. L. Hall ◽  
A. Mogro-Campero ◽  
R. P. Love
Keyword(s):  
Ion Implantation ◽  
Single Crystal ◽  
Single Crystal Silicon ◽  
Silicon Layer ◽  
Device Fabrication ◽  
Silicon On Insulator ◽  
High Dose ◽  
Crystal Silicon ◽  
Oxygen Ion ◽  
Oxygen Ion Implantation

The formation of buried oxide structures in single crystal silicon by high-dose oxygen ion implantation has received considerable attention recently for applications in advanced electronic device fabrication. This process is performed in a vacuum, and under the proper implantation conditions results in a silicon-on-insulator (SOI) structure with a top single crystal silicon layer on an amorphous silicon dioxide layer. The top Si layer has the same orientation as the silicon substrate. The quality of the outermost portion of the Si top layer is important in device fabrication since it either can be used directly to build devices, or epitaxial Si may be grown on this layer. Therefore, careful characterization of the results of the ion implantation process is essential.

Sign in / Sign up

Export Citation Format

Share Document