Microstrip Antenna Array Design for Generalized Spatial Modulation—Multiple Input Multiple Output (GSM-MIMO) Applications

Author(s):  
Raj Rajeshwari Lunawat ◽  
Debashis Adhikari ◽  
Priyanka Tupe Waghmare
2016 ◽  
Vol 2016 ◽  
pp. 1-10
Author(s):  
Shuainan Gu ◽  
Ke Li ◽  
Xiukun Ren ◽  
Na-e Zheng

The work presented here is concerned with the antenna array design in collocated multiple-input multiple-output (MIMO) radars. After knowing the system requirements, the antenna array design problem is formulated as a standard polynomial factorization. In addition, an algorithm based on Newton-Schubert-Kronecker (NSK) polynomial factorization is proposed. The algorithm contains three steps. First, linear factors are extracted by extended Vieta theorem. Then, undermined high-order factors are confirmed with Newton interpolation and certain high-order factors should be searched for within the undermined ones. Finally, the antenna array configurations are determined according to the result of polynomial factorization. Simulations confirm the wide use of the proposed algorithm in MIMO radar antenna array design.


2011 ◽  
Vol 20 (03) ◽  
pp. 515-529 ◽  
Author(s):  
CONSTANTINOS I. VOTIS ◽  
PANOS KOSTARAKIS ◽  
LEONIDAS P. IVRISSIMTZIS

The design of a multiple-output transmitter for digital beamforming (DBF), Multiple-Input Multiple-Output (MIMO) and channel sounder applications, based on Direct Digital Synthesis (DDS) system is presented and investigated in terms of antenna array performance. DDS generates independently modulated signals on specific carrier frequencies and is employed as the first stage in the proposed implementation, furnishing output signal of configurable amplitude, phase and frequency. The resulting phase progression, amplitude and beamforming accuracy of a beam steering array are further investigated, showing that the proposed architecture can provide a steering beam with high accuracy. Experimental results of system performance indicate that this architecture can drive efficiently and accurately an antenna array with independent modulated RF signals, with programmable frequency, initial phase, and magnitude.


Circuit World ◽  
2020 ◽  
Vol ahead-of-print (ahead-of-print) ◽  
Author(s):  
Premalatha J. ◽  
Sheela D.

Purpose This paper aims to present the design of a compact vertically polarized four-element UWB antenna suitable for MIMO communications. Design/methodology/approach The unit cell antenna is constructed using a square ring radiator excited through a stepped impedance feed. The proposed antenna covers the Ultra-wideband (UWB) spectrum ranging from 2.2 to 12.3 GHz. The isolation between the unit cell antennas in the array is enhanced using a simple microstrip line resonator. The decoupling element is connected to the ground through a via. Findings The proposed scheme offers at least 16 dB improvement in the port-to-port coupling. Furthermore, the four-element antenna array is constructed using a specific interlocking scheme. The proposed antenna array’s Multiple Input Multiple Output (MIMO) performance metrics are analyzed. Originality/value By suitably selecting the excitation port, directional radiation patterns can be realized. The combined radiation pattern covers 360 degrees. A prototype antenna array is fabricated, and the simulation results are verified using real-time experiments. The proposed antenna is a suitable candidate for shark fin housing in automotive communications.


Electronics ◽  
2019 ◽  
Vol 8 (12) ◽  
pp. 1509 ◽  
Author(s):  
Ismael Lopez ◽  
L. Pizano-Escalante ◽  
Joaquin Cortez ◽  
O. Longoria-Gandara ◽  
Armando Garcia

This paper presents a proposal for an architecture in FPGA for the implementation of a low complexity near maximum likelihood (Near-ML) detection algorithm for a multiple input-multiple output (MIMO) quadrature spatial modulation (QSM) transmission system. The proposed low complexity detection algorithm is based on a tree search and a spherical detection strategy. Our proposal was verified in the context of a MIMO receiver. The effects of the finite length arithmetic and limited precision were evaluated in terms of their impact on the receiver bit error rate (BER). We defined the minimum fixed point word size required not to impact performance adversely for n T transmit antennas and n R receive antennas. The results showed that the proposal performed very near to optimal with the advantage of a meaningful reduction in the complexity of the receiver. The performance analysis of the proposed detector of the MIMO receiver under these conditions showed a strong robustness on the numerical precision, which allowed having a receiver performance very close to that obtained with floating point arithmetic in terms of BER; therefore, we believe this architecture can be an attractive candidate for its implementation in current communications standards.


2016 ◽  
Vol 7 (4) ◽  
pp. 1-22 ◽  
Author(s):  
Chatkaew Jariyatantiwait ◽  
Gary G. Yen

Differential evolution is often regarded as one of the most efficient evolutionary algorithms to tackle multiobjective optimization problems. The key to success of any multiobjective evolutionary algorithms (MOEAs) is maintaining a delicate balance between exploration and exploitation throughout the evolution process. In this paper, the authors develop an Improved version of the Fuzzy-based Multiobjective Differential Evolution (IFMDE) that exploits performance metrics, specifically hypervolume, spacing, and maximum spread, to measure the state of the evolution progress. They apply the fuzzy inference rules, derived from domain knowledge, to these metrics in order to dynamically adjust the associated control parameters of a chosen mutation and crossover strategy used in this algorithm. One mutation parameter controls the degree of greedy or exploitation, while another regulates the degree of diversity or exploration of the reproduction phase. On the other hand, crossover rate controls the fraction of trial vector elements inherited from the mutant vectors. In doing so collectively, the authors can appropriately adjust the degree of exploration and exploitation through performance feedback. A 5 by 5 microstrip antenna array design problem is formulated as a three-objective optimization problem. The proposed IFMDE is applied to tackle this problem under real-world complications. Since the objective evaluations of a 5 by 5 microstrip antenna array are computationally very expensive, a radial basis function neural network is trained as a surrogate model for the fitness function approximations. The experimental results demonstrate the ability of IFMDE that it can find not only one, but a set of Pareto optimal solutions, specifically in terms of side lobe level and reflection coefficient. These multiple Pareto-optimal configurations can then be chosen from by a decision maker given dynamic operating environments, constraints and uncertainties.


Sign in / Sign up

Export Citation Format

Share Document