Magnetohydrodynamic flow through a rectangular duct due to a periodic pressure gradient-II

1969 ◽  
Vol 21 (1) ◽  
pp. 1-12
Author(s):  
K. K. Mandal
Keyword(s):  
Pressure Gradient ◽  
Magnetohydrodynamic Flow ◽  
Rectangular Duct ◽  
Periodic Pressure ◽  
Flow Through

Hemodynamic Method to Predict Whether Hunterian Ligation of the Basilar Artery Will Lead to Thrombosis of Basilar Bifurcation Aneurysms

Neurosurgery ◽  
1987 ◽  
Vol 20 (2) ◽  
pp. 249-253 ◽  
Author(s):  
Jack Chang ◽  
Margot R. Roach
Keyword(s):  
Pressure Gradient ◽  
Basilar Artery ◽  
Diameter Ratio ◽  
Phase Lag ◽  
Maximal Width ◽  
Before And After ◽  
Simple Measurement ◽  
Flow Through ◽  
Stop Flow

Abstract In some cases, basilar artery aneurysms cannot be repaired surgically and the basilar artery is occluded near the neck of the aneurysm to stop flow into the aneurysm. After the operation, the aneurysm can fill only by flow through the posterior communicating arteries (PCoAs). Hemodynamically, if the flow were the same in both PCoAs and there were no phase lag in the pressures, there would be no pressure gradient for flow to go across the neck of the aneurysm and therefore the aneurysm would thrombose. We have assumed that the diameter of the artery is roughly proportional to the flow that goes through it chronically. We measured the diameters of the PCoAs in 25 patients who had hunterian ligation of the basilar artery. We also measured the maximal width, height, and depth of the aneurysms on angiograms obtained before and after operation. Eleven aneurysms thrombosed completely and had a diameter ratio of > 0.6; 10 aneurysms thrombosed partially and had a diameter ratio of 0.46 ˜ 1.0; 4 aneurysms did not change and had a diameter ratio of <0.45. The ratio of the sizes of the PCoAs pre- and postoperatively was comparable in most cases, so we believe that it is possible to predict reasonably accurately from this simple measurement whether the aneurysm is likely to thrombose if the basilar artery is ligated.

A Topological Study of the Genesis of a Horseshoe Vortex in the Symmetry Plane Due to an Adverse Pressure Gradient

2001 ◽  
Author(s):  
Martijn A. van den Berg ◽  
Michael M. J. Proot ◽  
Peter G. Bakker
Keyword(s):  
Pressure Gradient ◽  
Bifurcation Theory ◽  
Nonlinear Differential Equations ◽  
Nonlinear Dynamical System ◽  
Symmetry Plane ◽  
Adverse Pressure Gradient ◽  
Horseshoe Vortex ◽  
Nonlinear Dynamical ◽  
Separating Flow ◽  
Flow Through

Abstract The present paper describes the genesis of a horseshoe vortex in the symmetry plane in front of a juncture. In contrast to a previous topological investigation, the presence of the obstacle is no longer physically modelled. Instead, the pressure gradient, induced by the obstacle, has been used to represent its influence. Consequently, the results of this investigation can be applied to any symmetrical flow above a flat plate. The genesis of the vortical structure is analysed by using the theory of nonlinear differential equations and the bifurcation theory. In particular, the genesis of a horseshoe vortex can be described by the unfolding of the degenerate singularity resulting from a Jordan Normal Form with three vanishing eigenvalues and one linear term which is related to the adverse pressure gradient. The examination of this nonlinear dynamical system reveals that a horseshoe vortex emanates from a non-separating flow through two subsequent saddle-node bifurcations in different directions and the transition of a node into a focus located in the flow field.

scholarly journals MHD Mixed Convection Micropolar Fluid Flow through a Rectangular Duct

2018 ◽  
Vol 2018 ◽  
pp. 1-8 ◽  
Author(s):  
Mekonnen Shiferaw Ayano ◽  
Stephen T. Sikwila ◽  
Stanford Shateyi
Keyword(s):  
Magnetic Field ◽  
Differential Equations ◽  
Mixed Convection ◽  
Applied Magnetic Field ◽  
Flow Reversal ◽  
Convection Flow ◽  
Temperature Profiles ◽  
Rectangular Duct ◽  
Micropolar Fluid Flow ◽  
Flow Through

Mixed convection flow through a rectangular duct with at least one of the sides of the walls of the rectangle being isothermal under the influence of transversely applied magnetic field has been analyzed numerically in this study. The governing differential equations of the problem have been transformed into a system of nondimensional differential equations and then solved numerically. The dimensionless velocity, microrotation components, and temperature profiles are displayed graphically showing the effects of various values of the parameters present in the problem. The results showed that the flow field is notably influenced by the considered parameters. It is found that increasing the aspect ratio increases flow reversal, commencement of the flow reversal is observed after some critical value, and the applied magnetic field increases the flow reversal in addition to flow retardation. The microrotation components flow in opposite direction; also it is found that one component of the microrotation will show no rotational effect around the center of the duct.

scholarly journals Modified boundary integral method for pressure driven MHD duct flow

1989 ◽  
Vol 12 (1) ◽  
pp. 159-174
Author(s):  
B. D. Aggarwala ◽  
P. D. Ariel
Keyword(s):  
Magnetic Field ◽  
Integral Method ◽  
Boundary Integral ◽  
Boundary Integral Method ◽  
Duct Flow ◽  
Rectangular Duct ◽  
Computationally Efficient ◽  
Electrically Conducting ◽  
Flow Through ◽  
The Magnetic Field

In this paper, we investigate the flow of a viscous, Incompressible, electrically conducting fluid through a rectangular duct in the presence of a magnetic field, when one of the boundaries perpedicular to the magnetic field is partly conducting and partly Insulating, by a modified Boundary Integral Method.Three problems are considered (i) flow through an infinite channel, (ii) flow through a rectangular duct when the conducting part is symmetrically situated, and (iii) flow through a rectangular duct when the conducting part is arbltrarily positioned.Such problems have been studied before by asymptotic means for large values of M, the Hartmann number. Hoverer, the present modification of the Boundary Integral Method renders the problem computationally efficient and provides a reliable numerical solution for all values of M. For large M, our coputation time decreases significantly.

Micropolar Fluid Flow Between Two Inclined Parallel Plates

2017 ◽  
Author(s):  
Abbas Hazbavi ◽  
Sajad Sharhani
Keyword(s):  
Fluid Flow ◽  
Pressure Gradient ◽  
Micropolar Fluid ◽  
Constant Heat Flux ◽  
Hydrodynamic Characteristics ◽  
Parallel Plates ◽  
Governing Equations ◽  
Micropolar Fluid Flow ◽  
Flow Through ◽  
The Magnetic Field

In this study, the hydrodynamic characteristics are investigated for magneto-micropolar fluid flow through an inclined channel of parallel plates with constant pressure gradient. The lower plate is maintained at constant temperature and upper plate at a constant heat flux. The governing equations which are continuity, momentum and energy are are solved numerically by Explicit Runge-Kutta. The effect of characteristic parameters is discussed on velocity and microrotation in different diagrams. The nonlinear parameter affected the velocity microrotation diagrams. An increase in the value of Hartmann number slows down the movement of the fluid in the channel. The application of the magnetic field induces resistive force acting in the opposite direction of the flow, thus causing its deceleration. Also the effect of pressure gradient is investigated on velocity and microrotation in different diagrams.

Sign in / Sign up

Export Citation Format

Share Document