An experimental study of influence of degree of swirling of a plasma air jet and introduction of natural gas into it on temperature and velocity fields

1978 ◽  
Vol 34 (2) ◽  
pp. 172-175
Author(s):  
S. P. Polyakov ◽  
P. F. Bulanyi ◽  
S. N. Pisanko
Author(s):  
Amir Allaf-Akbari ◽  
A. Gordon L. Holloway ◽  
Joseph Hall

The current experimental study investigates the effect of longitudinal core flow on the formation and structure of a trailing vortex. The vortex is generated using four airfoils connected to a central hub through which a jet flow is added to the vortex core. Time averaged vorticity, circumferential velocity, and turbulent kinetic energy are studied. The statistics of vortex wandering are identified and corrections applied to the vorticity distribution. The vortex generator used in this study was built on the basis of the design described by Beninati et al. [1]. It uses four NACA0012 airfoils connected to a central hub. The wings orientation can be adjusted such that each contributes to a strong trailing vortex on the center of the test section. The vortex generator also had the capability to deliver an air jet directed longitudinally through a hole in the hub at the joint of the airfoils. Tests were done without the jet and with the air jet at jet velocities of 10 and 20 m/s. Planar PIV was used to measure the velocity field in the vicinity of the vortex core. The measurements were taken at 3 chords behind the vortex generator.


2012 ◽  
Vol 16 (4) ◽  
pp. 1055-1065 ◽  
Author(s):  
Babak Kashir ◽  
Sadegh Tabejamaat ◽  
Mohammadi Baig

Author(s):  
V.A. Altunin ◽  
K.V. Altunin ◽  
M.R. Abdullin ◽  
M.R. Chigarev ◽  
I.N. Aliev ◽  
...  

The paper discovers the reasons for the transfer of single-use or reusable ground, air, aerospace, and space-based engines and power plants from liquid hydrocarbon fuels and coolers to gaseous fuels, or rather, to liquefied natural gas methane. The study gives specific examples of creating a new technology and using methane fuel and fuel in the existing units; lists the classes of methane engines and power plants, among which the main ones being piston engines and internal combustion power plants, air-jet engines and power plants, liquid propellant rocket engines and power plants. Findings of research show that it is necessary to experimentally study gaseous methane, so that it could be effectively used in advanced single-use or reusable ground, air, aerospace and space-based engines and power plants, and their features should be taken into account when designing and developing new technologies. The study introduces the results of the experimental study of thermal processes in gaseous methane during its natural convection, describes the experimental base in detail, as well as the procedure for conducting experiments, and develops methods for calculating the heat transfer coefficient to gaseous methane relying on the research results.


Author(s):  
Arnab Roy ◽  
Donald Ferguson ◽  
Todd Sidwell ◽  
Peter Strakey

Operational characteristics of an air breathing Rotating Detonation Combustor (RDC) fueled by natural gas-hydrogen blends are discussed in this paper. Experiments were performed on a 152 mm diameter uncooled RDC with a combustor to inlet area ratio of 0.2 at elevated inlet temperature and combustor pressure while varying the fuel split between natural gas and hydrogen over a range of equivalence ratios. Experimental data from short-duration (∼6sec) tests are presented with an emphasis on identifying detonability limits and exploring detonation stability with the addition of natural gas. Although the nominal combustor used in this experiment was not specifically designed for natural gas-air mixtures, significant advances in understanding conditions necessary for sustaining a stable, continuous detonation wave in a natural gas-hydrogen blended fuel were achieved. Data from the experimental study suggests that at elevated combustor pressures (2–3bar), only a small amount of natural gas added to the hydrogen is needed to alter the detonation wave operational mode. Additional observations indicate that an increase in air inlet temperature (up to 204°C) at atmospheric conditions significantly affects RDC performance by increasing deflagration losses through an increase in the number of combustion (detonation/Deflagration) regions present in the combustor. At higher backpressure levels the RDC exhibited the ability to achieve stable detonation with increasing concentrations of natural gas (with natural gas / hydrogen-air blend). However, losses tend to increase at intermediate air preheat levels (∼120°C). It was observed that combustor pressure had a first order influence on RDC stability in the presence of natural gas. Combining the results from this limited experimental study with our theoretical understanding of detonation wave fundamentals provides a pathway for developing an advanced combustor capable of replacing conventional constant pressure combustors typical of most power generation processes with one that produces a pressure gain.


Complexity ◽  
2021 ◽  
Vol 2021 ◽  
pp. 1-11
Author(s):  
Rashid Ayub ◽  
Shahzad Ahmad ◽  
Muhammad Imran Asjad ◽  
Mushtaq Ahmad

In this article, an unsteady free convection flow of MHD viscous fluid over a vertical rotating plate with Newtonian heating and heat generation is analyzed. The dimensionless governing equations for temperature and velocity fields are solved using the Laplace transform technique. Analytical solutions are obtained for the temperature and components of velocity fields. The obtained solutions satisfy the initial and boundary conditions. Some physical aspects of flow parameters on the fluid motion are presented graphically.


2012 ◽  
Vol 50 (4) ◽  
pp. 435-436 ◽  
Author(s):  
Benjamin Dewals ◽  
Sebastien Erpicum ◽  
Pierre Archambeau ◽  
Michel Pirotton

2013 ◽  
Vol 68 ◽  
pp. 505-511 ◽  
Author(s):  
Helmisyah Ahmad Jalaludin ◽  
Shahrir Abdullah ◽  
Mariyam Jameelah Ghazali ◽  
Bulan Abdullah ◽  
Nik Rosli Abdullah

Sign in / Sign up

Export Citation Format

Share Document