Relation between the static and the dynamic deformation indexes of rock in large-scale tests on rock masses

1968 ◽  
Vol 2 (11) ◽  
pp. 996-1001 ◽  
Author(s):  
S. B. Ukhov ◽  
A. S. Panenkov
2000 ◽  
Vol 132 (3) ◽  
pp. 345-351 ◽  
Author(s):  
Gary L. DeBarr ◽  
James L. Hanula ◽  
Christine G. Niwa ◽  
John C. Nord

AbstractSynthetic sex pheromones released in a loblolly pine, Pinus taeda L. (Pinaceae), seed orchard interfered with the ability of male coneworm moths, Dioryctria Zeller spp. (Lepidoptera: Pyralidae), to locate traps baited with sex pheromones or live females. Pherocon 1C® traps baited with synthetic pheromones or live conspecific females were hung near the center of two 1.2-ha circular plots during emergence of Dioryctria amatella (Hulst), Dioryctria disclusa (Heinrich), and Dioryctria merkeli (Mutuura and Munroe). In a paired design, trap catches for the mating-disruption treatment with synthetic pheromone dispensers consisting of three polyvinyl chloride rods placed in every tree were compared with the control treatment. Treatments were alternated at intervals of 2–3 d. Trap catches of D. amatella were reduced by 91% when plots were treated with 2.5 g/ha of Z-11-hexadencenyl acetate. Catches were reduced by 99.5% for D. disclusa and by 97% for D. merkeli when plots were treated with 12.5 g/ha of Z-9-tetradecenyl acetate, whereas catches of D. amatella were unaffected by this mating-disruption treatment. Daily disappearance of Z-9-tetradecenyl acetate from the dispensers averaged 0.46 g/ha or less. Manually placing dispensers on nylon lines in the tops of trees was an effective method for releasing synthetic Dioryctria pheromones in the orchard. These data suggest it may be feasible to prevent mating of Dioryctria spp. in pine seed orchards by using synthetic pheromones for mating disruption, but large-scale tests will be required to demonstrate cone protection.


2014 ◽  
Vol 2014 ◽  
pp. 1-10
Author(s):  
YanQun Zhou ◽  
YeZhi Zhang ◽  
MeiXin Ye ◽  
MengSi Zhan

The seismic behavior and plasticity spreading of a neotype column-slab high pier are researched in this paper. Four scale model tests of a web slab with two boundary columns are carried out under cyclic inelastic lateral displacements simulating seismic response. The test results show that the neotype column-slab high pier has strong and stable bearing capacity, good ductility, and energy dissipation capacity. The experimental values pertaining to the spread of plasticity are derived. An approach for deriving the spread of plasticity analytically is deduced and applied to the four tests. This method accurately assesses a pier’s spread of plasticity for most ductility levels. At nearly all ductility levels, the mean difference between analytical assessments of the spread of plasticity and results from 4 large-scale tests is 12% with a 9% coefficient of variation.


2021 ◽  
Author(s):  
Rabin Bhattarai ◽  
◽  
Yufan Zhang ◽  
Jacob Wood ◽  
◽  
...  

Construction activities entail substantial disturbance of topsoil and vegetative cover. As a result, stormwater runoff and erosion rates are increased significantly. If the soil erosion and subsequently generated sediment are not contained within the site, they would have a negative off-site impact as well as a detrimental influence on the receiving water body. In this study, replicable large-scale tests were used to analyze the ability of products to prevent sediment from exiting the perimeter of a site via sheet flow. The goal of these tests was to compare products to examine how well they retain sediment and how much ponding occurs upstream, as well as other criteria of interest to the Illinois Department of Transportation. The products analyzed were silt fence, woven monofilament geotextile, Filtrexx Siltsoxx, ERTEC ProWattle, triangular silt dike, sediment log, coconut coir log, Siltworm, GeoRidge, straw wattles, and Terra-Tube. Joint tests and vegetated buffer strip tests were also conducted. The duration of each test was 30 minutes, and 116 pounds of clay-loam soil were mixed with water in a 300 gallon tank. The solution was continuously mixed throughout the test. The sediment-water slurry was uniformly discharged over an 8 ft by 20 ft impervious 3:1 slope. The bottom of the slope had a permeable zone (8 ft by 8 ft) constructed from the same soil used in the mixing. The product was installed near the center of this zone. Water samples were collected at 5 minute intervals upstream and downstream of the product. These samples were analyzed for total sediment concentration to determine the effectiveness of each product. The performance of each product was evaluated in terms of sediment removal, ponding, ease of installation, and sustainability.


Author(s):  
Wouter Ockeloen ◽  
Coen Kuiper ◽  
Sjoerd van den Steen

The 'Afsluitdijk' is a 32 km enclosure dam which separates the Wadden sea and the Lake IJssel. The dam currently undergoes a major rehabilitation to meet the requirements with regard to water safety. The Dutch Ministry of infrastructure and Water Management (Rijkswaterstaat division) has commissioned Levvel, a consortium of BAM, Van Oord and Rebel, to prepare the design and carry out the reconstruction of the dam including sluices and highway. The project includes reinforcement of the armour layers and wave overtopping reduction. As part of the contract Rijkswaterstaat prescribed the contractor (Levvel) to verify the design with large scale physical model tests (min. 1:3 scale). These tests were carried out in the Delta Flume of Deltares. Prior to the large scale tests, smaller scale tests (1:20) have been carried out to optimize the design with regard to armour stability and wave overtopping. The research described here focuses on the wave overtopping.Recorded Presentation from the vICCE (YouTube Link): https://youtu.be/kPga0wVCCIE


2011 ◽  
Vol 1 (32) ◽  
pp. 65
Author(s):  
Thomas Lykke Andersen ◽  
Peter Frigaard ◽  
Michael R Rasmussen ◽  
Luca Martinelli

The present paper deals with loads on wind turbine access platforms. The many planned new wind turbine parks together with the observed damages on platforms in several existing parks make the topic very important. The paper gives an overview of recently developed design formulae for different types of entrance platforms. Moreover, the paper present new results on loads on grates based on both drag coefficient measurements and preliminary results on slamming from large scale tests. As expected both investigations show that platforms with grates give a significant reduction in the loads compared to closed plate platforms. The grate multiplication factor, defined as the peak load on the grate platform relative to the peak load on a closed plate platform was found approximately equal to the solidity of the grate.


2006 ◽  
Vol 932 ◽  
Author(s):  
Bernier Frédéric ◽  
Demarche Marc ◽  
Bel Johan

ABSTRACTThe EIG EURIDICE is responsible for performing large-scale tests, technical demonstrations and experiments so as to assess the feasibility of a final disposal of vitrified radioactive waste in deep clay layers. This programme is part of the Belgian Research and Development programme managed by ONDRAF/NIRAS. The research infrastructure includes the Underground Research Facilities HADES (URF HADES) in the Boom Clay geological formation and surface facilities. The achievements of the demonstration programme are the demonstration of the construction of shafts and galleries at industrial scale, the characterisation of the hydro-mechanical response of the host rock, and the “OPHELIE mock-up” a large scale hydration test under thermal load of pre-fabricated bentonite blocks. The future works will consist mainly in the realisation of the “PRACLAY experiments” including a large scale heater test. The large scale heater test has to demonstrate that Boom Clay is suitable, in terms of performance of the disposal system, to undergo the thermal load induced by the vitrified waste. The combined effect of the excavation and the thermal load will be investigated. A long term (more than 10 years) large scale heater test would be representative of the most penalizing conditions that could be encountered in the real disposal. The results of this test will constitute an important input for the Safety and Feasibility Cases 1 (SFC-1, 2013) and 2 (SFC-2, 2020).


Sign in / Sign up

Export Citation Format

Share Document