Effect of Freeze–Thaw Temperature and Number of Cycles on the Physical and Mechanical Properties of Marble

2020 ◽  
Vol 39 (1) ◽  
pp. 567-582
Author(s):  
Xuedong Luo ◽  
Shengtao Zhou ◽  
Bin Huang ◽  
Nan Jiang ◽  
Mengxin Xiong
Keyword(s):  
Mechanical Properties ◽  
Physical And Mechanical Properties ◽  
Freeze Thaw ◽  
Number Of Cycles

scholarly journals Effect of freeze–thaw cycle on physical and mechanical properties and damage characteristics of sandstone

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Longxiao Chen ◽  
Kesheng Li ◽  
Guilei Song ◽  
Deng Zhang ◽  
Chuanxiao Liu
Keyword(s):  
Mechanical Properties ◽  
Shear Failure ◽  
Triaxial Compression ◽  
Physical And Mechanical Properties ◽  
Freeze Thaw ◽  
Damage Characteristics ◽  
Large Pore ◽  
Natural Rock ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle

AbstractRock deterioration under freeze–thaw cycles is a concern for in-service tunnel in cold regions. Previous studies focused on the change of rock mechanical properties under unidirectional stress, but the natural rock mass is under three dimensional stresses. This paper investigates influences of the number of freeze–thaw cycle on sandstone under low confining pressure. Twelve sandstone samples were tested subjected to triaxial compression. Additionally, the damage characteristics of sandstone internal microstructure were obtained by using acoustic emission (AE) and mercury intrusion porosimetry. Results indicated that the mechanical properties of sandstone were significantly reduced by freeze–thaw effect. Sandstone’ peak strength and elastic modulus were 7.28–37.96% and 6.38–40.87% less than for the control, respectively. The proportion of super-large pore and large pore in sandstone increased by 19.53–81.19%. We attributed the reduced sandstone’ mechanical properties to the degenerated sandstone microstructure, which, in turn, was associated with increased sandstone macropores. The macroscopic failure pattern of sandstone changed from splitting failure to shear failure with an increasing of freeze–thaw cycles. Moreover, the activity of AE signal increased at each stage, and the cumulative ringing count also showed upward trend with the increase of freeze–thaw number.

Mechanical properties and freeze-thaw resistances of bronze-concrete composites

2021 ◽  
Vol 12 (2) ◽  
pp. 39
Author(s):  
Tuba Bahtli ◽  
Nesibe Sevde Ozbay
Keyword(s):  
Mechanical Properties ◽  
Bending Strength ◽  
Physical And Mechanical Properties ◽  
Ultrasonic Pulse Velocity ◽  
Ultrasonic Pulse ◽  
Test Methods ◽  
Pulse Velocity ◽  
Plastic Energy ◽  
Freeze Thaw ◽  
Schmidt Rebound Hammer

Studies in the literature show that the physical and mechanical properties of concrete could be improved by the incorporation of different kinds of industrial waste, including waste tire rubber and tire steel. Recycling of waste is important for economic gain and to curb environmental problems. In this study, finely ground CuAl10Ni bronze is used to improve the physical and mechanical properties, and freeze-thaw resistances of C30 concrete. The density, cold crushing strength, 3-point bending strength, elastic modulus, toughness, and freeze-thaw resistances of concrete are determined. In addition, the Schmidt Rebound Hammer (SRH) and the ultrasonic pulse velocity (UPV) tests, which are non-destructive test methods, are applied. SEM/EDX analyses are also carried out. It is noted that a more compacted structure of concrete is achieved with the addition of bronze sawdust. Then higher density and strength values are obtained for concretes that are produced by bronze addition. In addition, concretes including bronze sawdust generally show higher toughness due to high plastic energy capacities than pure concrete.

scholarly journals Impact of Drying and Wetting Cycles on Vegetation Cement-soil Physical and Mechanical Properties

2021 ◽  
Vol 20 (4) ◽  
Author(s):  
Xudong Hu ◽  
Jiazhen Gao ◽  
Mingtao Zhou ◽  
Songtao Peng ◽  
Wennian Xu ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Moisture Content ◽  
Initial Moisture Content ◽  
Meteorological Condition ◽  
Physical And Mechanical Properties ◽  
Friction Angle ◽  
Optimal Choice ◽  
The Stability ◽  
Number Of Cycles ◽  
Cement Soil

The physical and mechanical properties of the ecological slope protection substrate will be affected by long-term variation of the meteorological condition, resulting in the stability of the substrate being reduced. So an artificial substrate of vegetation cement-soil was selected as the research object to prepare specimens with the different initial moisture content of 13%, 19%, 25%, 31%, 37%, and 43%. And a series of tests are conducted to investigate the evolution of the physical and mechanical properties under drying-wetting cycling conditions. Typical results of the vegetation cement-soil evolution can be divided into three stages: cement hydration stage, shrinkage stage, and stabilization stage. In terms of different initial moisture content, the shrinkage cracks number, cracks length, crack width, and cracks surface area are increased first and then stabilize with the increase of the number of drying-wetting cycles. In contrast, the cohesion and internal friction angle of the vegetation cement-soil is reduced with the increase of the number of cycles. Comprehensive analysis shows that the initial moisture content of vegetation cement soil ranges from 25% to 31% is the optimal choice to ensure substrate stability in production practice.

scholarly journals PHYSICAL AND MECHANICAL PROPERTIES RESEARCH AND ANALYSIS OF CONCRETE WITH BIOFUEL COMBUSTION FLY ASH SUPPLEMENT

2019 ◽  
Vol 11 (0) ◽  
pp. 1-5
Author(s):  
Deividas Augutis ◽  
Džigita Nagrockienė
Keyword(s):  
Mechanical Properties ◽  
Fly Ash ◽  
Physical And Mechanical Properties ◽  
Ultrasonic Pulse Velocity ◽  
Ultrasonic Pulse ◽  
Pulse Velocity ◽  
Ash Content ◽  
Closed Porosity ◽  
Freeze Thaw ◽  
Materials Used

Materials used for the study: Portland cement CEM I 42,5 R, 0/4 fraction sand, 4/16 fraction gravel, biofuel fly ash, superplastizer ViscoCrete D187 (V) and water. Seven compositions of concrete were designed by replacing 0%, 5%, 10%, 15%, 20%, 25% and 30% of cement with biofuel fly ash. The article analyses the effect of biofuel fly ash content on the properties of concrete. Studies have shown that the increase of biofuel fly ash content up to 15% increases concrete density and compressive strengh after 28 days of curing, compressive strength, ultrasonic pulse velocity, closed porosity, concrete forecasted freeze-thaw cycles and decreases water absorbtion, open porosity.

Experimental Study on Damage Deterioration and Tensile Characteristics of Rock under Freeze-Thaw Environment

2012 ◽  
Vol 518-523 ◽  
pp. 1749-1752
Author(s):  
Hui Mei Zhang ◽  
Geng She Yang ◽  
Yuan Liang
Keyword(s):  
Mechanical Properties ◽  
Physical And Mechanical Properties ◽  
Mechanical Problem ◽  
Mode Fracture ◽  
Red Sandstone ◽  
Freeze Thaw ◽  
Thaw Cycle ◽  
Freeze Thaw Cycle ◽  
Tensile Experiment ◽  
Cycling Experiment

The basic mechanical problem facing of environmental geotechnical engineering in cold regions is the physical and mechanical properties of rocks under freeze-thaw conditions. The freeze-thaw cycling experiment was conducted first for two types of rock which are red sandstone and shale, then the splitting tensile experiment on different freeze-thaw cycles. The damage deterioration and breaking behavior under freeze-thaw conditions was investigated, and the influence of lithology and freeze-thaw cycle on anti-tensile characteristics of rock was studied. It is shown that three freeze-thaw damage deterioration modes of two kinds of rock are spalling mode, fracture mode and crack mode. The freeze-thaw cycle leads to irreversible deterioration on physical and mechanical properties for rock, but the damage of red sandstone is more serious than that of shale by the number of freeze-thaw cycles. The regularity of freeze-thaw effects of compression and tensile characteristics for two rocks are identical, but the tensile characteristic is more sensitive to freeze-thaw cycle.

Sign in / Sign up

Export Citation Format

Share Document