Radiological, structural and chemical characterization of raw materials and ceramic tiles in Serbia

2019 ◽  
Vol 323 (2) ◽  
pp. 861-874
Author(s):  
Predrag Kuzmanović ◽  
Nataša Todorović ◽  
Jovana Nikolov ◽  
Jovana Knežević ◽  
Bojan Miljević
2014 ◽  
Vol 1024 ◽  
pp. 211-214 ◽  
Author(s):  
Pao Ter Teo ◽  
Abu Seman Anasyida ◽  
Mohd Sharif Nurulakmal

The increasing production of steel leads to an increment of solid wastes generated especially Electric Arc Furnace (EAF) slag. This becomes a serious concern as the slag has to be disposed in a proper manner in order to avoid dumping in landfills which will eventually occupy available land and may cause permanent damage to the flora and fauna. In this project, an attempt was made to utilize the EAF slag as one of the raw materials in ceramic tiles. Results obtained showed that as percentage of EAF slag added was increased up to 60%, percentage of apparent porosity and water absorption were found to increase, accompanied by reduction in flexural strength due to more severe porosity was observed in the tiles. On the other hand, reducing the percentage of EAF slag up to 40% while increasing percentage of ball clay added led to formation of higher total percentage of anortite and wollastonite minerals. This would contribute to higher flexural strength of tiles. In addition, by adding silica and feldspar, the flexural strength of tile produced was further improved due to optimization of densification process. Highest flexural strength of EAF slag based tiles was attained at composition of 40% EAF slag 30% ball clay 10% feldspar 20% silica. It was observed that properties of ceramic tiles added with EAF slag, especially flexural strength are comparable with commercial ceramic tiles. Therefore, the EAF slag ceramic tiles have great potential to be made into high flexural strength or wear resistant floor tiles.


2019 ◽  
Vol 11 (7) ◽  
pp. 1995 ◽  
Author(s):  
Sabrina Cajamarca ◽  
Douglas Martins ◽  
Juscimar da Silva ◽  
Mariana Fontenelle ◽  
Ítalo Guedes ◽  
...  

Several agro-industrial, livestock, and food wastes can be recycled to create biofertilizers. This diversity of raw materials can result in nutritional imbalance and an increase in heavy metal content, which could make the final product unfeasible. Thus, the chemical characterization of the raw materials and their influence on the sustainable and safe production of biofertilizers need to be better understood. In this context, the objective of the present study was to evaluate the chemical characteristics of agro-industrial residues used in the manufacture of an aerobic liquid biofertilizer. We analyzed the macronutrient, micronutrient, and trace metal contents of seven waste products used as raw materials to create a biofertilizer. In addition, a survey of secondary biofertilizer data from different residues was carried out that showed great heterogeneity in the chemical compositions of these residues, which has a direct impact on the agronomic efficiency of these biofertilizers. The characterization revealed that some materials may be contaminants of the soil, due to high levels of trace metals, especially cadmium. We conclude that the generation of detailed inventories, such as those of the nutrient and heavy metal contents of the raw materials and biofertilizers produced, is indispensable for the correct recommendation of biologically-based inputs in agriculture.


Holzforschung ◽  
2016 ◽  
Vol 70 (9) ◽  
pp. 819-828 ◽  
Author(s):  
Caroline Sartori ◽  
Graciene da Silva Mota ◽  
Joana Ferreira ◽  
Isabel Miranda ◽  
Fábio Akira Mori ◽  
...  

Abstract Eucalyptus urophylla hybrids are important raw materials for the forest industry in Brazil, and large quantities of barks are available at mill site that may be used for added-value products. The chemical composition of barks of six commercial hybrids clones of E. urophylla×E. grandis, E. urophylla×E. Camaldulensis, and undisclosed E. urophylla hybrids was studied. The hybrids had similar composition, on average (data based on oven dry bark): 16% extractives, mainly corresponding to polar compounds that are soluble in ethanol and water, 19% lignin, 47% polysaccharides, 1% suberin, and 2% ash. The polysaccharides consists mainly of cellulose as indicated by 84% of total neutral monosaccharides in the acid hydrolysate and 10% xylose. The compositions of the lipophilic extracts was determined by GC-MS before and after alkaline hydrolysis. In all the barks, fatty acids, and triterpenes (namely: betulinic and ursolic acids) were the most abundant compounds followed by smaller amounts of sterols, long-chain aliphatic alcohols, phenolic acids, and acylglycerols. The ethanol-water bark extract had a high phenolic content: total phenolics ranged 211–551 mg gallic acid equivalents (GAE) g-1 of extract, tannins 76–184 mg catechin equivalents (CE) g-1 extract, and flavonoids 98–234 mg CE g-1 of extract. The antioxidant activity corresponds to 338 mg Trolox g-1 of extract. Development of high-value products is proposed through an integrated biorefinery approach including valorisation of extractives and targeting for cellulose-based applications.


2013 ◽  
Vol 66 (1) ◽  
pp. 91-98 ◽  
Author(s):  
José Manuel Rivas Mercury ◽  
Domingos de Jesus Costa Pereira ◽  
Nazaré do Socorro Lemos Silva Vasconcelos ◽  
Aluísio Alves Cabral Jr. ◽  
Romulo Simões Angélica

This work involved the first-ever characterization of antique Portuguese ceramic wall tiles in the Historic Center of São Luis do Maranhão, Brazil. The tiles were characterized by optical microscopy, X-ray diffraction (XRD) and chemical analysis to identify the possible raw materials used in the fabrication process, as well as the firing temperature of these materials. The results indicate that the microstructure of these materials consists of pores of varying sizes with calcite incrustations and quartz grain sizes smaller than 500 µm distributed in a pinkish yellow matrix, which were identified by XRD as calcite, gehlenite, wollastonite, quartz, and amorphous mineral phases. Based on this information, it can be inferred that the original raw materials probably consisted of a mixture of kaolinitic clays (Al2O3·2SiO2·2H2O) rich in calcium carbonates and quartz, or mixtures of kaolinitic clays, quartz and calcite, which did not reach the pre-firing temperature of 950ºC.


2010 ◽  
Vol 13 (1-2) ◽  
pp. 77
Author(s):  
H.C. Mandavia ◽  
K.V.R. Murthy ◽  
R.U. Purohit ◽  
P.K. Patel ◽  
B.M. Sharma

Many flooring materials most of them are in natural form are used to manufacture floor tiles for household flooring purpose. The peoples demand for variety of flooring material Leeds to develop various types of ceramic tiles. In India ceramic industry is fast growing one, more then 400 units of manufacturing ceramic tiles, vitrified tiles and sanitary ware, situated around Morbi, Rajkot, Gujarat, India. Many natural minerals are used as the raw materials required for the manufacturing ceramic ware. The following minerals are used to manufacturing the ceramic tiles i.e. Quartz, Feldspar, Zircon, Talc, Grog, Alumina oxide, etc. Most of the minerals are from Indian mines of Gujarat and Rajasthan states, some of are imported from Russian sub continent. The present paper reports the thermoluminescence (TL) characteristics of Feldspar, Alumina and Quartz minerals collected from the ceramic tiles manufacturing unit, Morbi. The as received minerals Natural TL was recorded (NTL), and annealed and quenched from 400 °C and 800 °C followed by 15Gy beta dose given from Sr-90 beta source TL was recorded and the comparative TL (Thermoluminescence) study of above materials are presented. The characterization of the minerals is done using TGA and XRD studies.


2021 ◽  
Vol 11 (6) ◽  
pp. 51-53
Author(s):  
Kundan Patil

Calcium is one of the essential elements for living beings. As a supplement, it is used to treat Calcium deficiencies due to a calcium deficient diet. In Rasaratnasamuchchaya Calcium bhasma (Eggshell bhasma) is included as a rich calcium supplement. There is a need for work on the determination of the percentage of Calcium in the eggshell and its limit of acceptance. Easy absorption of bhasma in the body is possible when its preparation is carried out in an acidic medium. Lemon juice is one of the acidic mediums employed for this purpose at pH 2.4. The eggshell powder is subjected to five calcination cycles to convert it into the Bhasma. Analysis of Eggshell Bhasma has been done by various modern analytical techniques to determine its exact chemical compositions. Various instrumental methods like XRD, FTIR, and SEM have been incorporated for analysis of raw materials, intermediates as well as final products. The calcium carbonate present in eggshells is in calcite form. In the present work, structural and chemical characterization of eggshell bhasma was carried out to develop an analytical profile of it.


2016 ◽  
Vol 869 ◽  
pp. 191-194
Author(s):  
Carolina del Roveri ◽  
R.A. Cunha ◽  
Antenor Zanardo ◽  
Letícia Hirata Godoy ◽  
Maria Margarita Torres Moreno ◽  
...  

The Santa Gertrudes ́ Ceramic Polo is the Brazilian region with national and international prominence in the manufacturing of ceramic tiles. Some raw materials used by ceramic industry and coatings industries in this region were characterized in terms of chemical-mineralogical and microscopic view, in order to promote the best technological characterization of them. For this, chemical analysis of major elements and trace X-ray diffraction and microscopic analysis by SEM, TEM and Electron microprobe were performed by ICP-MS. The results showed that the raw materials commonly referred to as "clays" are actually constituted by various mineral phases, which directly influence the properties of the same ceramics. Also showed that, by virtue of this constitution, different formulations can be developed, using the best raw materials found in the region of Santa Gertrudes, SP.


2016 ◽  
Vol 81 (2) ◽  
pp. 364-374 ◽  
Author(s):  
Sarah Trabert ◽  
Sunday Eiselt ◽  
David V. Hill ◽  
Jeffrey Ferguson ◽  
Margaret Beck

AbstractProtohistoric Ancestral Apache Dismal River groups (A.D. 1600–1750) participated in large exchange networks linking them to other peoples on the Plains and U.S. Southwest. Ceramic vessels made from micaceous materials appear at many Dismal River sites, and micaceous pottery recovered from the Central High Plains is typically seen as evidence for interaction with northern Rio Grande pueblos. However, few mineral or chemical characterization analyses have been conducted on these ceramics, and the term “micaceous” has been applied to a broad range of vessel types regardless of the form, size, or amount of mica in their pastes. Our recent analyses, including macroscopic evaluation combined with petrography and neutron activation analyses (NAA), indicate that only a small subset of Dismal River sherds are derived from New Mexico clays. The rest were likely manufactured using materials from Colorado and Wyoming. Seasonal mobility patterns may have given Dismal River potters the opportunity to collect mica raw materials as they traveled between the Central Plains and Front Range, and this has implications for the importance of internal Plains social networks during the Protohistoric and Historic periods.


2009 ◽  
Vol 8 ◽  
pp. 79-88 ◽  
Author(s):  
M. Pereira ◽  
T. de Lacerda-Arôso ◽  
M.J.M. Gomes ◽  
A. Mata ◽  
L.C. Alves ◽  
...  

Ancient ceramic wall tiles, called “azulejo”, firstly used on Portuguese churches, monasteries and palaces (15-18th century) have progressively been used in particular houses till the last century. These tiles and its use in huge decorative panels can be considered as a precious but fragile cultural heritage from Brazil to India, in several countries influenced by Portuguese culture. Morphologically, these tiles are composed by a porous clay-based ceramic body, the terracotta, covered by a protective glassy phase, the glaze. As artistic paintings, these murals incorporated various kinds of pigments in the glaze layer to create a pictorial impact on the walls of rich palaces or churches, real and durable monumental works-of-art. In the 21st century, degradation marks are visible on these ceramic tiles because of their use under corrosive conditions (moisture, atmospheric cycles…) along centuries. In order to promote their conservation and enhance their restoration, the physical-chemical characterization of the azulejos is performed in the present work, using mainly non-destructive processes like micro-Raman spectroscopy or X-Ray diffraction. In particular, Raman spectroscopy allows the detection of some nano/microcrystals present in the amorphous glaze due to pigments or opacifying agents or related to the elaboration process of the azulejo. Based on the observation of various selected fragments, one states that very few pigments have been used as colouring agents in this ceramic art during 17-18th centuries. Thus, the relationship between the different colours, the introduced pigments and the structural aspects of the glass will be focused. Some features related with the ancient ceramic technology will also be discussed.


Sign in / Sign up

Export Citation Format

Share Document