scholarly journals Production of no-carrier-added 89Zr at an 18 MeV cyclotron, its purification and use in investigations in solvent extraction

2021 ◽  
Vol 328 (1) ◽  
pp. 419-423
Author(s):  
Alexander Mansel ◽  
Karsten Franke
Keyword(s):  
Solvent Extraction ◽  
Chemical Separation ◽  
Extraction Process ◽  
Liquid Extraction ◽  
Radiotracer Technique ◽  
Liquid Liquid Extraction ◽  
Extraction And Purification ◽  
Uteva Resin ◽  
Efficient Extraction ◽  
No Carrier Added

AbstractThe chemical separation of zirconium from lanthanides by liquid–liquid extraction is challenging but critical for medical and technological applications. Using the example of 89Zr, we optimize the liquid–liquid-extraction process by means of the radiotracer technique. We produced 89Zr by proton irradiation of a metallic yttrium target at a cyclotron. The purification of the radionuclide was performed by a UTEVA resin. 89Zr was separated in no-carrier-added form in a sulfuric acid solution. 89Zr was successfully used in solvent extraction tests with calixarenes for the separation of zirconium from lanthanides. This reaction is suitable for the efficient extraction and purification of lanthanides.

STUDIES OF SOLVENT EXTRACTION AND SUPPORTED LIQUID MEMBRANE WITH REACTIVE DYES FROM AQUEOUS SOLUTIONS USING ALIQUOT 336 AS CARRIER

2015 ◽  
Vol 1 (01) ◽  
pp. 54-60
Author(s):  
G Muthuraman
Keyword(s):  
Solvent Extraction ◽  
Liquid Membrane ◽  
Reactive Dyes ◽  
Extraction Process ◽  
Liquid Extraction ◽  
Supported Liquid Membrane ◽  
Liquid Liquid Extraction ◽  
Dye Transport ◽  
Stage Process ◽  
The Stability

The liquid-liquid extraction (LLE) and supported liquid membrane (SLM) studies of reactive dyes namely Gold Yellow (GYHE-R) and Reactive Green HE 4BD (RGHE-4BD) from aqueous solution using Aliquot 336 as the carrier has been investigated. Polytetrafluoroethylene (PTFE) membrane with 0.5 μm pore size has been used after impregnated with Aliquot 336 in dichloromethane. In liquid liquid extraction the following parameters had been optimized; pH of feed, diluent, carrier , strip and dye concentration and the same parameters have been applied to supported liquid membrane (SLM) study to transport dye from aqueous solution.The main advantages SLM study is; the extraction and stripping as single stage process and low consumption of carrier in the membrane phase compared to the solvent extraction process. The other parameters such as transport time, stirring speed and mechanism of dye transport has also studied by SLM. The percentage of transport of dye and flux rate increases with increasing time. The stability of membrane is satisfactory over 5 days.

Reactor production of no-carrier-added 199Au for biomedical applications

RSC Advances ◽  
2016 ◽  
Vol 6 (86) ◽  
pp. 82832-82841 ◽  
Author(s):  
K. V. Vimalnath ◽  
Sudipta Chakraborty ◽  
Ashutosh Dash
Keyword(s):  
Ethyl Acetate ◽  
Biomedical Applications ◽  
Chemical Separation ◽  
Liquid Extraction ◽  
Liquid Liquid Extraction ◽  
Reactor Production ◽  
No Carrier Added

This investigation described development of a technology for the reactor production of no-carrier-added (NCA) 199Au using natural Pt target followed by chemical separation of 199Au employing liquid–liquid extraction (LLX) using ethyl acetate.

Comparison of Sorption and Extraction Methods for Recovery of Trace Organics from Water

1983 ◽  
Vol 15 (6-7) ◽  
pp. 149-159 ◽  
Author(s):  
V C Blok ◽  
G P Slater ◽  
E M Giblin
Keyword(s):  
Solvent Extraction ◽  
Methylene Chloride ◽  
Extraction Methods ◽  
Liquid Extraction ◽  
Standard Mixture ◽  
Liquid Liquid Extraction ◽  
Trace Organics ◽  
Tenax Gc

Several commercially available adsorbents were compared with solvent extraction methods for their utility in recovering trace organics from water. The adsorbents examined included Amberlite XAD-2, XAD-4 and XAD-8, Ambersorb XE340 and XE348 and Tenax-GC. All were found to produce high artifact levels, even after extensive clean-up, making them unsuitable for the analysis of trace organics in water. Quantitatively, Likens-Nickerson or continuous liquid-liquid extraction with méthylene chloride gave better recoveries than the adsorbents. Qualitatively, extractive methods were preferred as they yielded much lower levels of impurities than the adsorbents. These methods of recovering trace organics were evaluated using a standard mixture of compounds added to the water at a level of 55 µg/l. Likens-Nickerson extraction gave comparable recoveries of this mixture at 55 µg/l and 11 µg/l.

scholarly journals Tantalum and Niobium Selective Extraction by Alkyl-Acetophenone

Metals ◽  
2018 ◽  
Vol 8 (9) ◽  
pp. 654 ◽  
Author(s):  
Moussa Toure ◽  
Guilhem Arrachart ◽  
Jean Duhamet ◽  
Stephane Pellet-Rostaing
Keyword(s):  
Extraction Efficiency ◽  
Methyl Isobutyl Ketone ◽  
Selective Extraction ◽  
Extraction Process ◽  
Liquid Extraction ◽  
Methyl Isobutyl ◽  
Isobutyl Ketone ◽  
Waste Solution ◽  
Liquid Liquid Extraction ◽  
D Values

A study has been carried out on Ta and Nb recovery by a liquid-liquid extraction process using 4-methylacetophenone (4-MAcPh) as the organic phase. The 4-MAcPh was compared to methyl isobutyl ketone (MIBK) with respect to extraction efficiencies (D values) at different concentrations of H2SO4 in the aqueous phase. The results showed a similar extraction of Nb for both solvents. However, for Ta, extraction efficiency is increased by a factor of 1.3 for 4-MAcPh. In addition, the MIBK solubilized completely after 6 mol∙L−1 of H2SO4 against only a loss of 0.14–4% for 4-MAcPh between 6 and 9 mol∙L−1 of H2SO4. The potential of 4-MAcPh has also been studied to selectively recover Ta from a model capacitor waste solution. The results showed a selectivity for Ta in the presence of impurities such as Ag, Fe, Ni and Mn. The 4-MAcPh also presents the advantage of having physicochemical properties adapted to its use in liquid-liquid extraction technologies such as mixer-settlers.

scholarly journals Removal of lindane from wastewater using liquid-liquid extraction process

2013 ◽  
Vol 15 (3) ◽  
pp. 81-84 ◽  
Author(s):  
Indrasing D. Patil ◽  
Yogita S. Patil ◽  
Bhausaheb L. Pangarkar
Keyword(s):  
Distribution Coefficient ◽  
Extraction Process ◽  
Liquid Extraction ◽  
Ternary Mixtures ◽  
Triangular Diagram ◽  
Pesticide Pollution ◽  
Water Solvent ◽  
Liquid Liquid Extraction ◽  
Equilibrium Data ◽  
The Right

Abstract Pesticide pollution is a serious problem being faced. Harmful levels of pesticides are found in the water which is used for daily purposes. In the event of such a scenario, this paper presents a working solution for bringing down the Pesticide levels in the water to safe levels by using the method of liquid-liquid extraction. The experimental liquid-liquid equilibrium data on pesticide-water-solvent ternary mixtures at a temperature of 288.15 K are presented here. The pesticide used here is a chlorinated hydrocarbon called lindane found in the water (underground, land), beverages and foods. The solvents used are Petro-ether-Chloroform (1:1), Ethylene di chloride and n-hexane. The equilibrium generation diagram, triangular diagram, tie lines and bimodal curves as well as the distribution coefficient have been determined and reported. The petro-ether-chloroform was found to be the right solvent for the separation of lindane from wastewater because of high selectivity (25.36) and distribution coefficient (4). The extraction process is simulated into ‘C’ language

scholarly journals Solvent Extraction And Spectrophotomteric Determination Of Cu(Ii) With Dicyclohexyl - 18- Crown-6

2013 ◽  
Vol 10 (3) ◽  
pp. 997-1004
Author(s):  
Baghdad Science Journal
Keyword(s):  
Aqueous Solution ◽  
Solvent Extraction ◽  
Correlation Coefficient ◽  
Extraction Efficiency ◽  
Molar Absorptivity ◽  
Liquid Extraction ◽  
Liquid Liquid Extraction ◽  
Coloured Complex

Liquid-Liquid Extraction of Cu(II) ion in aqueous solution by dicyclohexyl-18-crown-6 as extractant in dichloroethane was studied .The extraction efficiency was investigated by a spectrophometric method. The reagent form a coloured complex which has been a quantitatively extracted at pH 6.3. The method obeys Beer`s law over range from (2.5-22.5) ppm with the correlation coefficient of 0.9989. The molar absorptivity the stoichiometry of extracted complex is found to be 1:2. the proposed method is very sensitive and selective.

scholarly journals Liquid–liquid extraction of gallium(III) with n-octylaniline from succinate media

2005 ◽  
Vol 70 (6) ◽  
pp. 853-867 ◽  
Author(s):  
T.N. Shilmkar ◽  
S.S. Kolekar ◽  
M.A. Anuse
Keyword(s):  
Extraction Process ◽  
Liquid Extraction ◽  
Tolerance Limit ◽  
Variation Method ◽  
Hydrogen Ions ◽  
Binary Separation ◽  
Liquid Liquid Extraction ◽  
Masking Agents ◽  
Increasing Temperature ◽  
Extraction Equilibria

The distribution equilibrium of gallium(III) between n-octylaniline dissolved in toluene and acidic aqueous succinate media has been investigated as a function of the concentration of extractant in the organic phase and concentration of hydrogen ions and gallium( III) ions in the aqueous phase. The stoichiometry of the extracted species was determined on the basis of slope analysis.Gallium(III) is extracted by the anion exchange mechanism as [RNH3+Ga(succinate)2]org. The temperature dependence of the extraction equilibria was examined by the temperature variation method. The extraction process is favoured with increasing temperature. It was found that a large number of cations and anions have a high tolerance limit. The selectivity of the extraction is increased by the use of suitable masking agents. The method affords the binary separation of gallium(III) from associated elements and was further extended to the analysis of a synthetic mixture.

scholarly journals EXTRACTION OF COLORED SUBSTANCES FROM MATE (ILEX PARAGUARIENSIS)

1998 ◽  
Vol 6 (6) ◽  
pp. 45-51
Author(s):  
Vania Regina Gabbi Polli ◽  
Alnei Ramos Prochnow ◽  
Juliane Zimmernan Tamanini
Keyword(s):  
Organic Solvents ◽  
Diethyl Ether ◽  
Sodium Lauryl Sulfate ◽  
Extraction Process ◽  
Liquid Extraction ◽  
Ilex Paraguariensis ◽  
Lauryl Sulfate ◽  
Liquid Liquid Extraction

Liquid-liquid extraction of pigments present in mate (flex Paraguariensis) was studied using various organic solvents and different concentrations. The best results were obtained using diethyl ether and sodium lauryl sulfate. The effect of the addition of ethanol on the extraction process was also analyzed.

Polymers for electronics: a new process under development

OPE Journal ◽  
2021 ◽  
Vol 11 (37) ◽  
pp. 20-20
Keyword(s):  
Extraction Process ◽  
Liquid Extraction ◽  
Liquid Liquid Extraction ◽  
New Process

The experts at Seqens are working on the implementation of a continuous liquid-liquid extraction process. In OPE journal, the company provides an update on the development

Sign in / Sign up

Export Citation Format

Share Document