Doping and impurity-vacancy complex formation during vapour-phase epitaxy of gallium arsenide

1992 ◽  
Vol 123 (3-4) ◽  
pp. 529-536 ◽  
Author(s):  
I.A. Bobrovnikova ◽  
L.G. Lavrent'eva ◽  
M.P. Rusaikin ◽  
M.D. Vilisova
Keyword(s):  
Gallium Arsenide ◽  
Complex Formation ◽  
Vapour Phase ◽  
Vapour Phase Epitaxy ◽  
Vacancy Complex

scholarly journals Characterisation of III?V Multilayers Grown by Low-pressure Metal Organic Vapour-phase Epitaxy

1993 ◽  
Vol 46 (3) ◽  
pp. 435
Author(s):  
C Jagadish ◽  
A Clark ◽  
G Li ◽  
CA Larson ◽  
N Hauser ◽  
...  
Keyword(s):  
Gallium Arsenide ◽  
Growth Temperature ◽  
Deep Level ◽  
Growth Parameters ◽  
Low Pressure ◽  
Vapour Phase ◽  
Growth Conditions ◽  
Vapour Phase Epitaxy ◽  
Metal Organic ◽  
Organic Vapour

Undoped and doped layers of gallium arsenide and aluminium gallium arsenide have been grown on gallium arsenide by low-pressure metal organic vapour-phase epitaxy (MOVPE). Delta doping and growth on silicon substrates have also been attempted. Of particular interest in the present study has been the influence of growth parameters, such as growth temperature, group III mole fraction and dopant flow, on the electrical and physical properties of gallium arsenide layers. An increase in growth temperature leads to increased doping efficiency in the case of silicon, whereas the opposite is true in the case of zinc. Deep level transient spectroscopy (DTLS) studies on undoped GaAs layers showed two levels, the expected EL2 level and a carbon-related level. The determination of optimum growth conditions has allowed good quality GaAs and AlGaAs epitaxial layers to be produced for a range of applications.`

Characterization of GaAs/AlGaAs quantum wells and quantum wires by chemical lattice imaging

1994 ◽  
Vol 52 ◽  
pp. 736-737
Author(s):  
A. Carlsson ◽  
J.-O. Malm ◽  
A. Gustafsson
Keyword(s):  
Quantum Well ◽  
Quantum Wells ◽  
Quantum Wires ◽  
Vapour Phase ◽  
Quantitative Information ◽  
Lattice Imaging ◽  
Vapour Phase Epitaxy ◽  
Metalorganic Vapour Phase Epitaxy ◽  
High Resolution Images

In this study a quantum well/quantum wire (QW/QWR) structure grown on a grating of V-grooves has been characterized by a technique related to chemical lattice imaging. This technique makes it possible to extract quantitative information from high resolution images.The QW/QWR structure was grown on a GaAs substrate patterned with a grating of V-grooves. The growth rate was approximately three monolayers per second without growth interruption at the interfaces. On this substrate a barrier of nominally Al0.35 Ga0.65 As was deposited to a thickness of approximately 300 nm using metalorganic vapour phase epitaxy . On top of the Al0.35Ga0.65As barrier a 3.5 nm GaAs quantum well was deposited and to conclude the structure an additional approximate 300 nm Al0.35Ga0.65 As was deposited. The GaAs QW deposited in this manner turns out to be significantly thicker at the bottom of the grooves giving a QWR running along the grooves. During the growth of the barriers an approximately 30 nm wide Ga-rich region is formed at the bottom of the grooves giving a Ga-rich stripe extending from the bottom of each groove to the surface.

scholarly journals Role of dislocations in nitride laser diodes with different indium content

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Agata Bojarska-Cieślińska ◽  
Łucja Marona ◽  
Julita Smalc-Koziorowska ◽  
Szymon Grzanka ◽  
Jan Weyher ◽  
...  
Keyword(s):  
Quantum Wells ◽  
Defect Density ◽  
Laser Diodes ◽  
Diffusion Path ◽  
Vapour Phase ◽  
Indium Content ◽  
Nonradiative Recombination ◽  
Light Emitters ◽  
Vapour Phase Epitaxy

AbstractIn this work we investigate the role of threading dislocations in nitride light emitters with different indium composition. We compare the properties of laser diodes grown on the low defect density GaN substrate with their counterparts grown on sapphire substrate in the same epitaxial process. All structures were produced by metalorganic vapour phase epitaxy and emit light in the range 383–477 nm. We observe that intensity of electroluminescence is strong in the whole spectral region for devices grown on GaN, but decreases rapidly for the devices on sapphire and emitting at wavelength shorter than 420 nm. We interpret this behaviour in terms of increasing importance of dislocation related nonradiative recombination for low indium content structures. Our studies show that edge dislocations are the main source of nonradiative recombination. We observe that long wavelength emitting structures are characterized by higher average light intensity in cathodoluminescence and better thermal stability. These findings indicate that diffusion path of carriers in these samples is shorter, limiting the amount of carriers reaching nonradiative recombination centers. According to TEM images only mixed dislocations open into the V-pits, usually above the multi quantum wells thus not influencing directly the emission.

scholarly journals Towards practical applications of quantum emitters in boron nitride

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
M. Koperski ◽  
K. Pakuła ◽  
K. Nogajewski ◽  
A. K. Dąbrowska ◽  
M. Tokarczyk ◽  
...  
Keyword(s):  
Optical Properties ◽  
Boron Nitride ◽  
Vapour Phase ◽  
Emission Characteristics ◽  
Vapour Phase Epitaxy ◽  
Practical Applications ◽  
Metalorganic Vapour Phase Epitaxy ◽  
Polydimethylsiloxane Films ◽  
Background Luminescence ◽  
Quantum Emitters

AbstractWe demonstrate quantum emission capabilities from boron nitride structures which are relevant for practical applications and can be seamlessly integrated into a variety of heterostructures and devices. First, the optical properties of polycrystalline BN films grown by metalorganic vapour-phase epitaxy are inspected. We observe that these specimens display an antibunching in the second-order correlation functions, if the broadband background luminescence is properly controlled. Furthermore, the feasibility to use flexible and transparent substrates to support hBN crystals that host quantum emitters is explored. We characterise hBN powders deposited onto polydimethylsiloxane films, which display quantum emission characteristics in ambient environmental conditions.

ZnSe metal organic vapour-phase epitaxy on GaAs: substrate preparation as the limiting factor in ZnSe growth

1998 ◽  
Vol 184-185 ◽  
pp. 1338 ◽  
Author(s):  
D.N. Gnoth ◽  
T.L. Ng ◽  
I.B. Poole ◽  
D.A. Evans ◽  
N. Maung ◽  
...  
Keyword(s):  
Gaas Substrate ◽  
Vapour Phase ◽  
Limiting Factor ◽  
Substrate Preparation ◽  
Vapour Phase Epitaxy ◽  
Metal Organic ◽  
Organic Vapour

EXCITON AND BIEXCITON PHENOMENA IN ZINC SULPHIDE EPILAYERS

1996 ◽  
Vol 05 (04) ◽  
pp. 621-629 ◽  
Author(s):  
J. VALENTA ◽  
D. GUENNANI ◽  
A. MANAR ◽  
P. GILLIOT
Keyword(s):  
Optical Gain ◽  
Vapour Phase ◽  
Zinc Sulphide ◽  
Detailed Characterization ◽  
Vapour Phase Epitaxy ◽  
Nanosecond Lasers ◽  
Metal Organic ◽  
Organic Vapour ◽  
Linear Optical Properties

The detailed characterization of metal organic vapour phase epitaxy grown ZnS layers on GaAs is the first step towards the study of their different non-linear optical properties performed with nanosecond lasers. Biexciton phenomena (with a binding energy of about 10 meV) are observed in photoluminescence-excitation and optical-gain spectra.

Sign in / Sign up

Export Citation Format

Share Document