Self-preoccupation and general stress level as sensitizing factors in premenstrual and menstrual distress

1989 ◽  
Vol 33 (5) ◽  
pp. 571-577 ◽  
Author(s):  
Alfred B. Heilbrun ◽  
Michelle E. Frank
2021 ◽  
Vol 10 (10) ◽  
pp. 2148
Author(s):  
Sandra Jóźwik ◽  
Błażej Cieślik ◽  
Robert Gajda ◽  
Joanna Szczepańska-Gieracha

The aim of this study was to assess the efficacy of virtual reality (VR)-enhanced cardiac rehabilitation (CR) in reducing the intensity of depression and anxiety symptoms in patients undergoing phase II of CR in ambulatory conditions. One hundred participants (mean age 65.7 years) were divided randomly into two groups. Both groups took part in eight sessions of standard CR (three times per week). The experimental group was additionally supported by eight sessions of VR therapy using the VR TierOne device and the control group by eight sessions of Schultz Autogenic Training. The Hospital Anxiety and Depression Scale (HADS) was used as the primary outcome measure. The Perception of Stress Questionnaire was used as the secondary outcome measure. The data from 77 participants were subject to analysis. Post-intervention, in the experimental group, the overall HADS score was statistically significantly reduced by 13.5%, HADS-Depression by 20.8%, and the general stress level by 12.8% (p < 0.05). In the control group, the scores of the HADS, HADS-Anxiety and the general stress level were statistically significantly higher, by 4.8%, 6.5%, and 4.9%, respectively. VR-enhanced CR for individuals with cardiovascular disease reduced the level of anxiety and depression symptoms compared to standard CR.


1983 ◽  
Vol 105 (2) ◽  
pp. 179-184
Author(s):  
D. L. Marriott

The paper describes a technique for estimating creep deformation from the results of short-term proof tests. The method relies on the concept of a reference stress which is representative of the general stress level in the component. It is shown that the method provides an upper, and therefore safe, bound on creep deformation. Application to a complex piping component is used to illustrate the procedure and some of the practical problems of interpreting the experimental data. Finally, an attempt is made to relate the reference stress method to tentative design procedures in Code Case N.47 of the ASME III Code.


Pneumologie ◽  
2010 ◽  
Vol 64 (01) ◽  
Author(s):  
E Kaltenborn ◽  
L Fragnet ◽  
KK Konzelmann ◽  
N Weichert ◽  
M Griese ◽  
...  

Food Industry ◽  
2018 ◽  
Vol 3 (4) ◽  
Author(s):  
Ekaterina V. Pastushkova ◽  
Olga V. Chugunova ◽  
Leonid S. Volkanin

1981 ◽  
Vol 27 (97) ◽  
pp. 503-505 ◽  
Author(s):  
Ian J. Smalley

AbstractRecent investigations have shown that various factors may affect the shear strength of glacial till and that these factors may be involved in the drumlin-forming process. The presence of frozen till in the deforming zone, variation in pore-water pressure in the till, and the occurrence of random patches of dense stony-till texture have been considered. The occurrence of dense stony till may relate to the dilatancy hypothesis and can be considered a likely drumlin-forming factor within the region of critical stress levels. The up-glacier stress level now appears to be the more important, and to provide a sharper division between drumlin-forming and non-drumlin-forming conditions.


Sign in / Sign up

Export Citation Format

Share Document