Biomass fly ash and biomass bottom ash

Author(s):  
Francisco Agrela ◽  
Manuel Cabrera ◽  
María Martín Morales ◽  
Montserrat Zamorano ◽  
Mazen Alshaaer
Keyword(s):  
Fly Ash ◽  
Minerals ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 593
Author(s):  
Mehmet Emin Küçük ◽  
Teemu Kinnarinen ◽  
Juha Timonen ◽  
Olli Mulari ◽  
Antti Häkkinen

This study focuses on characterisation of side streams including biomass fly ash, biomass bottom ash, coal fly ash, green liquor dregs, limestone mine tailings, and electric arc furnace steel slag from different industrial locations in Finland. It was found that the fly ash samples contained the highest Al2O3 and SiO2 concentrations, a large number of spherical particles of small sizes and high specific surface areas. Fly ashes and steel slag were observed to contain higher amounts of amorphous phases compared to the other side streams. The high loss on ignition value of the coal fly ash and green liquor dregs was found to exceed the limitations for their application in geopolymer composites. Despite their relatively high concentrations in ashes and steel slag, the leaching tests have shown that no hazardous metal leached out from the streams. Finally, test specimens of geopolymer composites (GP2) were prepared by the application of biomass fly ash, bottom ash, and limestone mine tailings without any pre-treatment process, in addition to the ordinary Portland cement-(R) and metakaolin-based geopolymer composites (GP1). The measured compressive (14.1 MPa) and flexural strength (3.5 MPa) of GP2 suggest that it could be used in concrete kerbs and paving flags. The data has also shown that over 500% of the compressive strength was developed between 7 and 28 days in GP2, whereas in the case of reference concrete (R) and the metakaolin-based geopolymer composite (GP1) it was developed in the first 7 days.


Author(s):  
L. L. Sutter ◽  
G. R. Dewey ◽  
J. F. Sandell

Municipal waste combustion typically involves both energy recovery as well as volume reduction of municipal solid waste prior to landfilling. However, due to environmental concerns, municipal waste combustion (MWC) has not been a widely accepted practice. A primary concern is the leaching behavior of MWC ash when it is stored in a landfill. The ash consists of a finely divided fly ash fraction (10% by volume) and a coarser bottom ash (90% by volume). Typically, MWC fly ash fails tests used to evaluate leaching behavior due to high amounts of soluble lead and cadmium species. The focus of this study was to identify specific lead bearing phases in MWC fly ash. Detailed information regarding lead speciation is necessary to completely understand the leaching behavior of MWC ash.


2020 ◽  
Vol 104 (2) ◽  
pp. 803-815
Author(s):  
Lisandro Simão ◽  
Andreia De Rossi ◽  
Dachamir Hotza ◽  
Manuel J. Ribeiro ◽  
Rui M. Novais ◽  
...  

2020 ◽  
Vol 11 (1) ◽  
pp. 107
Author(s):  
B. Simões ◽  
P. R. da Silva ◽  
R. V. Silva ◽  
Y. Avila ◽  
J. A. Forero

This study aims to evaluate the potential of incorporating fly ash (FA) and municipal solid waste incinerator bottom ash (MIBA) as a partial substitute of cement in the production of self-compacting concrete mixes through an experimental campaign in which four replacement levels (i.e., 10% FA + 20% MIBA, 20% FA + 10% MIBA, 20% FA + 40% MIBA and 40% FA + 20% MIBA, apart from the reference concrete) were considered. Compressive and tensile strengths, Young’s modulus, ultra-sonic pulse velocity, shrinkage, water absorption by immersion, chloride diffusion coefficient and electrical resistivity were evaluated for all concrete mixes. The results showed a considerable decline in both mechanical and durability-related performances of self-compacting concrete with 60% of substitution by MIBA mainly due to the aluminium corrosion chemical reaction. However, workability properties were not significantly affected, exhibiting values similar to those of the control mix.


J ◽  
2021 ◽  
Vol 4 (3) ◽  
pp. 223-232
Author(s):  
Esperanza Menéndez ◽  
Cristina Argiz ◽  
Miguel Ángel Sanjuán

Ground coal bottom ash is considered a novel material when used in common cement production as a blended cement. This new application must be evaluated by means of the study of its pozzolanic properties. Coal bottom ash, in some countries, is being used as a replacement for natural sand, but in some others, it is disposed of in a landfill, leading thus to environmental problems. The pozzolanic properties of ground coal bottom ash and coal fly ash cements were investigated in order to assess their pozzolanic performance. Proportions of coal fly ash and ground coal bottom ash in the mixes were 100:0, 90:10, 80:20, 50:50, 0:100. Next, multicomponent cements were formulated using 10%, 25% or 35% of ashes. In general, the pozzolanic performance of the ground coal bottom ash is quite similar to that of the coal fly ash. As expected, the pozzolanic reaction of both of them proceeds slowly at early ages, but the reaction rate increases over time. Ground coal bottom ash is a promising novel material with pozzolanic properties which are comparable to that of coal fly ashes. Then, coal bottom ash subjected to an adequate mechanical grinding is suitable to be used to produce common coal-ash cements.


Materials ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 3079
Author(s):  
Beata Jaworska ◽  
Dominika Stańczak ◽  
Joanna Tarańska ◽  
Jerzy Jaworski

The generation of energy for the needs of the population is currently a problem. In consideration of that, the biomass combustion process has started to be implemented as a new source of energy. The dynamic increase in the use of biomass for energy generation also resulted in the formation of waste in the form of fly ash. This paper presents an efficient way to manage this troublesome material in the polymer–cement composites (PCC), which have investigated to a lesser extent. The research outlined in this article consists of the characterization of biomass fly ash (BFA) as well as PCC containing this waste. The characteristics of PCC with BFA after 3, 7, 14, and 28 days of curing were analyzed. Our main findings are that biomass fly ash is suitable as a mineral additive in polymer–cement composites. The most interesting result is that the addition of biomass fly ash did not affect the rheological properties of the polymer–cement mortars, but it especially influenced its compressive strength. Most importantly, our findings can help prevent this byproduct from being placed in landfills, prevent the mining of new raw materials, and promote the manufacture of durable building materials.


Fuel ◽  
2012 ◽  
Vol 98 ◽  
pp. 265-271 ◽  
Author(s):  
Rejini Rajamma ◽  
João A. Labrincha ◽  
Victor M. Ferreira

Sign in / Sign up

Export Citation Format

Share Document