Role of dissolved oxygen availability on lactobionic acid production from whey by Pseudomonas taetrolens

2012 ◽  
Vol 109 ◽  
pp. 140-147 ◽  
Author(s):  
Saúl Alonso ◽  
Manuel Rendueles ◽  
Mario Díaz
2021 ◽  
Author(s):  
Xinpeng Zhao ◽  
Zhimin Zhou ◽  
hu luo ◽  
Yanfei Zhang ◽  
Wang Liu ◽  
...  

Combined experiments and density functional theory (DFT) calculations provided insights into the role of the environment-friendly γ-valerolactone (GVL) as a solvent in the hydrothermal conversion of glucose into lactic acid...


Metabolites ◽  
2022 ◽  
Vol 12 (1) ◽  
pp. 45
Author(s):  
Qi Yang ◽  
Wenli Lin ◽  
Jiawei Xu ◽  
Nan Guo ◽  
Jiachen Zhao ◽  
...  

Bioreactor scale-up from the laboratory scale to the industrial scale has always been a pivotal step in bioprocess development. However, the transition of a bioeconomy from innovation to commercialization is often hampered by performance loss in titer, rate and yield. These are often ascribed to temporal variations of substrate and dissolved oxygen (for instance) in the environment, experienced by microorganisms at the industrial scale. Oscillations in dissolved oxygen (DO) concentration are not uncommon. Furthermore, these fluctuations can be exacerbated with poor mixing and mass transfer limitations, especially in fermentations with filamentous fungus as the microbial cell factory. In this work, the response of glucose-limited chemostat cultures of an industrial Penicillium chrysogenum strain to different dissolved oxygen levels was assessed under both DO shift-down (60% → 20%, 10% and 5%) and DO ramp-down (60% → 0% in 24 h) conditions. Collectively, the results revealed that the penicillin productivity decreased as the DO level dropped down below 20%, while the byproducts, e.g., 6-oxopiperidine-2-carboxylic acid (OPC) and 6-aminopenicillanic acid (6APA), accumulated. Following DO ramp-down, penicillin productivity under DO shift-up experiments returned to its maximum value in 60 h when the DO was reset to 60%. The result showed that a higher cytosolic redox status, indicated by NADH/NAD+, was observed in the presence of insufficient oxygen supply. Consistent with this, flux balance analysis indicated that the flux through the glyoxylate shunt was increased by a factor of 50 at a DO value of 5% compared to the reference control, favoring the maintenance of redox status. Interestingly, it was observed that, in comparison with the reference control, the penicillin productivity was reduced by 25% at a DO value of 5% under steady state conditions. Only a 14% reduction in penicillin productivity was observed as the DO level was ramped down to 0. Furthermore, intracellular levels of amino acids were less sensitive to DO levels at DO shift-down relative to DO ramp-down conditions; this difference could be caused by different timescales between turnover rates of amino acid pools (tens of seconds to minutes) and DO switches (hours to days at steady state and minutes to hours at ramp-down). In summary, this study showed that changes in oxygen availability can lead to rapid metabolite, flux and productivity responses, and dynamic DO perturbations could provide insight into understanding of metabolic responses in large-scale bioreactors.


Author(s):  
Yingming Guo ◽  
Ben Ma ◽  
Jianxiong Huang ◽  
Jing Yang ◽  
Ruifeng Zhang

Abstract The iron and manganese oxide filter film (MeOx) were used to research the simultaneous removal of bisphenol A (BPA), manganese (Mn2+) and ammonium (NH4+) in a pilot-scale filter system. We found that 0.52 mg/L of BPA could be removed while consuming 5.44 mg/L of dissolved oxygen (DO). Since the oxidation process of NH4+ and BPA both consume the DO in water, the presence of NH4+ can hinder the removal of BPA. The presence of Mn2+ in water had a synergy effect on the BPA removal. The filter film was characterized by SEM, XRD and XPS. Some substances were generated to block the pores of the oxide film, and a small amount of film was found to crack and fall off. The elemental composition of C and O were both increased by about 9%, the composition of Mn was decreased from 63.48% to 44.55%, and the reduced manganese substance might affect the activity of the oxide film. The main chemical forms of MeOx are Mn6O12·3H2O, MnFe2O4 or Mn3O4. The decrease in the removal efficiency of BPA was mainly due to the C-containing intermediate [−CH2C − H(OH)]n covering the surface of the oxide film and blocking the pore size of the film.


2019 ◽  
Vol 161 ◽  
pp. 79-88 ◽  
Author(s):  
Huanyu Lei ◽  
Jiaming Lu ◽  
Guoqing Dong ◽  
Guofeng Tian ◽  
Shengli Qi ◽  
...  

2020 ◽  
Vol 139 (4) ◽  
Author(s):  
Florencia A. Rodriguez ◽  
Paola B. Reyna ◽  
Tamara Maggioni ◽  
Diego R. Giménez ◽  
Luciana Torre
Keyword(s):  

1983 ◽  
Vol 23 ◽  
Author(s):  
John C. C. Fan ◽  
B-Y. Tsaur ◽  
C. K. Chen ◽  
J. R. Dick ◽  
L. L. Kazmerski

ABSTRACTUsing secondary-ion mass spectroscopy, we have found that oxygen is strongly concentrated at the sub-boundaries in zone-melting-recrystallized silicon-on-insulator films prepared by the graphite-strip-heater technique. This observation suggests that the formation of sub-boundaries during recrystallization may be caused by constitutional supercooling resulting from the presence of oxygen that is dissolved into the molten Si zone from the adjacent SiO2 layers. Since all zone-melting-recrystallized films to date have been bordered by SiO2 layers, regardless of the heating techniques employed, the sub-boundaries almost always present in these films may well have dissolved oxygen as their common origin.


Sign in / Sign up

Export Citation Format

Share Document