Enhancing solar disinfection of water in PET bottles by optimized in-situ formation of iron oxide films. From heterogeneous to homogeneous action modes with H2O2 vs. O2 – Part 2: Direct use of (natural) iron oxides

2019 ◽  
Vol 360 ◽  
pp. 1051-1062 ◽  
Author(s):  
Sakine Shekoohiyan ◽  
Sami Rtimi ◽  
Gholamreza Moussavi ◽  
Stefanos Giannakis ◽  
Cesar Pulgarin
2017 ◽  
Vol 71 ◽  
pp. 29-32 ◽  
Author(s):  
Jinsu Choi ◽  
Hojae Lee ◽  
Insung S. Choi ◽  
Sung Ho Yang

2021 ◽  
Author(s):  
Sujung Go ◽  
Alexei Lyapustin ◽  
Gregory L. Schuster ◽  
Myungje Choi ◽  
Paul Ginoux ◽  
...  

Abstract. The iron-oxide content of dust in the atmosphere and most notably its apportionment between hematite (α-Fe2O3) and goethite (α-FeOOH) are key determinants in quantifying dust's light absorption, its top of atmosphere UV radiances used for dust monitoring, and ultimately shortwave dust direct radiative effects (DRE). Hematite and goethite column mass concentrations and iron-oxide mass fractions of total dust mass concentration were retrieved from the Deep Space Climate Observatory (DSCOVR) Earth Polychromatic Imaging Camera (EPIC) measurements in the ultraviolet–visible (UV–Vis) channels. The retrievals were performed for dust-identified aerosol plumes using aerosol optical depth (AOD) and spectral imaginary refractive index provided by the Multi-Angle Implementation of Atmospheric Correction (MAIAC) algorithm over six continental regions (North America, North Africa, West Asia, Central Asia, East Asia, and Australia). The dust particles are represented as an internal mixture of non-absorbing host and absorbing hematite and goethite. We use the Maxwell–Garnett effective medium approximation with carefully selected complex refractive indices of hematite and goethite that produce mass fractions of iron oxides species consistent with in situ values found in the literature to derive the hematite and goethite volumetric/mass concentrations from MAIAC EPIC products. We compared the retrieved hematite and goethite concentrations with in situ dust aerosol mineralogical content measurements, as well as with published data. Our data display variations within the published range of hematite, goethite, and iron-oxide mass fractions for pure mineral dust cases. A specific analysis is presented for 15 sites over the main dust source regions. Sites in the central Sahara, Sahel, and Middle East exhibit a greater temporal variability of iron oxides relative to other sites. Niger site (13.52° N, 2.63° E) is dominated by goethite over Harmattan season with median of ~2 weight percentage (wt.%) of iron-oxide. Saudi Arabia site (27.49° N, 41.98° E) over Middle East also exhibited surge of goethite content with the beginning of Shamal season. The Sahel dust is richer in iron-oxide than Saharan and northern China dust except in Summer. The Bodélé Depression area shows a distinctively lower iron-oxide concentration (~1 wt. %) throughout the year. Finally, we show that EPIC data allow to constrain the hematite refractive index. Specifically, we select 5 out of 13 different number of hematite refractive indices widely variable in published laboratory studies by constraining the iron-oxide mass ratio to the known measured values. Provided climatology of hematite and goethite mass fractions across main dust regions of the Earth will be useful for dust shortwave DRE studies and climate modeling. 


2001 ◽  
Vol 16 (2) ◽  
pp. 564-569 ◽  
Author(s):  
Hyunjung Shin ◽  
Jong Up Jeon ◽  
Y. Eugene Pak ◽  
Hyejin Im ◽  
Eung Soo Kim

Crystalline and pore-free films of α–Fe2O3 were prepared on hydrophilic self-assembled organic monolayers (DTT-SAMs) at 80 °C. Subsequently, Fe3O4 and γ–Fe2O3 films were synthesized via post annealing of as-deposited α–Fe2O3. In situ patterning of crystalline iron oxide thin layers was achieved via microcontact printing (μCP) and selective deposition. μCP was used to pattern two different surface moieties of self-assembled organic monolayers (SAMs) on Au–Cr–Si substrates. An elastomeric stamp was used to transfer either hexadecanethiol (HDT) SAMs, which are to sustain deposition of iron oxide precipitates, or hydrophilic SAMs [e.g., dithiothreitol (DTT)]. Selective deposition was realized through precipitation of iron oxide phases. Iron oxide films were deposited onto hydrophilic SAMs, but not onto HDT surfaces. Line (width of <1 μm) patterns in crystalline α–Fe2O3 thin films were obtained.


Author(s):  
Hyunjung Shin ◽  
Kyongmi Lee ◽  
Geunbae Lim ◽  
Jong Up Jeon ◽  
Y.E. Pak

1998 ◽  
Vol 524 ◽  
Author(s):  
E. Guiot ◽  
S. Gota ◽  
M. Henriot ◽  
M. Gautier-Soyer ◽  
S. Lefebvre

ABSTRACTNanometric films of iron oxides (Fe3O4, α and γ Fe2O3) of high crystalline order and purity are epitaxially grown on α-A12O3(0001) by atomic oxygen assisted MBE. A complete characterization of the films structure has been performed by in situ LEED and RHEED, and ex situ GIXRD using synchrotron radiation. The films grown at room temperature and post annealed at 400°C and 700°C (po2=10−6 Torr) are respectively metastable γ-Fe2O3 (111) and α-Fe2O3 (0001). For a substrate temperature of 450°C during growth, Fe3O4 (111) is directly obtained. GIXRD shows an in-plane expansion of the films, which decreases with thickness (0.8 and 0.2% for film thickness of 20 and 80 Å, respectively).


2020 ◽  
Vol 8 (4) ◽  
pp. 1335-1343 ◽  
Author(s):  
Mai Hussein Hamed ◽  
David N. Mueller ◽  
Martina Müller

Thermodynamically “active” oxide interfaces alter the standard iron oxide phase diagram of complex heterostructures. By controlling the effective oxygen pressure, selected iron oxides phases can be designed through a thermal phase design.


2011 ◽  
Vol 110 (10) ◽  
pp. 102208 ◽  
Author(s):  
F. Bertram ◽  
C. Deiter ◽  
K. Pflaum ◽  
M. Suendorf ◽  
C. Otte ◽  
...  

CrystEngComm ◽  
2018 ◽  
Vol 20 (44) ◽  
pp. 7206-7220 ◽  
Author(s):  
Walid Baaziz ◽  
Benoit P. Pichon ◽  
Jean-Marc Grenèche ◽  
Sylvie Begin-Colin

In this work, we investigate the effect of the reaction environment and the in situ formation of an iron precursor on the synthesis of iron oxide nanoparticles (IONPs) through thermal decomposition.


Sign in / Sign up

Export Citation Format

Share Document