EXAFS Investigation of Ni(Ⅱ) Sorption at the Palygorskite-Solution Interface: New Insights into Surface-induced Precipitation Phenomena

2021 ◽  
Author(s):  
Xinxin Mo ◽  
Matthew G. Siebecker ◽  
Wenxian Gou ◽  
Wei Li
Keyword(s):  
Solution Interface ◽  
Precipitation Phenomena

Heterogeneous Precipitation at Dislocations

1969 ◽  
Vol 27 ◽  
pp. 70-71
Author(s):  
A. K. Eikum
Keyword(s):  
Electron Microscopy ◽  
Room Temperature ◽  
Dislocation Loops ◽  
Silver Alloys ◽  
Heterogeneous Precipitation ◽  
Precipitation Phenomena ◽  
Aluminum Base ◽  
Silver Atoms

Precipitation phenomena in concentrated aluminum-base silver alloys have been studied with a variety of techniques including electron microscopy. The purpose of the present work was to investigate the dislocation reactions that occur as silver atoms precipitate (or segregate) under a relatively low supersaturation. Specimens (0.1 mm thick) of Al-1 at. % Ag were quenched from ~500°C into an oil bath at room temperature and aged 30 min. at 265°C. The initial configurations available as sites for heterogeneous precipitation will therefore include perfect prismatic dislocation loops, Frank sessile loops and random segments of grown-in dislocations.

Growth kinetics of Al2Cu in an Al-1.5Cu thin film by in Situ TEM

1993 ◽  
Vol 51 ◽  
pp. 1172-1173
Author(s):  
M. Park ◽  
S.J. Krause ◽  
S.R. Wilson
Keyword(s):  
Thin Film ◽  
In Situ Tem ◽  
Collector Plate ◽  
Transmission Electron ◽  
Device Processing ◽  
Corrosion Susceptibility ◽  
Precipitation Phenomena ◽  
Semiconductor Chips ◽  
Kinetics Of

Cu alloying in Al interconnection lines on semiconductor chips improves their resistance to electromigration and hillock growth. Excess Cu in Al can result in the formation of Cu-rich Al2Cu (θ) precipitates. These precipitates can significantly increase corrosion susceptibility due to the galvanic action between the θ-phase and the adjacent Cu-depleted matrix. The size and distribution of the θ-phase are also closely related to the film susceptibility to electromigration voiding. Thus, an important issue is the precipitation phenomena which occur during thermal device processing steps. In bulk alloys, it was found that the θ precipitates can grow via the grain boundary “collector plate mechanism” at rates far greater than allowed by volume diffusion. In a thin film, however, one might expect that the growth rate of a θ precipitate might be altered by interfacial diffusion. In this work, we report on the growth (lengthening) kinetics of the θ-phase in Al-Cu thin films as examined by in-situ isothermal aging in transmission electron microscopy (TEM).

Template mediated crystal engineering

1994 ◽  
Vol 52 ◽  
pp. 480-481
Author(s):  
Brigid R. Heywood ◽  
S. Champ
Keyword(s):  
Crystal Engineering ◽  
Electrostatic Interactions ◽  
Alkyl Chain ◽  
Crystallographic Axis ◽  
Two Dimensional ◽  
Engineering Process ◽  
Solution Interface ◽  
Extensive Program ◽  
Geometric Homology ◽  
Long Alkyl Chain

Recent work on the crystallisation of inorganic crystals under compressed monomolecular surfactant films has shown that two dimensional templates can be used to promote the oriented nucleation of solids. When a suitable long alkyl chain surfactant is cast on the crystallisation media a monodispersied population of crystals forms exclusively at the monolayer/solution interface. Each crystal is aligned with a specific crystallographic axis perpendicular to the plane of the monolayer suggesting that nucleation is facilitated by recognition events between the nascent inorganic solid and the organic template.For example, monolayers of the long alkyl chain surfactant, stearic acid will promote the oriented nucleation of the calcium carbonate polymorph, calcite, on the (100) face, whereas compressed monolayers of n-eicosyl sulphate will induce calcite nucleation on the (001) face, (Figure 1 & 2). An extensive program of research has confirmed the general principle that molecular recognition events at the interface (including electrostatic interactions, geometric homology, stereochemical complementarity) can be used to promote the crystal engineering process.

Enterovirus Concentration Using Automated Hollow Fiber Ultrafiltration

1982 ◽  
Vol 14 (4-5) ◽  
pp. 257-272 ◽  
Author(s):  
G Belfort ◽  
A Paluszek ◽  
L S Sturman
Keyword(s):  
Drinking Water ◽  
Hollow Fiber ◽  
Enhanced Recovery ◽  
Tap Water ◽  
Membrane Surface ◽  
Creeping Flow ◽  
Hollow Fibers ◽  
Virus Concentration ◽  
Concentration Technique ◽  
Solution Interface

The Automated Hollow Fiber Ultrafiltration (AHFU) method is proposed here as a simple, efficient and rapid virus concentration technique from tap and drinking water sources. The results reported here extend the testing of the AHFU method to include two Picornaviruses [Poliovirus 2 (vaccine) and Echovirus 1] and Reovirus 3. Their respective mean virus recoveries from between 3 and 100 l of tap water is 88 ± 26, 79 ± 60, and 104 ± 48%. Various approaches including membrane surface modification, changes in backwash hydrodynamics, modification of the feed and backwash composition, and the use of S35-methionine labelled Poliovirus 2, are used to study the recovery of sorbed Poliovirus 2 from the hollow fiber/solution interface. An increase in the backwash pH to between 9.5 and 10.5 significantly improved Poliovirus 2 recovery. This, together with the labelled experiments, indicates that the virus-membrane interactions are probably electrostatic in nature. Convective polarization during filtration probably brings the virus close enough to the surface for these interactions to occur since virus losses were not detected for a non-permeation recycle experiment. Because very low Reynold's numbers are used, the flow is in the creeping-flow-regime for both filtration and backwashing (axial and radial). Unless significantly higher Reynolds could be used, enhanced recovery due to purely hydrodynamic forces is unlikely. High Reynold's numbers, of course, are limited by the pressure constraints of the hollow fibers.

Temperature Effect on the Two-Dimensional Phase Transition Kinetics of Adenine Adsorbed at the Hg Electrode/Aqueous Solution Interface

2003 ◽  
Vol 68 (8) ◽  
pp. 1407-1419 ◽  
Author(s):  
Claudio Fontanesi ◽  
Roberto Andreoli ◽  
Luca Benedetti ◽  
Roberto Giovanardi ◽  
Paolo Ferrarini
Keyword(s):  
Phase Transition ◽  
Aqueous Solution ◽  
Phase Change ◽  
Temperature Effect ◽  
Transition Rate ◽  
Effect Of Temperature ◽  
Two Dimensional ◽  
Solution Interface ◽  
Phase Transition Kinetics ◽  
Kinetics Of

The kinetics of the liquid-like → solid-like 2D phase transition of adenine adsorbed at the Hg/aqueous solution interface is studied. Attention is focused on the effect of temperature on the rate of phase change; an increase in temperature is found to cause a decrease of transition rate.

Electrochemistry at anthracene crystal/aqueous nitrite, nitrate solution interface

1988 ◽  
Vol 92 (9) ◽  
pp. 2506-2511
Author(s):  
Baldwin Leong ◽  
Martin Pope ◽  
Joseph Steigman
Keyword(s):  
Nitrate Solution ◽  
Solution Interface ◽  
Anthracene Crystal ◽  
Nitrite Nitrate

Coating ligands mediated dynamic formation of natural organic matter (NOM) corona on engineered nanoparticles in environments

2021 ◽  
Author(s):  
Chuan-Wang Yang ◽  
Li Yuan ◽  
Hong-Zhi Zhou ◽  
Xin Zhang ◽  
Guo-Ping Sheng
Keyword(s):  
Organic Matter ◽  
Natural Organic Matter ◽  
Engineered Nanoparticles ◽  
Aquatic Systems ◽  
Solution Interface ◽  
Dynamic Formation

Natural organic matter (NOM) can adsorb onto engineered nanoparticles (ENPs) and form NOM-corona on ENPs-solution interface, thus affecting the performance and ecotoxicity of ENPs in aquatic systems. Nevertheless, the formation...

Sign in / Sign up

Export Citation Format

Share Document