Atomic simulation of the effect of orientation on tensile/compressive properties in nickel-based single crystal superalloys

2021 ◽  
pp. 162210
Author(s):  
Qian Yin ◽  
Yeda Lian ◽  
Zhixun Wen ◽  
Haiqing Pei ◽  
Jundong Wang ◽  
...  
Keyword(s):  
Single Crystal ◽  
Compressive Properties ◽  
Atomic Simulation

scholarly journals Atomic Simulation on Deformation and Fracture of Nano-Single Crystal of Nickel in Tension.

1997 ◽  
Vol 40 (4) ◽  
pp. 430-435 ◽  
Author(s):  
Takayuki KITAMURA ◽  
Kisaragi YASHIRO ◽  
Ryuichi OHTANI
Keyword(s):  
Single Crystal ◽  
Atomic Simulation ◽  
Deformation And Fracture

Atomic simulation of void location effect on the void growth in nickel-based single crystal

2019 ◽  
Vol 160 ◽  
pp. 245-255 ◽  
Author(s):  
J.P. Wang ◽  
J.W. Liang ◽  
Z.X. Wen ◽  
Z.F. Yue
Keyword(s):  
Single Crystal ◽  
Void Growth ◽  
Atomic Simulation

Atomic Simulation of the Bending Deformation of a Single-Crystal Simply Supported Nano-Beam

2009 ◽  
Vol 79-82 ◽  
pp. 1185-1188 ◽  
Author(s):  
Wen Bin Ni ◽  
Jian Wei Zhao ◽  
Yun Hong Liu ◽  
Feng Ying Wang ◽  
Xing Yin
Keyword(s):  
Mechanical Properties ◽  
Single Crystal ◽  
Deformation Behavior ◽  
Surface Effect ◽  
Dynamics Simulation ◽  
Nanoelectromechanical Systems ◽  
Atomic Simulation ◽  
Simply Supported ◽  
Distributed Load ◽  
Uniformly Distributed Load

Advanced fabrication techniques to miniaturize electromechanical systems have brought us into the regime of nanoelectromechanical systems (NEMS). Understanding the mechanical properties of NEMS components is of fundamental importance in the operation of these devices. In this paper, we have reported the deformation behavior of a single-crystal simply supported nano-beam under the uniformly distributed load. By using the molecular dynamics simulation, we have investigated the influence of span the nano-beam on the bending characters. Due to surface effect, the nano-beam shows a different behavior under the uniformly distributed load.

A Preparation of High Resolution Standards for Electron Microscopy. Part II

1971 ◽  
Vol 29 ◽  
pp. 160-161
Author(s):  
Akira Tanaka ◽  
David F. Harling
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
Carbon Black ◽  
Single Crystal ◽  
Dark Field ◽  
Graphitized Carbon Black ◽  
Graphitized Carbon ◽  
Dark Field Imaging ◽  
Crystal Films ◽  
Micro Holes

In the previous paper, the author reported on a technique for preparing vapor-deposited single crystal films as high resolution standards for electron microscopy. The present paper is intended to describe the preparation of several high resolution standards for dark field microscopy and also to mention some results obtained from these studies. Three preparations were used initially: 1.) Graphitized carbon black, 2.) Epitaxially grown particles of different metals prepared by vapor deposition, and 3.) Particles grown epitaxially on the edge of micro-holes formed in a gold single crystal film.The authors successfully obtained dark field micrographs demonstrating the 3.4Å lattice spacing of graphitized carbon black and the Au single crystal (111) lattice of 2.35Å. The latter spacing is especially suitable for dark field imaging because of its preparation, as in 3.), above. After the deposited film of Au (001) orientation is prepared at 400°C the substrate temperature is raised, resulting in the formation of many square micro-holes caused by partial evaporation of the Au film.

Structure of Palladium Single-Crystal Films Prepared by Flash Evaporation onto (001) NaCl Substrates

1970 ◽  
Vol 28 ◽  
pp. 456-457
Author(s):  
L. E. Murr ◽  
G. Wong
Keyword(s):  
Single Crystal ◽  
High Vacuum ◽  
Ultra High Vacuum ◽  
High Rate ◽  
Flash Evaporation ◽  
Optimum Load ◽  
Single Crystal Films ◽  
Crystal Films ◽  
A Current

Palladium single-crystal films have been prepared by Matthews in ultra-high vacuum by evaporation onto (001) NaCl substrates cleaved in-situ, and maintained at ∼ 350° C. Murr has also produced large-grained and single-crystal Pd films by high-rate evaporation onto (001) NaCl air-cleaved substrates at 350°C. In the present work, very large (∼ 3cm2), continuous single-crystal films of Pd have been prepared by flash evaporation onto air-cleaved (001) NaCl substrates at temperatures at or below 250°C. Evaporation rates estimated to be ≧ 2000 Å/sec, were obtained by effectively short-circuiting 1 mil tungsten evaporation boats in a self-regulating system which maintained an optimum load current of approximately 90 amperes; corresponding to a current density through the boat of ∼ 4 × 104 amperes/cm2.

Dislocations, Ordering and Antiferromagnetic Domains in MnO

1970 ◽  
Vol 28 ◽  
pp. 522-523
Author(s):  
D. J. Barber ◽  
R. G. Evans
Keyword(s):  
Electron Diffraction ◽  
Single Crystal ◽  
Optical Microscopy ◽  
Defect Chemistry ◽  
Magnetic Structures ◽  
Optically Transparent ◽  
Magnetic Features ◽  
Antiferromagnetic Domains

Manganese (II) oxide, MnO, in common with CoO, NiO and FeO, possesses the NaCl structure and shows antiferromagnetism below its Neel point, Tn∼ 122 K. However, the defect chemistry of the four oxides is different and the magnetic structures are not identical. The non-stoichiometry in MnO2 small (∼2%) and below the Tn the spins lie in (111) planes. Previous work reported observations of magnetic features in CoO and NiO. The aim of our work was to find explanations for certain resonance results on antiferromagnetic MnO.Foils of single crystal MnO were prepared from shaped discs by dissolution in a mixture of HCl and HNO3. Optical microscopy revealed that the etch-pitted foils contained cruciform-shaped precipitates, often thick and proud of the surface but red-colored when optically transparent (MnO is green). Electron diffraction and probe microanalysis indicated that the precipitates were Mn2O3, in contrast with recent findings of Co3O4 in CoO.

Electron Microscopy of Shock Loaded Polycrystalline Beryllium

1974 ◽  
Vol 32 ◽  
pp. 506-507 ◽  
Author(s):  
J. M. Galbraith ◽  
L. E. Murr ◽  
A. L. Stevens
Keyword(s):  
Electron Microscopy ◽  
Wave Propagation ◽  
Structural Change ◽  
Single Crystal ◽  
Diffraction Pattern ◽  
Shock Loading ◽  
Slip Systems ◽  
Compression Tests ◽  
X Ray Diffraction ◽  
X Ray

Uniaxial compression tests and hydrostatic tests at pressures up to 27 kbars have been performed to determine operating slip systems in single crystal and polycrystal1ine beryllium. A recent study has been made of wave propagation in single crystal beryllium by shock loading to selectively activate various slip systems, and this has been followed by a study of wave propagation and spallation in textured, polycrystal1ine beryllium. An alteration in the X-ray diffraction pattern has been noted after shock loading, but this alteration has not yet been correlated with any structural change occurring during shock loading of polycrystal1ine beryllium.This study is being conducted in an effort to characterize the effects of shock loading on textured, polycrystal1ine beryllium. Samples were fabricated from a billet of Kawecki-Berylco hot pressed HP-10 beryllium.

Sign in / Sign up

Export Citation Format

Share Document