Key role of processing to avoid low temperature ageing in alumina zirconia composites for orthopaedic application

2007 ◽  
Vol 27 (2-3) ◽  
pp. 1547-1552 ◽  
Author(s):  
Dan Gutknecht ◽  
Jérôme Chevalier ◽  
Vincent Garnier ◽  
Gilbert Fantozzi
2021 ◽  
Vol 22 (4) ◽  
pp. 1554
Author(s):  
Tawhidur Rahman ◽  
Mingxuan Shao ◽  
Shankar Pahari ◽  
Prakash Venglat ◽  
Raju Soolanayakanahally ◽  
...  

Cuticular waxes are a mixture of hydrophobic very-long-chain fatty acids and their derivatives accumulated in the plant cuticle. Most studies define the role of cuticular wax largely based on reducing nonstomatal water loss. The present study investigated the role of cuticular wax in reducing both low-temperature and dehydration stress in plants using Arabidopsis thaliana mutants and transgenic genotypes altered in the formation of cuticular wax. cer3-6, a known Arabidopsis wax-deficient mutant (with distinct reduction in aldehydes, n-alkanes, secondary n-alcohols, and ketones compared to wild type (WT)), was most sensitive to water loss, while dewax, a known wax overproducer (greater alkanes and ketones compared to WT), was more resistant to dehydration compared to WT. Furthermore, cold-acclimated cer3-6 froze at warmer temperatures, while cold-acclimated dewax displayed freezing exotherms at colder temperatures compared to WT. Gas Chromatography-Mass Spectroscopy (GC-MS) analysis identified a characteristic decrease in the accumulation of certain waxes (e.g., alkanes, alcohols) in Arabidopsis cuticles under cold acclimation, which was additionally reduced in cer3-6. Conversely, the dewax mutant showed a greater ability to accumulate waxes under cold acclimation. Fourier Transform Infrared Spectroscopy (FTIR) also supported observations in cuticular wax deposition under cold acclimation. Our data indicate cuticular alkane waxes along with alcohols and fatty acids can facilitate avoidance of both ice formation and leaf water loss under dehydration stress and are promising genetic targets of interest.


2009 ◽  
Vol 92 (6) ◽  
pp. 1203-1207 ◽  
Author(s):  
Niall J. Donnelly ◽  
Thomas R. Shrout ◽  
Clive A. Randall

2015 ◽  
Vol 233-234 ◽  
pp. 133-136 ◽  
Author(s):  
Leonard Bezmaternykh ◽  
Evgeniya Moshkina ◽  
Evgeniy Eremin ◽  
Maxim Molokeev ◽  
Nikita Volkov ◽  
...  

Temperature-field and orientational magnetization dependences of single crystals were measured. Both samples demonstrate significant field-depending temperature hysteresis and low-temperature counter field magnetization. The correlation of orientational dependences of these effects and magnetic anisotropy is analyzed; the role of spin-lattice interactions is discussed.


1987 ◽  
Vol 94 ◽  
Author(s):  
S. B. Ogale ◽  
M. Thomsen ◽  
A. Madhukar

ABSTRACTComputer simulations of III-V molecular beam epitaxy (MBE) show that surface reconstruction induced modulation of kinetic rates could give rise to ordering in alloys. Results are also presented for the possible influence of an external ion beam in achieving low temperature epitaxy as well as smoother growth front under usual conditions.


Fuel ◽  
2021 ◽  
Vol 303 ◽  
pp. 121239
Author(s):  
Zhiping Zhang ◽  
Yingying Li ◽  
Piaoping Yang ◽  
Yushi Li ◽  
Chen Zhao ◽  
...  

2021 ◽  
Vol 288 ◽  
pp. 110365
Author(s):  
He Zhang ◽  
Shuqian Zhou ◽  
Penta Pristijono ◽  
John B. Golding ◽  
Huqing Yang ◽  
...  

Materials ◽  
2021 ◽  
Vol 14 (1) ◽  
pp. 209
Author(s):  
Xuanming Ji ◽  
Panpan Ge ◽  
Song Xiang ◽  
Yuanbiao Tan

In this work, the effect of double-ageing heat treatments on the microstructural evolution and mechanical behaviour of a metastable β-titanium Ti-3.5Al-5Mo-4V alloy is investigated by X-ray diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The double-ageing treatments are composed of low-temperature pre-ageing and high-temperature ageing, where the low-temperature pre-ageing is conducted at 300 °C or 350 °C for different times, and the high-temperature ageing is conducted at 500 °C for 8 h. The results show that the phase transformation sequence is altered with the time spent during the first ageing stage, the isothermal ω phase is precipitated in the pre-ageing process of the alloy at 300 °C and 350 °C with the change in the ageing time, and the ω phase is finally transformed into the α phase with the extension of pre-ageing time. The existence time of the ω phase is shortened as the pre-ageing temperature increases. The microhardness of the alloy increases with increasing pre-ageing time and temperature. Compared with single-stage ageing, the ω phase formed in the pre-ageing stage changes the response to subsequent high-temperature ageing. After the two-stage ageing treatment, the precipitation size of the α phase is obviously refined after the double-ageing treatment. A microhardness test shows that the microhardness of the two-stage aged alloy increases with extended pre-ageing time.


Sign in / Sign up

Export Citation Format

Share Document