Confirmation of the compensation of unintentional donors in AlGaN/GaN HEMT structures by Mg-doping during initial growth of GaN buffer layer

2020 ◽  
Vol 219 ◽  
pp. 116904
Author(s):  
Dipankar Jana ◽  
Abhishek Chatterjee ◽  
T.K. Sharma
Keyword(s):  
Buffer Layer ◽  
Initial Growth ◽  
Mg Doping ◽  
Gan Hemt ◽  
Gan Buffer Layer

Initial growth effects on the properties of GaN buffer layer and subsequent GaN overlayer by MOCVD

2000 ◽  
Author(s):  
DongSing Wuu ◽  
WeiHao Tseng ◽  
WeiTsung Lin ◽  
RayHua Horng
Keyword(s):  
Buffer Layer ◽  
Initial Growth ◽  
Growth Effects ◽  
Gan Buffer Layer

The Effect of Ohmic Contact Location on the Buffer Leakage Current of AlGaN/GaN Heterostructure

2008 ◽  
Vol 600-603 ◽  
pp. 1337-1340
Author(s):  
Young Hwan Choi ◽  
Ji Yong Lim ◽  
Kyu Heon Cho ◽  
In Hwan Ji ◽  
Min Koo Han
Keyword(s):  
Buffer Layer ◽  
Leakage Current ◽  
Ohmic Contact ◽  
Lateral Diffusion ◽  
Drain Current ◽  
Gan Hemt ◽  
Cap Layer ◽  
Type C ◽  
Gan Heterostructure ◽  
Gan Buffer Layer

The effect of ohmic contact location on the buffer leakage current of AlGaN/GaN heterostructure was investigated and the AlGaN/GaN HEMT employing the proposed ohmic contact pattern was fabricated. We have fabricated 3 different types of ohmic patterns; type A - both contacts are on the etched GaN buffer layer, type B - one is on the etched GaN buffer layer and the other is on the unetched GaN cap layer and type C - both contacts are on the unetched GaN cap layer. Our experimental results showed that the ohmic contact on GaN buffer increased the buffer leakage current due to the lateral diffusion of ohmic metals. The proposed AlGaN/GaN HEMT successfully decreased the leakage current and did not affect the forward drain current and the transconductance.

scholarly journals Investigation of the Heteroepitaxial Process Optimization of Ge Layers on Si (001) by RPCVD

Nanomaterials ◽  
2021 ◽  
Vol 11 (4) ◽  
pp. 928
Author(s):  
Yong Du ◽  
Zhenzhen Kong ◽  
Muhammet Toprak ◽  
Guilei Wang ◽  
Yuanhao Miao ◽  
...  
Keyword(s):  
High Temperature ◽  
Buffer Layer ◽  
Layer Thickness ◽  
Growth Temperature ◽  
Crystalline Quality ◽  
Initial Growth ◽  
Two Dimensional ◽  
High Quality ◽  
Reduced Pressure

This work presents the growth of high-quality Ge epilayers on Si (001) substrates using a reduced pressure chemical vapor deposition (RPCVD) chamber. Based on the initial nucleation, a low temperature high temperature (LT-HT) two-step approach, we systematically investigate the nucleation time and surface topography, influence of a LT-Ge buffer layer thickness, a HT-Ge growth temperature, layer thickness, and high temperature thermal treatment on the morphological and crystalline quality of the Ge epilayers. It is also a unique study in the initial growth of Ge epitaxy; the start point of the experiments includes Stranski–Krastanov mode in which the Ge wet layer is initially formed and later the growth is developed to form nuclides. Afterwards, a two-dimensional Ge layer is formed from the coalescing of the nuclides. The evolution of the strain from the beginning stage of the growth up to the full Ge layer has been investigated. Material characterization results show that Ge epilayer with 400 nm LT-Ge buffer layer features at least the root mean square (RMS) value and it’s threading dislocation density (TDD) decreases by a factor of 2. In view of the 400 nm LT-Ge buffer layer, the 1000 nm Ge epilayer with HT-Ge growth temperature of 650 °C showed the best material quality, which is conducive to the merging of the crystals into a connected structure eventually forming a continuous and two-dimensional film. After increasing the thickness of Ge layer from 900 nm to 2000 nm, Ge surface roughness decreased first and then increased slowly (the RMS value for 1400 nm Ge layer was 0.81 nm). Finally, a high-temperature annealing process was carried out and high-quality Ge layer was obtained (TDD=2.78 × 107 cm−2). In addition, room temperature strong photoluminescence (PL) peak intensity and narrow full width at half maximum (11 meV) spectra further confirm the high crystalline quality of the Ge layer manufactured by this optimized process. This work highlights the inducing, increasing, and relaxing of the strain in the Ge buffer and the signature of the defect formation.

The Influence of Growth Temperature on Oxygen Concentration in GaN Buffer Layer

2008 ◽  
Vol 1068 ◽  
Author(s):  
Ewa Dumiszewska ◽  
Wlodek Strupinski ◽  
Piotr Caban ◽  
Marek Wesolowski ◽  
Dariusz Lenkiewicz ◽  
...  
Keyword(s):  
High Temperature ◽  
Buffer Layer ◽  
Oxygen Concentration ◽  
Growth Temperature ◽  
Low Temperatures ◽  
Buffer Layers ◽  
Crystalline Quality ◽  
Temperature Growth ◽  
Gan Buffer Layer

ABSTRACTThe influence of growth temperature on oxygen incorporation into GaN epitaxial layers was studied. GaN layers deposited at low temperatures were characterized by much higher oxygen concentration than those deposited at high temperature typically used for epitaxial growth. GaN buffer layers (HT GaN) about 1 μm thick were deposited on GaN nucleation layers (NL) with various thicknesses. The influence of NL thickness on crystalline quality and oxygen concentration of HT GaN layers were studied using RBS and SIMS. With increasing thickness of NL the crystalline quality of GaN buffer layers deteriorates and the oxygen concentration increases. It was observed that oxygen atoms incorporated at low temperature in NL diffuse into GaN buffer layer during high temperature growth as a consequence GaN NL is the source for unintentional oxygen doping.

Effect of N/Ga Flux Ratio in GaN Buffer Layer Growth by MBE on (0001) Sapphire on Defect Formation in the GaN Main Layer

1999 ◽  
Vol 572 ◽  
Author(s):  
S. Ruvimov ◽  
Z. Liliental-Weber ◽  
J. Washburn ◽  
Y. Kim ◽  
G. S. Sudhir ◽  
...  
Keyword(s):  
Dislocation Density ◽  
Buffer Layer ◽  
Defect Formation ◽  
Flux Ratio ◽  
Growth Conditions ◽  
Buffer Layers ◽  
Simultaneous Increase ◽  
Growth Stages ◽  
Dislocation Generation ◽  
Gan Buffer Layer

ABSTRACTTransmission electron microscopy was employed to study the effect of N/Ga flux ratio in the growth of GaN buffer layers on the structure of GaN epitaxial layers grown by molecular-beamepitaxy (MBE) on sapphire. The dislocation density in GaN layers was found to increase from 1×1010 to 6×1010 cm−2 with increase of the nitrogen flux from 5 to 35 sccm during the growth of the GaN buffer layer with otherwise the same growth conditions. All GaN layers were found to contain inversion domain boundaries (IDBs) originated at the interface with sapphire and propagated up to the layer surface. Formation of IDBs was often associated with specific defects at the interface with the substrate. Dislocation generation and annihilation were shown to be mainly growth-related processes and, hence, can be controlled by the growth conditions, especially during the first growth stages. The decrease of electron Hall mobility and the simultaneous increase of the intensity of “green” luminescence with increasing dislocation density suggest that dislocation-related deep levels are created in the bandgap.

Sign in / Sign up

Export Citation Format

Share Document