The use of grain-size dependent magnetic susceptibility and gamma-ray measurements for the detailed reconstruction of volcanostratigraphy: The case of La Fossa di Vulcano, S. Italy

2004 ◽  
Vol 138 (1-2) ◽  
pp. 163-183 ◽  
Author(s):  
Iris Gehring
2009 ◽  
Vol 105 (7) ◽  
pp. 07A701 ◽  
Author(s):  
Stefan Philippi ◽  
Jürgen Markmann ◽  
Rainer Birringer ◽  
Andreas Michels

2015 ◽  
Vol 211 ◽  
pp. 67-76 ◽  
Author(s):  
B. Lyson-Sypien ◽  
M. Radecka ◽  
M. Rekas ◽  
K. Swierczek ◽  
K. Michalow-Mauke ◽  
...  

2021 ◽  
Author(s):  
Sandra B. Ramírez-García ◽  
Luis M. Alva-Valdivia

<p>Magnetite formation of serpentinized ultramafic rocks leads to variations in the magnetic properties of serpentinites; however, magnetite precipitation is still on debate.</p><p>In this work, we analyzed 60 cores of ultramafic rocks with a variety of serpentinization degrees. These rocks belong to the ultramafic-mafic San Juan de Otates complex in Guanajuato, Mexico. Geochemical studies have been previously conducted, enabling us to compare changes in the magnetic properties against the chemical variations generated by the serpentinization process. By studying the density and magnetic properties such as anisotropy of magnetic susceptibility, hysteresis curves as well as magnetic and temperature-dependent susceptibility and, we were able to identify the relationship between magnetic content and serpentinization degree, the predominant magnetic carrier, and to what extent the magnetite grain size depends on the serpentinization.  Variations in these parameters allowed us to better constrain the temperature at which serpentinization occurred, the generation of other Fe-rich phases such as Fe-brucite and/or Fe-rich serpentine as well as distinctive rock textures formed at different serpentinization degrees.</p>


2012 ◽  
Vol 715-716 ◽  
pp. 703-710
Author(s):  
W.M. Rainforth ◽  
P. Zeng ◽  
L. Ma

t is well known that alumina ceramics undergo a time dependent wear transition during sliding wear. The transition, which is associated with 1-2 orders of magnitude increase in specific wear rate, involves a change from mild wear to intergranular fracture. The transition is strongly grain size dependent, with the time to the transition decreasing with grain size. However, there is a minimum grain size that can be achieved in fully dense alumina using commercially viable processing. Alternative strategies for reducing grain size and increasing toughness are through the addition of a fine second phase, with SiC and ZrO2being the most promising. The resultant composite not only has finer grain size, but also exhibits additional toughening mechanisms. This paper reports on the microstructural control in alumina, zirconia toughened alumina and alumina-silicon carbide composites. The grain size and residual stress distribution are related to the damage accumulation mechanism that occur during frictional contact, in particular the surface specific dislocation activity.


Sign in / Sign up

Export Citation Format

Share Document