Effect of limestone aggregate type and water–cement ratio on concrete strength

2004 ◽  
Vol 58 (5) ◽  
pp. 772-777 ◽  
Author(s):  
Ergül Yaşar ◽  
Yasin Erdoğan ◽  
Alaettin Kılıç
2021 ◽  
pp. 1-41
Author(s):  
Haotian Fan ◽  
Ravindra K. Dhir ◽  
Peter C. Hewlett

This study, third in the series, following from ground limestone and Class F fly ash, evaluates, as a cement constituent, the effect of using ground granulated blast furnace slag (GGBS) on the strength development of concrete, and consequently its embodied carbon dioxide (CO2e). The paper has been built from systematically analysing, evaluating and modelling the extensive data-matrix developed, having 85,099 data points, from the information sourced from 663 studies published in English, during 1974 to 2020, by 1,672 authors, working in 718 institutions in 49 countries, globally. It is shown that, at a given water/cement ratio, in comparison to Portland cement (PC), the use of GGBS results in a reduction in 28-day concrete strength, which increases with GGBS content, at a rate determined by the strength of concrete, GGBS fineness, and curing of concrete. It is also shown that, as to achieve a 28-day design strength, a lower water/cement ratio is required with a PC/GGBS blended cement than PC, this will reduce the actual CO2e savings that can be realised with the use of GGBS as cement constituent in manufacturing concrete. Finally, it is shown that GGBS is more effective in lowering CO2e of concrete than FA and GLS.


2013 ◽  
Vol 838-841 ◽  
pp. 1801-1805 ◽  
Author(s):  
Li Juan Kong ◽  
Qing Chao Meng ◽  
Yuan Bo Du

Influence of aggregate types on the impermeability and frost-resistance of concrete with different water/cement ratios were investigated, as well as the pore structure and hydrates of the ITZ. The results show that, concrete prepared with a high water/cement ratio and using granite aggregate, presents the highest values of chloride diffusion coefficient and the lowest numbers of freeze-thaw cycles. Whereas concrete prepared with a low water/cement ratio and using limestone aggregate, obtains the similar durability results. The limestone aggregate with a rough surface and higher water absorption, has a tight bonding with the cement paste. However, the granite and basalt aggregate that formed by magma eruption, have higher activity. The XRD results demonstrate that more clinkers participate in the hydration of cement, therefore, resulting in a denser ITZ. In order to improve the concrete durability, the basalt aggregate both with higher activity and rough surface is consider optimal.


2021 ◽  
Vol 283 ◽  
pp. 01016
Author(s):  
Wei Li

In this paper, the main strength of the relationship between water-cement ratio and concrete, and it uses the contrast test of different water cement ratio, finally, it gets the regular change between water cement ratio and concrete strength. The test results show that: cement. when the ratio of large stone: small stone: water: admixture is 340: 618: 1009: 433: 139: 6.8, the water-cement ratio of concrete is within the range of 0.371-0.479. The concrete strength of the sample decreases with the increase of the water-cement ratio. Finally, the relationship between the concrete strength and the water-cement ratio is obtained by fitting.


2014 ◽  
Vol 487 ◽  
pp. 84-89
Author(s):  
Hai Long Ning ◽  
Wen Feng Zhao ◽  
Jian Liu ◽  
Shao Peng Jiao ◽  
Yi Xin Wang

To study the effect of recycled coarse aggregate, water-cement ratio and mixture ratio on the physico-mechanical properties of recycled concrete, determine the finial optimum mixture ratio and physico-mechanical properties of recycled concrete with the optimum mixture ratio, physico-mechanical tests are done on recycled concrete and conventional concrete. Results show that with the replacement rate increasing of recycled coarse aggregate, the compressive strength and splitting tensile strength of recycled concrete increase and then decrease. It is feasible to develop the concrete with 100% replacement rate of recycled coarse aggregate. With an increase of recycled coarse aggregate replacement rate, dry shrinkage ratio of concrete increases gradually, but the increasing range has little effect on the concrete. The concrete strength of 28 days is linear with water-cement ratio with the correlation coefficient is 0.98763. Taking appropriate mix design, the physico-mechanical properties of recycled concrete will surpass or be equivalent to those of conventional concrete. Recycled concrete of the optimum mixing rate is the high strength with lower brittleness.


2012 ◽  
Vol 174-177 ◽  
pp. 1552-1557 ◽  
Author(s):  
Ya Li Sun ◽  
Jin Song Zhu

This paper studies the effects of different water-cement ratio on recycled concrete strength, anti-carbonation capability, and protecting reinforce steel bar capability. Select the water-cement ratio 0.6,0.55,0.5,0.45,0.4 five cases of the pilot study.It shows that: recycled concrete cube compressive strength, anti-carbonation capacity and protecting reinforce steel bar capability are less than ordinary concrete.


Author(s):  
E Susanti ◽  
H Istiono ◽  
I Komara ◽  
D Pertiwi ◽  
Y Septiarsilia ◽  
...  

2021 ◽  
Vol 9 (2) ◽  
pp. 106-109
Author(s):  
Fathelrahman M. Adam ◽  
Omer E. A. ◽  
Mohammed I. Ali ◽  
Salih E. M.

In this research, a study of using silica sand of a purity reaches 95% was done in order to know its effects on the strength of concrete when it used as an alternative to the normal sand by a different ratio of 25%, 50%, 75% and 100%. The study was done using Normal Portland Cement with a water/cement ratio of 0.52 and the mix design was done according to the British Standard Method. The ratio 1:1.5:3 was used for the different materials composed of the mix design. A reference mix design was used without containing any silica sand by means of 0% ratio of silica sand. Compression tests for the strength of concrete have been done for cubes of 7 days and 28 days age of curing and the results obtained appeared that the using of silica sand increases the concrete strength with reaching the peak at a ratio of 50% of silica sand where the strength was increased for the 7 days and 28 days by a ratio of 10% and 11% more than the strength of reference mix design respectively. Also, the study appears that the increase of silica sand by more than 50%, leads to the brittleness of concrete and this has been seen clearly when the ratio of silica sand reached 100% since the strength of concrete be down by 31% for 7 days and by 16% for the 28 days.  


2021 ◽  
Vol 4 (2) ◽  
pp. 16
Author(s):  
Honghong Ye ◽  
Delin Zeng ◽  
Yong Yang ◽  
Xingbo Fan ◽  
Wei Wang ◽  
...  

Considering actual construction conditions of Binchuan-Heqing Highway, this paper provides the C50 mix ratio conforming to engineering requirements by strictly controlling the quality of raw materials, optimizing the design of mix ratio scientifically, preparing superior C50 concrete 0 with manufactured sand, and optimizing the concrete mix ratio based on the adjustment of fly ash replacement, water-cement ratio, polycarboxylate-type water reducer mixing amount, sand ratio, etc. The result indicates that, the water-cement ratio has a great influence on the concrete strength, and if the ratio of coal ash is high in the binding material, the early compressive strength of the concrete will increase slowly.


Sign in / Sign up

Export Citation Format

Share Document