Non-Klinkenberg slippage phenomenon at high pressure for tight core floods using a novel high pressure gas permeability measurement system

2017 ◽  
Vol 156 ◽  
pp. 62-66 ◽  
Author(s):  
Wei-qing An ◽  
Xiang-an Yue ◽  
Xue-gang Feng ◽  
JosephYuchun Fu ◽  
Xing Fang ◽  
...  
2011 ◽  
Vol 82 (5) ◽  
pp. 054702 ◽  
Author(s):  
Eun Ho Song ◽  
Young Wook Park ◽  
Jin Hwan Choi ◽  
Tae Hyun Park ◽  
Jin Wook Jeong ◽  
...  

2005 ◽  
Vol 76 (1) ◽  
pp. 013902 ◽  
Author(s):  
A. Ranade ◽  
N. A. D’Souza ◽  
R. M. Wallace ◽  
B. E. Gnade

Holzforschung ◽  
2001 ◽  
Vol 55 (1) ◽  
pp. 82-86
Author(s):  
J. Lu ◽  
F. Bao ◽  
Y. Zhao

Summary To calculate the effective radii of two conductive elements in series in wood specimens by using the gas permeability measurement, the four parameters from the curvilinear relationship of superficial specific permeability against reciprocal mean pressure as illustrated in Petty's model must be evaluated. This paper describes a detailed procedure for obtaining such parameters by using the least-squares fit calculated from a statistical analysis system (SAS) program. Three different iterative optimization algorithms and starting points were used separately to fit the Petty's nonlinear model based on the same experimental data from one specimen of birch. The estimate of the parameters: A = 35.38 darcy, B = 80.51 darcy, l = 0.19 darcy atm, m = 6.34 darcy atm was recommended for the fitted model. Compared to the results on the estimate of parameters obtained in the previous papers, this estimate for the parameters was a global minimum, thus it was a refinement and more accurate. Since the Gauss-Newton method resulted in almost the same convergence results for all the three sets of starting values with the least iterations in the evaluation, it was the preferred optimization algorithm both for simplicity and accuracy in solving the Petty's model. Because the same solutions for all three iterative optimization algorithms were obtained by using two different sets of starting points produced from the grid search, a grid search seemed to be very helpful for finding reasonable starting values for various iterative optimization techniques.


2007 ◽  
Vol 46 (5A) ◽  
pp. 3090-3095 ◽  
Author(s):  
Fumiaki Tomioka ◽  
Izuru Umehara ◽  
Takashi Ono ◽  
Masato Hedo ◽  
Yoshiya Uwatoko ◽  
...  

2015 ◽  
Vol 42 (1) ◽  
pp. 92-96 ◽  
Author(s):  
Jianlong FANG ◽  
Ping GUO ◽  
Xiangjiao XIAO ◽  
Jianfen DU ◽  
Chao DONG ◽  
...  

Author(s):  
Hadi Belhaj ◽  
Bechir Mtawaa ◽  
Mohammed Haroun ◽  
Terry Lay

Energies ◽  
2019 ◽  
Vol 12 (12) ◽  
pp. 2351 ◽  
Author(s):  
Jirui Zou ◽  
Xiangan Yue ◽  
Weiqing An ◽  
Jun Gu ◽  
Liqi Wang

The Klinkenberg slippage theory has widely been used to obtain gas permeability in low-permeability porous media. However, recent research shows that there is a deviation from the Klinkenberg slippage theory for tight reservoir cores under low-pressure conditions. In this research, a new experimental device was designed to carry out the steady-state gas permeability test with high pressure and low flowrate. The results show that, unlike regular low-permeability cores, the permeability of tight cores is not a constant value, but a variate related to a fluid-dynamic parameter (flowrate). Under high-pressure conditions, the relationship between flowrate and apparent permeability of cores with low permeability is consistent with Klinkenberg slippage theory, while the relationship between flowrate and apparent permeability of tight cores is contrary to Klinkenberg slip theory. The apparent permeability of tight core increases with increasing flowrate under high-pressure conditions, and it is significantly lower than the Klinkenberg permeability predicted by Klinkenberg slippage theory. The difference gets larger when the flowrate becomes lower (back pressure increases and pressure difference decreases). Therefore, the Klinkenberg permeability which is obtained by the Klinkenberg slippage theory by using low-pressure experimental data will cause significant overestimation of the actual gas seepage capacity in the tight reservoir. In order to evaluate the gas seepage capacity in a tight reservoir precisely, it is necessary to test the permeability of the tight cores directly at high pressure and low flowrate.


1971 ◽  
Vol 49 (1A) ◽  
pp. 135-135
Author(s):  
R. W. Higgs ◽  
P. M. D'Amico ◽  
L. J. Eriksson

Sign in / Sign up

Export Citation Format

Share Document