Influence of thermal treatment conditions on capacitive deionization performance and charge efficiency of carbon electrodes

2018 ◽  
Vol 202 ◽  
pp. 67-75 ◽  
Author(s):  
Lutfi Agartan ◽  
Bilen Akuzum ◽  
Tyler Mathis ◽  
Kurtay Ergenekon ◽  
Ertan Agar ◽  
...  
2021 ◽  
Vol 4 (1) ◽  
Author(s):  
Eric N. Guyes ◽  
Amit N. Shocron ◽  
Yinke Chen ◽  
Charles E. Diesendruck ◽  
Matthew E. Suss

AbstractEmerging water purification applications often require tunable and ion-selective technologies. For example, when treating water for direct use in irrigation, often monovalent Na+ must be removed preferentially over divalent minerals, such as Ca2+, to reduce both ionic conductivity and sodium adsorption ratio (SAR). Conventional membrane-based water treatment technologies are either largely non-selective or not dynamically tunable. Capacitive deionization (CDI) is an emerging membraneless technology that employs inexpensive and widely available activated carbon electrodes as the active element. We here show that a CDI cell leveraging sulfonated cathodes can deliver long-lasting, tunable monovalent ion selectivity. For feedwaters containing Na+ and Ca2+, our cell achieves a Na+/Ca2+ separation factor of up to 1.6. To demonstrate the cell longevity, we show that monovalent selectivity is retained over 1000 charge–discharge cycles, the highest cycle life achieved for a membraneless CDI cell with porous carbon electrodes to our knowledge, while requiring an energy consumption of ~0.38 kWh/m3 of treated water. Furthermore, we show substantial and simultaneous reductions of ionic conductivity and SAR, such as from 1.75 to 0.69 mS/cm and 19.8 to 13.3, respectively, demonstrating the potential of such a system towards single-step water treatment of brackish and wastewaters for direct use in irrigation.


2016 ◽  
Vol 65 (2) ◽  
pp. 432-439 ◽  
Author(s):  
A. A. Shesterkina ◽  
L. M. Kozlova ◽  
O. A. Kirichenko ◽  
G. I. Kapustin ◽  
I. V. Mishin ◽  
...  

2021 ◽  
Vol 312 ◽  
pp. 110757
Author(s):  
Minjun Kim ◽  
Hyunsoo Lim ◽  
Xingtao Xu ◽  
Md Shahriar A. Hossain ◽  
Jongbeom Na ◽  
...  

2015 ◽  
Vol 1 (4) ◽  
pp. 516-522 ◽  
Author(s):  
Danyang Liu ◽  
Kuan Huang ◽  
Leijie Xie ◽  
Hao L. Tang

This work presents a novel attempt at using a statistical modeling approach to predict the desalination performance of CDI.


2014 ◽  
Vol 604 ◽  
pp. 249-253 ◽  
Author(s):  
Agnese Pura ◽  
Janis Locs ◽  
Liga Berzina-Cimdina

TiO2samples were obtained by extrusion process, sintered in air at 1000 °C, 1100 °C, 1200°C and 1300 °C and, afterwards, thermally treated under vacuum conditions at 1250 °C for 1 hour applying two different heating/cooling rates (2 °C/min and 5 °C/min). It was found that thermal treatment conditions substantially affected thermoelectric properties of the samples. Increasing sintering temperature, during the sample thermal treatment in air, the electrical conductivity of the specimens increased, while Seebeck coefficient decreased. With an increase in the heating rate during the vacuum heat treatment of the samples, the electrical conductivity of the samples decreased, while Seebeck coefficient increased.


Carbon ◽  
2019 ◽  
Vol 149 ◽  
pp. 627-636 ◽  
Author(s):  
Linlin Wu ◽  
Mingquan Liu ◽  
Silu Huo ◽  
Xiaogang Zang ◽  
Min Xu ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document