Sidewall finite-conductivity effects in confined turbulent thermal convection

2002 ◽  
Vol 473 ◽  
pp. 201-210 ◽  
Author(s):  
ROBERTO VERZICCO
Keyword(s):  
Boundary Conditions ◽  
Thermal Convection ◽  
Lateral Wall ◽  
Finite Conductivity ◽  
Mean Flow ◽  
Number Range ◽  
Additional Heat ◽  
Low Aspect Ratio ◽  
Temperature Boundary ◽  
The Mean

The effects of a sidewall with finite thermal conductivity on confined turbulent thermal convection has been investigated using direct numerical simulation. The study is motivated by the observation that the heat flowing through the lateral wall is not always negligible in the low-aspect-ratio cells of several recent experiments. The extra heat flux modifies the temperature boundary conditions of the flow and therefore the convective heat transfer. It has been found that, for usual sidewall thicknesses, the heat travelling from the hot to the cold plates directly through the sidewall is negligible owing to the additional heat exchanged at the lateral fluid/wall interface. In contrast, the modified temperature boundary conditions alter the mean flow yielding significant Nusselt number corrections which, in the low Rayleigh number range, can change the exponent of the Nu vs. Ra power law by 10%.

Scaling laws for pipe-flow turbulence

1975 ◽  
Vol 67 (2) ◽  
pp. 257-271 ◽  
Author(s):  
A. E. Perry ◽  
C. J. Abell
Keyword(s):  
Pipe Flow ◽  
Scaling Laws ◽  
Dynamic Calibration ◽  
Turbulence Structure ◽  
Mean Flow ◽  
Number Range ◽  
Static Calibration ◽  
Calibration Methods ◽  
The Mean ◽  
Flow Turbulence

Using hot-wire-anemometer dynamic-calibration methods, fully developed pipe-flow turbulence measurements have been taken in the Reynolds-number range 80 × 103 to 260 × 103. Comparisons are made with the results of previous workers, obtained using static-calibration methods. From the dynamic-calibration results, a consistent and systematic correlation for the distribution of turbulence quantities becomes evident, the resulting correlation scheme being similar to that which has previously been established for the mean flow. The correlations reported have been partly conjectured in the past by many workers but convincing experimental evidence has always been masked by the scatter in the results, no doubt caused by the difficulties associated with static-calibration methods, particularly the earlier ones. As for the mean flow, the turbulence intensity measurements appear to collapse to an inner and outer law with a region of overlap, from which deductions can be made using dimensional arguments. The long-suspected similarity of the turbulence structure and its consistency with the established mean-flow similarity appears to be confirmed by the measurements reported here.

Influences of Turbulence Boundary Conditions on RANS and URANS Simulations for an Inter-Turbine Duct

2020 ◽  
Author(s):  
Alessio Firrito ◽  
Yannick Bousquet ◽  
Nicolas Binder ◽  
Ludovic Pintat
Keyword(s):  
Flow Field ◽  
Boundary Conditions ◽  
Mean Flow ◽  
Time Resolved ◽  
Flow Solution ◽  
Low Pressure Turbine ◽  
Outlet Flow ◽  
Architecture Evolution ◽  
The Mean ◽  
Turbulence Length

Abstract In recent years, lot of turbine research is focused on the study and optimization of inter-turbine ducts, an aero-engine component for which the design is becoming more challenging due to the turbofan architecture evolution. Starting from the early design phase, the knowledge of the component performance and outlet flow pattern is crucial in the design of the low pressure turbine. To improve prediction, multi-row unsteady simulations are deployed. Unfortunately, some questions arise in the use of these simulations, among others the knowledge of the turbulent boundary conditions and the contribution of the unsteady simulations to the flow solution. In this paper steady and time resolved RANS simulations of a turning inter-turbine duct are investigated. Particularly, two questions are addressed. The first one is the influence of the turbulent quantities boundary conditions in the case of a k–ω Wilcox turbulence model in the flow field solution. The second one is the contribution of the unsteadiness to the mean flow prediction. It will be shown that the mean flow depends on inlet turbulence only if the turbulence length scale is relatively high; otherwise the flow field is almost turbulence-invariant. For the unsteady simulations, unsteadiness modifies the mean flow solution only with low inlet turbulence.

A Continuous Prediction Method for Fully Developed Laminar, Transitional, and Turbulent Flows in Pipes

1975 ◽  
Vol 42 (1) ◽  
pp. 51-54 ◽  
Author(s):  
N. W. Wilson ◽  
R. S. Azad
Keyword(s):  
Turbulent Flows ◽  
Flow Characteristics ◽  
Prediction Method ◽  
Reynolds Numbers ◽  
Mean Flow ◽  
Number Range ◽  
Circular Pipes ◽  
The Mean ◽  
Single Set ◽  
Good Agreement

A single set of equations is developed to predict the mean flow characteristics in long circular pipes operating at laminar, transitional, and turbulent Reynolds numbers. Generally good agreement is obtained with available data in the Reynolds number range 100 < Re < 500,000.

Subsonic Turbulent Flow Past a Planar Fence

1979 ◽  
Vol 101 (3) ◽  
pp. 373-375
Author(s):  
M. L. Agarwal ◽  
P. K. Pande ◽  
Rajendra Prakash
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Flow Field ◽  
Boundary Conditions ◽  
Mean Flow ◽  
Governing Equations ◽  
Flow Past ◽  
Entire Flow ◽  
The Mean ◽  
Shape And Size

The mean flow past a fence submerged in a turbulent boundary layer is numerically simulated. The governing equations have been simplified by neglecting the convective effects of turbulence and solved numerically using experimental boundary conditions. The information obtained includes the shape and size of the upstream and downstream separation bubbles and the streamline pattern in the entire flow field. General agreement between the simulated and the experimental flow field was found.

scholarly journals Mean flows generated by a progressing water wave packert

1981 ◽  
Vol 22 (3) ◽  
pp. 318-347 ◽  
Author(s):  
R. Grimshaw
Keyword(s):  
Wave Packet ◽  
Boundary Conditions ◽  
Finite Length ◽  
Water Wave ◽  
Wave Train ◽  
Mean Flow ◽  
The Mean

AbstractEquations are derived which describe the evolution of the mean flow generated by a progressing water wave packet. The effect of friction is included, and so the equations are subject to the boundary conditions first derived by Longuet-Higgins [10]. Solutions of the equations are obtained for a wave packet of finite length, and also for a uniform wave train. The latter solution is compared with experiments.

The distortion of turbulence by a circular cylinder

1979 ◽  
Vol 92 (2) ◽  
pp. 269-301 ◽  
Author(s):  
R. E. Britter ◽  
J. C. R. Hunt ◽  
J. C. Mumford
Keyword(s):  
Circular Cylinder ◽  
Spectral Energy ◽  
Cylinder Surface ◽  
List Type ◽  
Cylinder Wake ◽  
Mean Flow ◽  
Mean Velocity ◽  
Number Range ◽  
Velocity Fluctuations ◽  
The Mean

The flow of grid-generated turbulence past a circular cylinder is investigated using hot-wire anemometry over a Reynolds number range from 4·25 × 103 to 2·74 × 104 and a range of intensities from 0·025 to 0·062. Measurements of the mean velocity distribution, and r.m.s. intensities and spectral energy densities of the turbulent velocity fluctuations are presented for various radial and circumferential positions relative to the cylinder, and for ratios of the cylinder radius a to the scale of the incident turbulence Lx ranging from 0·05 to 1·42. The influence of upstream conditions on the flow in the cylinder wake and its associated induced velocity fluctuations is discussed.For all measurements, detailed comparison is made with the theoretical predictions of Hunt (1973). We conclude the following. The amplification and reduction of the three components of turbulence (which occur in different senses for the different components) can be explained qualitatively in terms of the distortion by the mean flow of the turbulent vorticity and the ‘blocking’ or ‘source’ effect caused by turbulence impinging on the cylinder surface. The relative importance of the first effect over the second increases as a/Lx increases or the distance from the cylinder surface increases.Over certain ranges of the variables involved, the measurements are in quantitative agreement with the predictions of the asymptotic theory when a/Lx [Lt ] 1, a/Lx [Gt ] 1 or |k| a [Gt ] 1 (where k is the wavenumber).The incident turbulence affects the gross properties of the flow in the cylinder wake, but the associated velocity fluctuations are probably statistically independent of those in the incident flow.The dissipation of turbulent energy is greater in the straining flow near the cylinder than in the approach flow. Some estimates for this effect are proposed.

The Effect of Sound on Vortex Shedding From Single and Tandem Cylinders

2002 ◽  
Author(s):  
Joseph W. Hall ◽  
Samir Ziada ◽  
David S. Weaver
Keyword(s):  
Vortex Shedding ◽  
Sound Field ◽  
Open Circuit ◽  
Mean Flow ◽  
Number Range ◽  
Single Cylinder ◽  
Tandem Cylinders ◽  
Vortex Shedding Frequency ◽  
The Mean ◽  
Lock In

A single cylinder and two tandem cylinders configurations with longitudinal pitch ratios L/D = 1.75 and 2.5 were rigidly mounted in an open circuit windtunnel and a sound field was applied so that the acoustic particle velocity was normal to both the cylinder axis and the mean flow velocity. Tests were performed for a Reynolds number range of 5000 &lt; ReD &lt; 24000. The effect of sound on the vortex shedding was investigated by instrumenting the cylinders with pressure taps and hot-wire probes. These tests show that applied sound can entrain and shift the natural vortex shedding frequency to the frequency of excitation and produce nonlinearities in the wake. The lock-in envelope for the tandem cylinders is considerably larger than for the single cylinder. The lock-in range for the smaller tandem cylinder spacing (L/D = 1.75) was broader still than either the single cylinder, or the L/D = 2.5 tandem cylinder case.

Free-Stream Vorticity Disturbances Adjusting to the Presence of a Plate—A Quarter-Plane Problem

1977 ◽  
Vol 44 (4) ◽  
pp. 529-533 ◽  
Author(s):  
H. Rogler
Keyword(s):  
Boundary Conditions ◽  
Unsteady Flow ◽  
Dirichlet Boundary ◽  
Free Stream ◽  
Dirichlet Boundary Conditions ◽  
Wavy Wall ◽  
Mean Flow ◽  
Quarter Plane ◽  
Taylor’S Hypothesis ◽  
The Mean

Vorticity disturbances are introduced at a grid and convect with the uniform mean flow alongside a flat plate. The influence of the plate on this rotational, unsteady flow is found by solving Laplace’s equation in a quarter plane subject to Dirichlet boundary conditions. In the corner region downstream of the grid and near the plate, the streamline patterns do not convect with the mean flow and Taylor’s hypothesis is not valid as indicated by the velocity correlations. The influence of the plate is limited to a region from the plate to about one vortex diameter away from the plate. Near the plate and about one diameter downstream of the grid, a new streamline pattern evolves which convects along without further change. The alteration to the free-stream disturbances produced by the plate also represents the flow introduced by a wavy wall.

scholarly journals Surface-roughness effects on the mean flow past circular cylinders

1980 ◽  
Vol 98 (4) ◽  
pp. 673-701 ◽  
Author(s):  
O. Güven ◽  
C. Farell ◽  
V. C. Patel
Keyword(s):  
Boundary Layer ◽  
Surface Roughness ◽  
Pressure Rise ◽  
Boundary Layer Separation ◽  
Circular Cylinders ◽  
Mean Flow ◽  
Roughness Effects ◽  
Number Range ◽  
Mean Pressure ◽  
The Mean

Measurements of mean-pressure distributions and boundary-layer development on rough-walled circular cylinders in a uniform stream are described. Five sizes of distributed sandpaper roughness have been tested over the Reynolds-number range 7 × 104to 5·5 × 105. The results are examined together with those of previous investigators, and the observed roughness effects are discussed in the light of boundary-layer theory. It is found that there is a significant influence of surface roughness on the mean-pressure distribution even at very large Reynolds numbers. This observation is supported by an extension of the Stratford–Townsend theory of turbulent boundary-layer separation to the case of circular cylinders with distributed roughness. The pressure rise to separation is shown to be closely related, as expected, to the characteristics of the boundary layer, smaller pressure rises being associated with thicker boundary layers with greater momentum deficits. Larger roughness gives rise to a thicker and more retarded boundary layer which separates earlier and with a smaller pressure recovery.

Parametric Resonance Oscillations of Flexible Slender Cylinders in Harmonically Perturbed Axial Flow—Part 1: Theory

1980 ◽  
Vol 47 (4) ◽  
pp. 709-714 ◽  
Author(s):  
M. P. Paidoussis ◽  
N. T. Issid ◽  
M. Tsui
Keyword(s):  
Boundary Conditions ◽  
Flow Velocity ◽  
Dynamical Behavior ◽  
Parametric Instability ◽  
Axial Flow ◽  
Mean Flow ◽  
Parametric Resonances ◽  
Flow Part ◽  
The Mean ◽  
Resonance Oscillations

This paper studies theoretically the dynamical behavior of a flexible slender cylinder in pulsating axial flow. The dynamics of the system in steady, unperturbed flow are examined first. For various sets of boundary conditions the eigenfrequencies of the system at any given flow velocity are determined, and the critical flow velocities are established, beyond which buckling (divergence) would occur. The behavior of the system in pulsating flow is examined next, establishing the existence of parametric resonances. The effects of the mean flow velocity, boundary conditions, dissipative forces, and virtual (hydrodynamic) mass on the extent of the parametric instability zones are then discussed.

Sign in / Sign up

Export Citation Format

Share Document