On the temporal instability of a two-dimensional viscous liquid sheet

1991 ◽  
Vol 226 ◽  
pp. 425-443 ◽  
Author(s):  
Xianguo Li ◽  
R. S. Tankin

This paper reports a temporal instability analysis of a moving thin viscous liquid sheet in an inviscid gas medium. The results show that surface tension always opposes, while surrounding gas and relative velocity between the sheet and gas favour, the onset and development of instability. It is found that there exist two modes of instability for viscous liquid sheets – aerodynamic and viscosity-enhanced instability – in contrast to inviscid liquid sheets for which the only mode of instability is aerodynamic. It is also found that axisymmetrical disturbances control the instability process for small Weber numbers, while antisymmetrical disturbances dominate for large Weber numbers. For antisymmetrical disturbances, liquid viscosity, through the Ohnesorge number, enhances instability at small Weber numbers, while liquid viscosity reduces the growth rate and the dominant wavenumber at large Weber numbers. At the intermediate Weber-number range, Liquid viscosity has complicated effects due to the interaction of viscosity-enhanced and aerodynamic instabilities. In this range, the growth rate curve exhibits two local maxima, one corresponding to aerodynamic instability, for which liquid viscosity has a negligible effect, and the other due to viscosity-enhanced instability, which is influenced by the presence and variation of liquid viscosity. For axisymmetrical disturbances, liquid viscosity always reduces the growth rate and the dominant wavenumber, aerodynamic instability always prevails, and although the regime of viscosity-enhanced instability is always present, its growth rate curve does not possess a local maximum.

2008 ◽  
Vol 131 (1) ◽  
Author(s):  
M. Ahmed ◽  
N. Ashgriz ◽  
H. N. Tran

An experimental investigation is conducted to determine the effect of liquid viscosity and density, nozzle diameter, and flow velocity on the break-up length and spreading angle of liquid sheets formed by splash plate nozzles. Various mixtures of corn syrup and water were used to obtain viscosities in the range of 1–170 mPa s. Four different splash plate nozzle diameters of 0.5 mm, 0.75 mm, 1 mm, and 2 mm, with a constant plate angle of 55 deg were tested. The liquid sheet angles and the break-up lengths were measured at various operating conditions. An empirical correlation for the sheet spreading angle and a semi-empirical correlation for the sheet break-up lengths are developed.


Author(s):  
Kai Yan ◽  
Milind A. Jog ◽  
Zhi Ning

A nonlinear spatial instability analysis of an annular swirling viscous liquid sheet has been carried out by a perturbation expansion method with the initial amplitude of the disturbance as the perturbation parameter. The viscous liquid sheet is considered to move axially and azimuthally and is exposed to co-flowing inner and outer gas streams. The effects of liquid swirl strength and liquid viscosity on the sheet instability and breakup length have been studied. The results show that except at very low values of swirl to axial velocity ratio of the liquid sheet, the liquid swirl destabilizes the sheet. The sheet breakup length increases slightly and then decreases rapidly with an increase in liquid swirl strength. Viscosity has a stabilizing effect on the sheet breakup. The sheet breakup length increases with an increase in liquid viscosity.


2016 ◽  
Vol 26 (4) ◽  
pp. 319-347 ◽  
Author(s):  
Han-Yu Deng ◽  
Feng Feng ◽  
Xiao-Song Wu

2000 ◽  
Vol 406 ◽  
pp. 281-308 ◽  
Author(s):  
SEYED A. JAZAYERI ◽  
XIANGUO LI

A nonlinear stability analysis has been carried out for plane liquid sheets moving in a gas medium at rest by a perturbation expansion technique with the initial amplitude of the disturbance as the perturbation parameter. The first, second and third order governing equations have been derived along with appropriate initial and boundary conditions which describe the characteristics of the fundamental, and the first and second harmonics. The results indicate that for an initially sinusoidal sinuous surface disturbance, the thinning and subsequent breakup of the liquid sheet is due to nonlinear effects with the generation of higher harmonics as well as feedback into the fundamental. In particular, the first harmonic of the fundamental sinuous mode is varicose, which causes the eventual breakup of the liquid sheet at the half-wavelength interval of the fundamental wave. The breakup time (or length) of the liquid sheet is calculated, and the effect of the various flow parameters is investigated. It is found that the breakup time (or length) is reduced by an increase in the initial amplitude of disturbance, the Weber number and the gas-to-liquid density ratio, and it becomes asymptotically insensitive to the variations of the Weber number and the density ratio when their values become very large. It is also found that the breakup time (or length) is a very weak function of the wavenumber unless it is close to the cut-off wavenumbers.


2011 ◽  
Vol 66-68 ◽  
pp. 1556-1561 ◽  
Author(s):  
Kai Yan ◽  
Ming Lv ◽  
Zhi Ning ◽  
Yun Chao Song

A three-dimensional linear instability analysis was carried out for an annular swirling viscous liquid jet with solid vortex swirl velocity profile. An analytical form of dispersion relation was derived and then solved by a direct numerical procedure. A parametric study was performed to explore the instability mechanisms that affect the maximum spatial growth rate. It is observed that the liquid swirl enhances the breakup of liquid sheet. The surface tension stabilizes the jet in the low velocity regime. The aerodynamic force intensifies the developing of disturbance and makes the jet unstable. Liquid viscous force holds back the growing of disturbance and the makes the jet stable, especially in high liquid velocity regime.


Author(s):  
Y. Liao ◽  
A. T. Sakman ◽  
S. M. Jeng ◽  
M. A. Jog ◽  
M. Benjamin

The performance of liquid fuel atomizer has direct effects on combustion efficiency, pollutant emission and stability. Pressure swirl atomizer, or simplex atomizer, is widely used in liquid fuel combustion devices in aircraft and power generation industry. A computational, experimental, and theoretical study is conducted to predict its performance. The Arbitrary-Lagrangian-Eulerian method with finite volume scheme is employed in the CFD model. Internal flow characteristics of the simplex atomizer as well as its performance parameters such as discharge coefficient, spray angle and film thickness are predicted. A temporal linear stability analysis is performed for cylindrical liquid sheets under 3-D disturbance. The model incorporates swirling velocity component, finite film thickness and radius which are essential features of conical liquid sheets emanating from simplex atomizers. It is observed that the relative velocity between liquid and gas phase, density ratio and surface curvature enhance the interfacial aerodynamic instability. As Weber number and density ratio increase, both the wave growth rate and the unstable wave number range increase. Combination of axial and swirling velocity components is more effective than single axial component for disintegration of liquid sheet. A breakup model for conical liquid sheet is proposed. Combining the breakup model with linear stability analysis, mean drop sizes are predicted. The theoretical results are compared with measurement data and agreement is very good.


2014 ◽  
Vol 694 ◽  
pp. 288-291
Author(s):  
Run Ze Duan ◽  
Zhi Ying Chen ◽  
Li Jun Yang

An electrified liquid sheet injected into a dielectric moving through a viscous gas bounded by two horizontal parallel flat plates of a transverse electric field is investigated with the linear analysis method. The liquid sheet velocity profile and the gas boundary layer thickness are taken into account. The relationship between temporal growth rate and the wave number was obtained using linear stability analysis and solved using the Chebyshev spectral collocation method. The effects of the velocity profile on the stability of the electrified liquid sheet were revealed for both sinuous mode and varicose mode. The results show that the growth rate of the electrified Newtonian liquid is greater than that of corresponding Newtonian one under the same condition, and the growth rate of the sinuous mode is greater than that of the varicose mode. Keywords: instability; planar liquid sheet; velocity profile;spectral method;linear analysis


Sign in / Sign up

Export Citation Format

Share Document