scholarly journals Changes on diametral compression behaviour of compacted marls due to drying

2020 ◽  
Vol 195 ◽  
pp. 03008
Author(s):  
Carmen Covadonga Garcia-Fernandez ◽  
Rafaela Cardoso ◽  
Martina Inmaculada Alvarez-Fernandez ◽  
Celestino Gonzalez-Nicieza

Cracking due to desiccation can compromise the behaviour of earth structures built with compacted clayey soils by promoting water access and consequent volume changes on further wetting. Tensile strength therefore is important to be considered when studying the behaviour of such structures, and in particular its dependence on the degree of saturation or water content. The influence of water content in tensile behaviour of compacted marls was investigated by performing diametral compression tests (Brazilian splitting tests), where axial deformations were measured besides strength. The samples were prepared by compaction at optimum point using standard compaction energy (optimum water content 16%) and then dried by vapour equilibrium to reach water contents between 5% and 16%. The correspondence between water content and suction was done by using the drying branch of the water retention curve, measured using WP4 equipment (Water Dewpoint Potentiometer). Good relationships were found between tensile strength and the water content (and suction). In addition, the study was completed with the analysis of other parameters such as the semi-contact angle created in the loaded area and the stiffness of the material, which also showed changes with water content.

2015 ◽  
Vol 52 (11) ◽  
pp. 1874-1885 ◽  
Author(s):  
Bibiana Narvaez ◽  
Michel Aubertin ◽  
Faustin Saleh-Mbemba

Bending tests were conducted on specimens of unsaturated tailings from three hard rock mines to evaluate their tensile strength. Saturated samples were prepared at an initial water content, w0, of 40% and then naturally dried under ambient conditions to pre-selected degrees of saturation, Sr, which can be related to the corresponding suction using the water retention curve. The basic interpretation of the bending tests results is based on an elastic–brittle behavior. The results show how the tensile strength, σt, of unsaturated tailings varies with water content, w (and Sr). The experimental data are also used to evaluate Young’s modulus in tension, Et, and to estimate the apparent cohesion, capp, as a function of Sr. Predictive equations are also applied to estimate the values of σt of unsaturated tailings using the water retention curve.


2011 ◽  
Vol 382 ◽  
pp. 172-175
Author(s):  
Ren Wei Wu ◽  
Xing Qian Peng ◽  
Li Zhang

As the "Fujian earth-building" have been inscribed by UNESCO in 2008 as World Heritage Site, attentions of protection about the "Fujian earth-building" has getting more and more. This article takes samples of a rammed-earth wall from Yongding earth-buildings and determines the shear strength of the samples with different water content through triaxial compression tests. The influence on shear strength of water content of rammed-earth samples is analyzed. Test results show that the shear strength of rammed-earth has much to do with the water content of the soil, the greater the water content is,the smaller the shear strength is. With water content increasing, cohesion and internal friction angle of rammed-earth were decreases, and its changing trend is of marked characteristic of stage. When water contents of rammed-earth is under some value, its cohesion changes in small ranges; when water contents of rammed-earth is over the value, its cohesion decreases with water content increasing.


2018 ◽  
Vol 55 (9) ◽  
pp. 1313-1333 ◽  
Author(s):  
Penghai Yin ◽  
Sai K. Vanapalli

The influence of tensile strength on the behaviour of cohesionless soils is typically ignored in geotechnical engineering practice. However, the tensile cracking and subsequent failure characteristics of earth structures, such as dams, slopes and embankments, are significantly influenced by the tensile strength. For this reason, a semi-empirical model is proposed for predicting the variation of the tensile strength of unsaturated cohesionless soils with the degree of saturation, using the soil-water characteristic curve (SWCC) as a tool. The proposed model is capable of predicting the tensile strength arising from matric suction and surface tension, which are related to saturated pores and to the air–water interface associated with water bridges around interparticle contacts in unsaturated pores, respectively. Information about (i) the matric suction (ua– uw), the capillary degree of saturation (Sc), and the residual degree of saturation (Sr) derived from the SWCC; (ii) the mean particle size (d50) and the coefficient of uniformity (Cu) from the grain-size distribution curve; (iii) the void ratio (e); and (iv) the friction angle ([Formula: see text]) at low normal stress level is required to employ this model. The proposed model is validated by comparing the prediction results with measured tensile strength of 10 different unsaturated cohesionless soils (including five sandy soils and five silty soils). The proposed model is promising for use in engineering practice applications as it only requires conventional soil properties, alleviating the need for cumbersome experimental studies for the determination of tensile strength of unsaturated cohesionless soils.


2021 ◽  
Author(s):  
Alessandro Fraccica ◽  
Enrique Romero ◽  
Thierry Fourcaud

<p>Soil tensile strength plays an important role in the hydro-mechanical behaviour of earth structures and slopes interacting with the atmosphere. Shrinkage-induced cracking may be generated by drying/wetting cycles, with consequent faster water infiltration from the top of slopes and reduction of the safety factor. Vegetation roots were proven to increase soil shear strength, but less is known about their effects on soil tensile strength. For this purpose, new equipment has been designed and used to induce plant growth in compacted soil samples and to perform uniaxial tensile tests on the reinforced material. The equipment is composed of two cylindrical moulds linked by a soil bridge in which the tensile crack is induced due to geometrical restraints.</p><p>For this study, silty sand was chosen and compacted at a low dry density (ρ<sub>d</sub> = 1.60 Mg/m<sup>3</sup>) and at a water content w = 15%. After compaction, samples were gently poured with water up to a high degree of saturation (S<sub>r</sub> ≈ 0.95) and low suction (s ≈ 1 kPa). Then, six of them were seeded with Cynodon dactilon, adopting fixed seeding density and spacing. Plants were irrigated and let to grow for three months: during this period, suction was monitored by a tensiometer. Seven fallow specimens were prepared following the same procedure, for comparison purposes.</p><p>When ready, samples were dried in a temperature/relative humidity-controlled room and left in the darkness for three hours, to attain and equalise the desired value of initial suction. Finally, the tensile stress was induced on the soil by a displacement rate of 0.080 mm/min. For each test, suction was continuously monitored by a tensiometer while the water content was checked at the beginning and at the end. Moreover, the void ratio and the root volume and area ratio were assessed close to the crack generated, at the end of each test.</p><p>The hydraulic state affected the soil mechanical response upon uniaxial extension: an increase of strength and a more brittle behaviour were observed as suction was increasing. At the same suction, a higher strength was systematically observed in the vegetated soil. In fact, even at very low suction (i.e. s = 1 kPa), vegetation roots induced a considerable increase in soil tensile strength (i.e. 10 kPa). The soil hydraulic state also affected the root failure mechanism. In wet soil, the roots subjected to tension were stretched and pulled-out whereas in dry soil they experienced a more immediate breakage (i.e. in concomitance with the cracking of the surrounding soil). Some preliminary PIV (Particle Image Velocimetry) analyses showed differences among dry/wet and fallow/vegetated soils. Indeed, a more diffuse strain field was observed in vegetated samples, thanks to the redistribution of stresses induced by the roots.</p><p>Results were successfully interpreted by a well-established shear strength criterion for partially saturated soils, considering the degree of saturation, suction and soil microstructure. An increase of the soil shear strength was observed and correlated to the presence of roots and to their geometrical and mechanical features. Moreover, good consistency was detected with results coming from other equipment.</p><p> </p>


2006 ◽  
Vol 43 (10) ◽  
pp. 1042-1060 ◽  
Author(s):  
R Rodríguez

This paper presents the results of hydrogeotechnical characterization tests carried out on the metallurgical waste (MW) from a tailings impoundment located on the terraces of the Moa River, Cuba. Characterization of the MW includes chemical and mineralogical analysis, oedometer tests, triaxial tests, tensile strength tests, determination of the water retention curve, and shrinkage and permeability tests. The MW, which has a grain-size distribution similar to that of a silt, mainly contains iron and heavy metals minerals and has low plasticity. Consolidated undrained triaxial tests on remoulded samples indicate a dilative behaviour, with a decrease in pore-water pressure near failure. The material is susceptible to liquefaction when subjected to a cyclic load in the triaxial test. Hydraulic conductivity, soil stiffness, and compressive and tensile strength of the MW have an important dependence on the degree of saturation and vary significantly during the drying process. The results indicate that, during the drying process, cracks in the MW initiate in quasi-saturated conditions. The cracks increase the hydraulic conductivity by more than one order of magnitude compared with that of intact samples of MW. The main environmental risk with this MW is the possibility of liquefaction under a cyclic load due to an earthquake and the increase in saturated hydraulic conductivity due to desiccation cracks.Key words: desiccation cracks, hydrogeotechnical properties, liquefaction, metallurgical waste, characterization.


Geotecnia ◽  
2016 ◽  
Vol 136 ◽  
pp. 127-142
Author(s):  
Saul Barbosa Guedes ◽  
◽  
<br>Roberto Quental Coutinho ◽  
<br>António Viana da Fonseca ◽  
◽  
...  

2011 ◽  
Vol 10 (2) ◽  
pp. 31 ◽  
Author(s):  
Daisy B Badilla ◽  
Peter A Gostomski ◽  
Maria Lourdes P Dalida

In biofiltration, contaminants in a gas stream are transferred into a biofilm on the filter bed medium and are metabolized by the microorganisms. Water is essential for microbial growth/activity and for transport of nutrients. In both full-scale and laboratory-scale systems, the water content of the medium is difficult to control. In this study, a biofilter, with rigorous water content control and internal gas recycle, was used to determine the influence of the water content on the degradation of toluene. Soil was used as the medium for treating toluene-contaminated air at an average inlet concentration of 263 ppm and a flow rate of 21 ml min-1. Through a water retention curve, gravimetric water content was related to matric potential. Results showed that lowering the water content from 79 to 48% (dry weight) or -20 to -400 cm H2O matric potential decreased the elimination capacity (EC) by 42% (29.8 to 17.3 g m-3h-1). Wetting the medium by increasing the matric potential from -400 to -10 cm H2O increased the elimination capacity to 43.9 g m-3h-1. However, further increase of the matric potential from -10 to -5 cm H2O decreased the elimination capacity by 57% (43.9 to 19.0 g m-3 h-1). Thus, this study suggests the soil water content should be controlled at about 96% (dry weight) or a matric potential of -10 cm H2O and the maximum elimination capacity is restricted to a narrow water content/matric potential. This narrow range impacts on the operation of full-scale biofilters as traditional techniques for water content control would make maintaining this range difficult.


2019 ◽  
Vol 92 ◽  
pp. 15008 ◽  
Author(s):  
C. Jayasundara ◽  
J. Kodikara ◽  
A. N. Zhou

Unsaturated soils exhibit various complex behaviours compared to saturated soils, such as collapse upon wetting. Therefore, understanding the response of unsaturated soils under general field conditions is essential for the design and construction of safe and economical geotechnical engineering structures. This research is based on the Monash-Peradeniya-Kodikara (MPK) framework proposed by Kodikara [1] for unsaturated compacted soils, which provides a direct link to the traditional compaction loaded curves and constant water content loading experiments. Kodikara [1] named the loaded compaction surface the loading wetting state boundary surface (LWSBS) and validated the model for a combination of loading and wetting stress paths. However, the experimental validation of the yield surface after drying stress paths was not addressed in the original paper. This paper reports the results of drying stress path tests carried out within the specific volume (v),specific moisture ratio (vw) and mean net stress (p) space of the MPK model, and observations suggest that the yield surface is unique after drying stress paths. Mathematical equations for the volumetric behaviour of unsaturated soils are derived using the constant degree of saturation hyperlines derived from constant water content testing, as this enables direct coupling with the soil water retention curve. Finally, the volumetric equations are validated based on the available experimental data.


Sign in / Sign up

Export Citation Format

Share Document