Characterization of Environmental Pollutants in Sediment Collected during Street Sweeping Operations to Evaluate its Potential for Reuse

2019 ◽  
Vol 145 (2) ◽  
pp. 04018141 ◽  
Author(s):  
Lewis N. Lloyd ◽  
G. Michael Fitch ◽  
Tony S. Singh ◽  
James A. Smith
2013 ◽  
Vol 97 (11) ◽  
pp. 5043-5053 ◽  
Author(s):  
Rabea Schlüter ◽  
Ramona Lippmann ◽  
Elke Hammer ◽  
Manuela Gesell Salazar ◽  
Frieder Schauer

2021 ◽  
Author(s):  
Omid Moradi ◽  
Samira Mhdavi ◽  
Sajjad Sedaghat

Abstract Today, environmental pollutants pose a threat to human societies and all living organisms, which is why they have attracted the attention of environmental researchers. In this study, in order to remove pharmaceutical contaminants Naproxen and Amoxicillin from aqueous media with SiO2 nanoparticles based on Agar and Chitosan was investigated. The study of structural properties, physical and chemical characterization of synthesized nanocomposite was investigated by FTIR, XRD, TEM, FE-SEM, DLS and EDX analyzes. In addition, the role of parameters affecting the removal of pharmaceutical contaminants such as solution pH, contact time, contaminant concentration and temperature were studied. Nanocomposites prepared from Agar and Chitosan showed good performance in absorbing naproxen and amoxicillin. According to the studies performed to remove naproxen, the max adsorption efficiency was obtained at a concentration of 20 mg/l with an absorbent dose of 0.05 g and a pH of 8 and at an optimum temperature of 25 °C and 99% in 15 min. Also, for amoxicillin with nanocomposite prepared with an initial concentration of 20 mg/l and an adsorbent dose of 0.05 g, a time of 10 min, a temperature of 25 °C and a pH of 8, the max removal efficiency of 91.15% was obtained.


RSC Advances ◽  
2016 ◽  
Vol 6 (67) ◽  
pp. 62916-62922 ◽  
Author(s):  
Hossein Ghafuri ◽  
Shirin Rahmani ◽  
Rahmatollah Rahimi ◽  
Esmaeel Mohammadiyan

5,10,15,20-Tetrakis-(4-hydroxymethylphenyl)porphyrin (THMP), metalloporphyrin [(Co(iii)THMP)] and its nanocomposites with graphene oxide (GO–CoTHMP) were synthesized for the first time.


2013 ◽  
Vol 19 (S4) ◽  
pp. 87-88 ◽  
Author(s):  
S. Galante-Oliveira ◽  
R. Marçal ◽  
F. Guimarães ◽  
J. Machado ◽  
C.M. Barroso

Gastropods statoliths are biogenic structures of CaCO3, analogous to fish otoliths. Their application in sclerochronology is recent and may be advantageous comparing to the most traditional organisms used hitherto. Moreover, since elements bind within calcified structures, statoliths theoretically incorporate chemical information from the surrounding environment over time. So, besides being used for age estimation and growth studies, statoliths elemental fingerprinting is recognized as natural tag to track larval dispersal and may also be considered as a potential marker of environmental change and/or pollution. However there is a lack of information on the elemental composition of adult gastropod statoliths. Here we characterize Nassariusreticulatus (Gastropoda: Caenogastropoda) statoliths elemental composition by electron microprobe analysis (EMPA).One statolith from each of 3 adults was prepared for EMPA (Figure 1) and showed the same structural pattern: a nucleus circled by a metamorphic ring and, in addition to this core, 4 other rings delineating 5 increments (Figure 1F). General composition was assessed by Energy and Wavelength Dispersive Spectroscopy revealing C, Ca, O, Sr, Na, S and Mg as the most representative elements. These were then quantified in 3 points per increment. Carbon was not determined since surfaces were C-coated and the amount of oxides of Ca, Sr, Na, S and Mg was estimated from the valence. In addition, Ba – trace element in statoliths of some gastropods larvae – and Al, Cu, Hg, Sn – known as environmental pollutants – were also sought in one of the statoliths. For such, mean values for Ca, Sr, Na, S, Mg and O were set as the sample matrix. Standards and mean detection limits by element and statolith are indicated in Table 1.Concentrations of Ca, O, Na, Sr and S varied between 3.7x105-4.2x105, 1.5x105-1.7x105, 2.5x103-6.1x103, 1.3x103-8.9x103 and 4.7x102-1.3x103 ppm, respectively; Mg, which was not always detected, ranged from 2.0x102-8.6x102 ppm. No significant differences in these elements mean concentrations were found between increments, except Na in one statolith between increments 1 and 5 (higher at the edge; Dunn’s test s=2.014, p>0.05). Thus the general elemental composition is nearly constant throughout lifespan (i.e. along statoliths radiuses). Regarding trace elements: Sn was never detected; Al and Hg were at 22.2% of the punctual analyses conducted while Cu was at 66.7% and Ba at 88.9%. Concentrations of Al, Hg, Cu and Ba varied between 55-71, 176-180, 183-302 and 647-969 ppm, respectively.EMPA proved to be a useful technique in sclerochronology, allowing the characterization of the overall composition of gastropods statoliths and the quantification of elements in specific locations with high resolution.This work was supported by the Portuguese Foundation for Science and Technology (FCT) through the grant SFRH/BPD/70368/2010.


2020 ◽  
Vol 72 (11-12) ◽  
pp. 1900148
Author(s):  
Jing Li ◽  
Andrew Riley ◽  
Lumei Pu ◽  
Haitao Long ◽  
Zhihai Li

2014 ◽  
Vol 809-810 ◽  
pp. 82-87
Author(s):  
Xin Liu ◽  
Chang Ping Wei ◽  
Li Dan Dong ◽  
Sheng Nan Zhao ◽  
Jing Li ◽  
...  

There are many kinds of preparation methods of silver nanoparticles ,such as chemical method, physical method plant reduction method and microbial enzyme and so on. The most common method is to use chemical method for reduction. But this method needs to add some chemicals that will produce environmental pollutants. The production consumption will be increased. High quality nanometer silver needing low cost and according with environment protection needs was prepared by using homogeneous precipitation that contains no auxiliary reagent and high temperature pyrolysis in this paper. Experimental results that this method is very effective.


2017 ◽  
Vol 84 (2) ◽  
Author(s):  
Tomas Buryska ◽  
Petra Babkova ◽  
Ondrej Vavra ◽  
Jiri Damborsky ◽  
Zbynek Prokop

ABSTRACTThe haloalkane dehalogenase enzyme DmmA was identified by marine metagenomic screening. Determination of its crystal structure revealed an unusually large active site compared to those of previously characterized haloalkane dehalogenases. Here we present a biochemical characterization of this interesting enzyme with emphasis on its structure-function relationships. DmmA exhibited an exceptionally broad substrate specificity and degraded several halogenated environmental pollutants that are resistant to other members of this enzyme family. In addition to having this unique substrate specificity, the enzyme was highly tolerant to organic cosolvents such as dimethyl sulfoxide, methanol, and acetone. Its broad substrate specificity, high overexpression yield (200 mg of protein per liter of cultivation medium; 50% of total protein), good tolerance to organic cosolvents, and a broad pH range make DmmA an attractive biocatalyst for various biotechnological applications.IMPORTANCEWe present a thorough biochemical characterization of the haloalkane dehalogenase DmmA from a marine metagenome. This enzyme with an unusually large active site shows remarkably broad substrate specificity, high overexpression, significant tolerance to organic cosolvents, and activity under a broad range of pH conditions. DmmA is an attractive catalyst for sustainable biotechnology applications, e.g., biocatalysis, biosensing, and biodegradation of halogenated pollutants. We also report its ability to convert multiple halogenated compounds to corresponding polyalcohols.


Reproduction ◽  
2006 ◽  
Vol 132 (1) ◽  
pp. 11-19 ◽  
Author(s):  
Zuping He ◽  
Wai-Yee Chan ◽  
Martin Dym

Male infertility is now a major reproductive health problem because of an increasing number of environmental pollutants and chemicals, which eventually result in gene mutations. Genetic alterations caused by environmental factors account for a significant percentage of male infertility. Microarray technology is a powerful tool capable of measuring simultaneously the expression of thousands of genes expressed in a single sample. Eventually, advances in genetic technology will allow for the diagnosis of patients with male infertility due to congenital reasons or environmental factors. Since its introduction in 1994, microarray technology has made significant advances in the identification and characterization of novel or known genes possibly correlated with male infertility in mice, as well as in humans. This provides a rational basis for the application of microarray to establishing molecular signatures for the diagnosis and gene therapy targets of male infertility. In this review, the differential gene expression patterns characterized by microarray in germ and somatic cells at different steps of development or in response to stimuli, as well as a number of novel or known genes identified to be associated with male infertility in mice and humans, are addressed. Moreover, issues pertaining to measurement reproducibility are highlighted for the application of microarray data to male infertility.


Sign in / Sign up

Export Citation Format

Share Document