Influence of Soft Soil Shear Strength on the Seismic Response of Concrete Buildings Considering Soil-Structure Interaction

2016 ◽  
Author(s):  
Ruoshi Xu ◽  
Behzad Fatahi ◽  
Aslan S. Hokmabadi
2020 ◽  
Vol 10 (23) ◽  
pp. 8357
Author(s):  
Ibrahim Oz ◽  
Sevket Murat Senel ◽  
Mehmet Palanci ◽  
Ali Kalkan

Reconnaissance studies performed after destructive earthquakes have shown that seismic performance of existing buildings, especially constructed on weak soils, is significantly low. This situation implies the negative effects of soil-structure interaction on the seismic performance of buildings. In order to investigate these effects, 40 existing buildings from Turkey were selected and nonlinear models were constructed by considering fixed-base and stiff, moderate and soft soil conditions. Buildings designed before and after Turkish Earthquake code of 1998 were grouped as old and new buildings, respectively. Different soil conditions classified according to shear wave velocities were reflected by using substructure method. Inelastic deformation demands were obtained by using nonlinear time history analysis and 20 real acceleration records selected from major earthquakes were used. The results have shown that soil-structure interaction, especially in soft soil cases, significantly affects the seismic response of old buildings. The most significant increase in drift demands occurred in first stories and the results corresponding to fixed-base, stiff and moderate cases are closer to each other with respect to soft soil cases. Distribution of results has indicated that effect of soil-structure interaction on the seismic performance of new buildings is limited with respect to old buildings.


2016 ◽  
Vol 16 (08) ◽  
pp. 1550043 ◽  
Author(s):  
Aslan S. Hokmabadi ◽  
Behzad Fatahi

In selecting the type of foundation best suited for mid-rise buildings in high risk seismic zones, design engineers may consider that a shallow foundation, a pile foundation, or a pile-raft foundation can best carry the static and dynamic loads. However, different types of foundations behave differently during earthquakes, depending on the soil–structure interaction (SSI) where the properties of the in situ soil and type of foundation change the dynamic characteristics (natural frequency and damping) of the soil–foundation–structure system. In order to investigate the different characteristics of SSI and its influence on the seismic response of building frames, a 3D numerical model of a 15-storey full-scale (prototype) structure was simulated with four different types of foundations: (i) A fixed-based structure that excludes the SSI, (ii) a structure supported by a shallow foundation, (iii) a structure supported by a pile-raft foundation in soft soil and (iv) a structure supported by a floating (frictional) pile foundation in soft soil. Finite difference analyzes with FLAC3D were then conducted using real earthquake records that incorporated material (soil and superstructure) and geometric (uplifting, gapping and [Formula: see text] effects) nonlinearities. The 3D numerical modeling procedure had previously been verified against experimental shaking table tests conducted by the authors. The results are then presented and compared in terms of soil amplification, shear force distribution and rocking of the superstructure, including its lateral deformation and drift. The results showed that the type of foundation is a major contributor to the seismic response of buildings with SSI and should therefore be given careful consideration in order to ensure a safe and cost effective design.


Author(s):  
Toshio Iwasaki ◽  
Kazuhiko Kawashima

In analyzing seismic behaviour of highway bridges constructed on soft soil deposits, it is important to take account of soil-structure interaction effects. In this paper, seismic response of a bridge pier-foundation is investigated based on earthquake acceleration records measured simultaneously on the pier crest and on the ground surface near that bridge. Four motions were used in the analysis, i.e., two were induced by two earthquakes with magnitudes of 7.5 and 6.6, respectively; and two by their aftershocks. In the former two earthquakes, the maximum accelerations were 186 and 438 gals on the ground surface, and 310 and 230 gals on the pier top, respectively. Analyses of frequency characteristics of the motions showed that the predominant frequencies of pier-foundation were always approximately identical with the fundamental natural frequency of the subsoil. Analyses of micro-tremors measured at the sites revealed that the natural frequency of the pier-foundation system is higher than the fundamental natural frequency of the subsoil. Analytical models were formulated to calculate the seismic response of the pier-foundation assuming the subsoil and pier-foundation to be a shear column model with an equivalent linear shear modulus and an elastically supported beam on the subsoil, respectively. Bedrock motions were computed from the measured ground surface motions and then applied to the bedrock of the analytical model. The seismic responses of pier-foundation were thus calculated and compared with the measured records giving a good agreement.


2012 ◽  
Vol 256-259 ◽  
pp. 2106-2110
Author(s):  
Xin Liang Jiang ◽  
Yue Li

An analytical approach based on branch mode method is formulated in this paper to study the dynamic response of eccentric structure considering soil-structure interaction The superstructure branch and foundation soil branch are coupled through mode aggregation procedure. The computational scale of system equations decreases to an acceptable level. Sample analysis indicate that the seismic response of eccentric structure increases first and then decreases with the decreasing of stiffness of soil-foundation system, which is affected by the inertia effect of foundation branch. For the soft soil case, the influence of SSI effect is more intensive that the trends of transfer function curves are fundamentally changed comparing to the results of other foundation conditions.


2014 ◽  
Vol 17 (10) ◽  
pp. 1387-1402 ◽  
Author(s):  
Behzad Fatahi ◽  
S. Hamid Reza Tabatabaiefar

In this study, the effects of Plasticity Index (PI) variation on the seismic response of mid-rise building frames resting on soft soil deposits are investigated. To achieve this goal, three structural models including 5, 10, and 15 storey buildings are simulated in conjunction with a clayey soil representing soil class Ee according to the classification of AS1170.4–2007 (Earthquake actions in Australia) and then varying the Plasticity Index. Structural sections of the selected frames were designed according to AS3600–2009 (Australian Standard for Concrete Structures) after undertaking dynamic analysis under the influence of four different earthquake ground motions. The frame sections are modelled and analysed, employing finite difference method adopting FLAC 2D software under two different boundary conditions: (i) fixed base (no Soil-Structure Interaction), and (ii) flexible base considering soil-structure interaction. Fully nonlinear dynamic analyses under the influence of different earthquake records are conducted and the results in terms of maximum lateral displacements and inter-storey drifts for the above mentioned boundary conditions are obtained, compared, and discussed. Base on the results of the numerical investigations, it becomes apparent that as the Plasticity Index of the subsoil increases, the base shears of mid-rise building frames resting on soft soil deposits increase, while the lateral deflections and corresponding inter-storey drifts decrease. It is concluded that reduction of the Plasticity Index could noticeably amplify the effects of soil-structure interaction on the seismic response of mid-rise building frames.


2013 ◽  
Vol 663 ◽  
pp. 87-91
Author(s):  
Ying Bo Pang

As an effective way of passive damping, isolation technology has been widely used in all types of building structures. Currently, for its theoretical analysis, it usually follows the rigid foundation assumption and ignores soil-structure interaction, which results in calculation results distortion in conducting seismic response analysis. In this paper, three-dimensional finite element method is used to establish finite element analysis model of large chassis single-tower base isolation structure which considers and do not consider soil-structure interaction. The calculation results show that: after considering soil-structure interaction, the dynamic characteristics of the isolation structure, and seismic response are subject to varying degrees of impact.


2014 ◽  
Vol 539 ◽  
pp. 731-735 ◽  
Author(s):  
Yu Chen

In this thesis, based on the design of a 140+90m span unusual single tower and single cable plane cable-stayed bridge, free vibration characteristics and seismic response are investigated; three dimensional finite element models of a single tower cable-stayed bridge with and without the pile-soil-structure interaction are established respectively by utilizing finite element software MIDAS/CIVIL, seismic response of Response spectrum and Earthquake schedule are analyzed respectively and compared. By the comparison of the data analysis, for small stiffness span cable-stayed bridge, the pile-soil-structure interaction can not be ignored with calculation and analysis of seismic response.


Sign in / Sign up

Export Citation Format

Share Document