Continuous change of surface magnetization direction from perpendicular to planar in soft magnetic CoP multilayers

Iron-base alloys containing 8-11 wt.% Si, 4-8 wt.% Al, known as “Sendust” alloys, show excellent soft magnetic properties. These magnetic properties are strongly dependent on heat treatment conditions, especially on the quenching temperature following annealing. But little has been known about the microstructure and the Fe-Si-Al ternary phase diagram has not been established. In the present investigation, transmission electron microscopy (TEM) has been used to study the microstructure in a Sendust alloy as a function of temperature.An Fe-9.34 wt.% Si-5.34 wt.% Al (approximately Fe3Si0.6Al0.4) alloy was prepared by vacuum induction melting, and homogenized at 1,200°C for 5 hrs. Specimens were heat-treated in a vertical tube furnace in air, and the temperature was controlled to an accuracy of ±2°C. Thin foils for TEM observation were prepared by jet polishing using a mixture of perchloric acid 15% and acetic acid 85% at 10V and ∼13°C. Electron microscopy was performed using a Philips EM 301 microscope.

Download Full-text

Dynamic low-dose electron diffraction and imaging of phase transitions in polymers

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100150289 ◽

1993 ◽

Vol 51 ◽

pp. 890-891

Author(s):

David C. Martin ◽

Jun Liao

Keyword(s):

Crystal Structure ◽

Phase Transition ◽

Electron Diffraction ◽

Low Dose ◽

Dark Field ◽

Continuous Change ◽

Selected Area Electron Diffraction ◽

Resolution Electron ◽

Chain Axis ◽

High Resolution Electron Micrographs

By careful control of the electron beam it is possible to simultaneously induce and observe the phase transformation from monomer to polymer in certain solid-state polymcrizable diacetylenes. The continuous change in the crystal structure from DCHD diacetylene monomer (a=1.76 nm, b=1.36 nm, c=0.455 nm, γ=94 degrees, P2l/c) to polymer (a=1.74 nm, b=1.29 nm, c=0.49 nm, γ=108 degrees, P2l/c) occurs at a characteristic dose (10−4C/cm2) which is five orders of magnitude smaller than the critical end point dose (20 C/cm2). Previously we discussed the progress of this phase transition primarily as observed down the [001] zone (the chain axis direction). Here we report on the associated changes of the dark field (DF) images and selected area electron diffraction (SAED) patterns of the crystals as observed from the side (i.e., in the [hk0] zones).High resolution electron micrographs (HREM), DF images, and SAED patterns were obtained on a JEOL 4000 EX HREM operating at 400 kV.

Download Full-text

Spin-polarized Scanning Electron Microscopy

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100176976 ◽

1990 ◽

Vol 48 (4) ◽

pp. 768-769

Author(s):

Kazuyuki Koike ◽

Hideo Matsuyama

Keyword(s):

Electron Microscopy ◽

Scanning Electron Microscopy ◽

High Speed ◽

Magnetic Thin Films ◽

Electron Spin Polarization ◽

Acquisition Time ◽

Magnetization Direction ◽

Spin Polarized ◽

Conventional Methods ◽

Scanning Electron

Spin-polarized scanning electron microscopy (spin SEM), where the secondary electron spin polarization is used as the image signal, is a novel technique for magnetic domain observation. Since its first development by Koike and Hayakawa in 1984, several laboratories have extensively studied this technique and have greatly improved its capability for data extraction and its range of applications. This paper reviews the progress over the last few years.Almost all the high expectations initially held for spin SEM have been realized. A spatial resolution of several hundreds angstroms has been attained, which is nearly one order of magnitude higher than that of conventional methods for thick samples. Quantitative analysis of magnetization direction has been performed more easily than with conventional methods. Domain observation of the surface of three-dimensional samples has been confirmed to be possible. One of the drawbacks, a long image acquisition time, has been eased by combining highspeed image-signal processing with high speed scanning, although at the cost of image quality. By using spin SEM, the magnetic structure of a 180 degrees surface Neel wall, magnetic thin films, multilayered films, magnetic discs, etc., have been investigated.

Download Full-text

Soft Magnetic Properties of Fe-Ti-N Alloy Thin Films

Journal of the Magnetics Society of Japan ◽

10.3379/jmsjmag.22.186 ◽

1998 ◽

Vol 22 (4_1) ◽

pp. 186-189

Author(s):

M. Matsumoto ◽

A. Morisako ◽

Y. Mutoh

Keyword(s):

Thin Films ◽

Magnetic Properties ◽

Soft Magnetic Properties ◽

Soft Magnetic

Download Full-text

HASTANELERİN HİZMET KALİTESİNİN HASTA TATMİN ÖLÇEĞİ İLE ÖLÇÜLMESİ: KARABÜK DEVLET HASTANESİNDE YATAN HASTALAR ÜZERİNDE BİR ARAŞTIRMA THE MEASUREMENT SERVICE QUALITY OF THE HOSPITALS BY THE PATIENT SCALE: A RESEARCH ON THE PATIENTS IN KARABUK STATE HOSP

Business And Management Studies An International Journal ◽

10.15295/bmij.v1i1.20 ◽

2013 ◽

Vol 1 (1) ◽

pp. 100

Author(s):

Selçuk Yurtsever

Keyword(s):

Patient Satisfaction ◽

Health Services ◽

Literature Review ◽

Private Sector ◽

State Hospital ◽

Continuous Change ◽

Satisfaction Scale ◽

The World ◽

Main Factors

It has been known that both in the world and in Turkey a continuous change has been experienced in the provision of health services in recent years. In this sense by adopting the customer(client) focused approach of either public or private sector hospitals; it has been seen that they are in the struggle for presenting a right, fast, trustuble, comfy service. The purpose of this research is to measure the satisfaction degree, expectations and perceptions of the patients in Karabük State Hospital through comparison. In this context, the patient satisfaction scale which has been developed as a result of literature review has been used and by this scale it has been tried to measure the satisfaction levels of the patients in terms of material and human factors which are the two main factors of the service that was presented. In the study, with the scales of Servqual and 0-100 Points together, in the part of the analysis MANOVA have been used. The expectations and the perceptions of the patient has been compared first by generally and then by separating to different groups according to the various criterias and in thisway it has been tried to be measured their satisfaction levels. According to the results that were obtained, although, the satisfaction levels of the patients who have taken service from Karabük State Hospital are high in terms of thedoctors and the nurses; it has been reached to the result that their satisfaction levels are low in terms of the materials that have been used at the presenting of the service and the management.

Download Full-text