scholarly journals Impedance probe to measure local gas volume fraction and bubble velocity in a bubbly liquid

2003 ◽  
Vol 74 (5) ◽  
pp. 2817-2827 ◽  
Author(s):  
R. Zenit ◽  
D. L. Koch ◽  
A. S. Sangani
Author(s):  
Sahand Pirouzpanah ◽  
Gerald L. Morrison

Impedance probes are used by the oil and gas industry to investigate multiphase flow behavior. In this study, an impedance needle probe has been developed to measure the local and temporal gas volume fraction in conductive and non-conductive process fluid. Measuring both resistance and capacitance enables this probe to be functional in both types of fluids and facilitates the measurement of local bubble velocity. Two 1/32″ insulated brass (alloy 260) rods with bare tips protrude into the flow. The gap between the electrodes is designed to be 0.085″. The probe can measure directional bubble velocity by measuring duration of signal gradient from liquid to gas transition. For a known distance between electrodes and by the measured time, directional bubble velocity in the direction of the connecting line between electrodes can be measured. The ratio between the time interval when signal is non-zero to the total time represents the temporal gas volume fraction.


2014 ◽  
Vol 763 ◽  
pp. 254-285 ◽  
Author(s):  
Damien Colombet ◽  
Dominique Legendre ◽  
Frédéric Risso ◽  
Arnaud Cockx ◽  
Pascal Guiraud

AbstractThe present work focuses on the collective effect on both bubble dynamics and mass transfer in a dense homogeneous bubble swarm for gas volume fractions${\it\alpha}$up to 30 %. The experimental investigation is carried out with air bubbles rising in a square column filled with water. Bubble size and shape are determined by means of a high-speed camera equipped with a telecentric lens. Gas volume fraction and bubble velocity are measured by using a dual-tip optical probe. The combination of these two techniques allows us to determine the interfacial area between the gas and the liquid. The transfer of oxygen from the bubbles to the water is measured from the time evolution of the concentration of oxygen dissolved in water, which is obtained by means of the gassing-out method. Concerning the bubble dynamics, the average vertical velocity is observed to decrease with${\it\alpha}$in agreement with previous experimental and numerical investigations, while the bubble agitation turns out to be weakly dependent on ${\it\alpha}$. Concerning mass transfer, the Sherwood number is found to be very close to that of a single bubble rising at the same Reynolds number, provided the latter is based on the average vertical bubble velocity, which accounts for the effect of the gas volume fraction on the bubble rise velocity. This conclusion is valid for situations where the diffusion coefficient of the gas in the liquid is very low (high Péclet number) and the dissolved gas is well mixed at the scale of the bubble. It is understood by considering that the transfer occurs at the front part of the bubbles through a diffusion layer which is very thin compared with all flow length scales and where the flow remains similar to that of a single rising bubble.


2012 ◽  
Vol 704 ◽  
pp. 211-231 ◽  
Author(s):  
Emmanuella Bouche ◽  
Véronique Roig ◽  
Frédéric Risso ◽  
Anne-Marie Billet

AbstractThe spatial distribution, the velocity statistics and the dispersion of the gas phase have been investigated experimentally in a homogeneous swarm of bubbles confined within a thin gap. In the considered flow regime, the bubbles rise on oscillatory paths while keeping a constant shape. They are followed by unstable wakes which are strongly attenuated due to wall friction. According to the direction that is considered, the physical mechanisms are totally different. In the vertical direction, the entrainment by the wakes controls the bubble agitation, causing the velocity variance and the dispersion coefficient to increase almost linearly with the gas volume fraction. In the horizontal direction, path oscillations are the major cause of bubble agitation, leading to a constant velocity variance. The horizontal dispersion, which is lower than that in the vertical direction, is again observed to increase almost linearly with the gas volume fraction. It is however not directly due to regular path oscillations, which are unable to generate a net deviation over a whole period, but results from bubble interactions which cause a loss of the bubble velocity time correlation.


2021 ◽  
Vol 263 (5) ◽  
pp. 1008-1018
Author(s):  
Sanae Serbout ◽  
Laurent Maxit ◽  
Frédéric Michel

The characterization of the presence of bubbles in industrial fluid circuits may be extremely important for many safety issuses. It is well known that the acoustic properties of liquids can be drastically modified by a small amount of gaz content in the liquid. At sufficiently low frequencies, the speed of sound depends primarily on the gas volume fraction. The variation of the gas fraction may then induce some variations in the vibroacoustic behavior of the pipe transporting the liquid. Analysis of the pipe vibrations can then help in the monitoring of the bubble presence. In such a context, the aim of this study is to show how the the presence of bubbles in the liquid could affect the resonance frequencies of the pipe. A numerical vibroacoustical model has been developed to predict the vibroacoustical behavior of a stiffened cylindrical shell filled with a bubbly liquid exhibiting low frequency resonances. The model, experimentally verified with a well-characterized bubbly liquid, is then used to analyse the frequency shifts of the shell resonances in function of the bubble. Keywords : pipe, heavy fluid, numerical modelling, circumferential admittance approach, cylindrical shell, resonance frequency, void fraction


Processes ◽  
2021 ◽  
Vol 9 (4) ◽  
pp. 650
Author(s):  
Guangtai Shi ◽  
Dandan Yan ◽  
Xiaobing Liu ◽  
Yexiang Xiao ◽  
Zekui Shu

The gas volume fraction (GVF) often changes from time to time in a multiphase pump, causing the power capability of the pump to be increasingly affected. In the purpose of revealing the pressure load characteristics of the multiphase pump impeller blade with the gas-liquid two-phase case, firstly, a numerical simulation which uses the SST k-ω turbulence model is verified with an experiment. Then, the computational fluid dynamics (CFD) software is employed to investigate the variation characteristics of static pressure and pressure load of the multiphase pump impeller blade under the diverse inlet gas volume fractions (IGVFs) and flow rates. The results show that the effect of IGVF on the head and hydraulic efficiency at a small flow rate is obviously less than that at design and large flow rates. The static pressure on the blade pressure side (PS) is scarcely affected by the IGVF. However, the IGVF has an evident effect on the static pressure on the impeller blade suction side (SS). Moreover, the pump power capability is descended by degrees as the IGVF increases, and it is also descended with the increase of the flow rate at the impeller inlet. Simultaneously, under the same IGVF, with the increase of the flow rate, the peak value of the pressure load begins to gradually move toward the outlet and its value from hub to shroud is increased. The research results have important theoretical significance for improving the power capability of the multiphase pump impeller.


2014 ◽  
Vol 136 (7) ◽  
Author(s):  
Sowmitra Singh ◽  
Tiffany Fourmeau ◽  
Jin-Keun Choi ◽  
Georges L. Chahine

This paper addresses the concept of thrust augmentation through bubble injection into an expanding-contracting nozzle with a throat. The presence of a throat in an expanding-contracting nozzle can result in flow transition from the subsonic regime to the supersonic regime (choked conditions) for a bubbly mixture flow, which may result in a substantial increase in jet thrust. This increase would primarily arise from the fact that the injected gas bubbles expand drastically in the supersonic region of the flow. In the current work, an analytical 1D model is developed to capture choked bubbly flow in an expanding-contracting nozzle with a throat. The study provides analytical and numerical support to analytical observations and serves as a design tool for nozzle geometries that can achieve efficient choked bubbly flows through nozzles. Starting from the 1D mixture continuity and momentum equations, along with an equation of state for the bubbly mixture, expressions for mixture velocity and gas volume fraction were derived. Starting with a fixed geometry and an imposed upstream pressure for a choked flow in the nozzle, the derived expressions were iteratively solved to obtain the exit pressures and velocities for different injected gas volume fractions. The variation of thrust enhancement with the injected gas volume fraction was also studied. Additionally, the geometric parameters were varied (area of the exit, area of the throat) to understand the influence of the nozzle geometry on the thrust enhancement and on the flow conditions at the inlet. This parametric study provides a performance map that can be used to design a bubble augmented waterjet propulsor, which can achieve and exploit supersonic flow. It was found that the optimum geometry for choked flows, unlike the optimum geometry under purely subsonic flows, had a dependence on the injected gas volume fraction. Furthermore, for the same injected gas volume fraction the optimum geometry for choked flows resulted in greater thrust enhancement compared to the optimum geometry for purely subsonic flows.


2021 ◽  
Vol 15 ◽  
pp. 223-232
Author(s):  
Sharul Sham Dol ◽  
Niraj Baxi ◽  
Mior Azman Meor Said

By introducing a multiphase twin screw pump as an artificial lifting device inside the well tubing (downhole) for wet gas compression application; i.e. gas volume fraction (GVF) higher than 95%, the unproductive or commercially unattractive gas wells can be revived and made commercially productive once again. Above strategy provides energy industry with an invaluable option to significantly reduce greenhouse gas emissions by reviving gas production from already existing infrastructure thereby reducing new exploratory and development efforts. At the same time above strategy enables energy industry to meet society’s demand for affordable energy throughout the critical energy transition from predominantly fossil fuels based resources to hybrid energy system of renewables and gas. This paper summarizes the research activities related to the applications involving multiphase twin screw pump for gas volume fraction (GVF) higher than 95% and outlines the opportunity that this new frontier of multiphase fluid research provides. By developing an understanding and quantifying the factors that influence volumetric efficiency of the multiphase twin screw pump, the novel concept of productivity improvement by a downhole wet gas compression using above technology can be made practicable and commercially more attractive than other production improvement strategies available today. Review and evaluation of the results of mathematical and experimental models for multiphase twin screw pump for applications with GVF of more than 95% has provided valuable insights in to multiphase physics in the gap leakage domains of pump and this increases confidence that novel theoretical concept of downhole wet gas compression using multiphase twin screw pump that is described in this paper, is practically achievable through further research and improvements.


2019 ◽  
Author(s):  
Luis E. Granado ◽  
Antonio Drago ◽  
Faycal Smail ◽  
Abdelhak Khalfaoui ◽  
Giovanni Fidanza ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document