Recently, supercapacitors have attracted a tremendous amount of attention as energy-storage devices due to their high-power density, fast charge–discharge ability, excellent reversibility, and long cycling life. In this research work, we demonstrate a laser scribed super capacitor based on polyimide (PI) substrate for the storage of electrical energy. PI substrate of thickness 200μm and area 1cm × 1cm was reduced by a laser engraver with a 450 nm wavelength in the form of stackable supercapacitor electrodes. Although, PI itself exhibits non-conductive behavior; however, by laser irradiation we change the surface properties of PI and reduce its resistance. The chemical property of irradiated PI was characterized with XRD where the carbon peak was observed at 2*theta = 25.44, which confirms the reduction of PI material in to a graphene-like substance. The electrical conductivity was analyzed with a probe station and observed to be 1.6mS. Two conductive regions were assembled into a capacitor device by sandwiching a PVA/H3PO4 electrolyte in between. During the charging and discharging characterization of the capacitor device, current density was observed to be 1.5mA/cm2. Capacitance versus voltage analysis was carried out and the device showed 75mF/cm2 against a voltage sweep of ±2V. The galvanostatic charging and discharging curve shows a symmetric behavior with respect to time exhibiting the stability and durability of the device.
Characterization of Qatar’s surface carbonates for CO2 capture and thermochemical energy storage
