Electrical properties of binary mixtures of amino silicone oil and methyl iso butyl ketone

2018 ◽  
Author(s):  
K. N. Shah ◽  
V. A. Rana ◽  
H. P. Vankar
Keyword(s):  
Electrical Properties ◽  
Binary Mixtures ◽  
Silicone Oil ◽  
Amino Silicone ◽  
Butyl Ketone

Preparation and Properties Fluoralkylpolysiloxane Modified Polyurethane Films

2009 ◽  
Vol 620-622 ◽  
pp. 741-744 ◽  
Author(s):  
Rui Weng ◽  
Chong Rui Wang ◽  
Lian Meng Zhang ◽  
Shui Ping Wang
Keyword(s):  
Contact Angle ◽  
Water Contact Angle ◽  
Silicone Oil ◽  
Soft Segment ◽  
High Water ◽  
Water Contact ◽  
Sulfuryl Fluoride ◽  
Low Surface Energy ◽  
End Capping ◽  
Amino Silicone

Fluoralkylpolysiloxane modified Polyurethane (FSPU) films with high water contact angle (CA) were prepared. fluoralkylpolysiloxane was obtained using perfluoro octyl sulfuryl fluoride and terminal amino-silicone oil as reactants. Then, the isocyanate end capped PU prepolymer was synthesized by reacting isocyanate with a soft segment mixed by active amino-end-capping fluoralkylpolysiloxane and polyether glycol. The fluoralkylpolysiloxane modified PU films were obtained after the PU prepolymer was cured by 3,3 '- dichloro -4,4' – amino - diphenyl methane (MOCA). The results showed that the modified polyurethane with 10% (mass fraction) PFATPS had a good compatibility, low surface energy, surface water contact angle and surface oil contact angle was improved by 49° and 37° respectively, and heat resistance, water resistance was apparently improved.

Electric Field Alignment of Nanofibrillated Cellulose (NFC) in Silicone Oil: Impact on Electrical Properties

2014 ◽  
Vol 6 (12) ◽  
pp. 9418-9425 ◽  
Author(s):  
Amal Kadimi ◽  
Karima Benhamou ◽  
Zoubeida Ounaies ◽  
Albert Magnin ◽  
Alain Dufresne ◽  
...  
Keyword(s):  
Electrical Properties ◽  
Electric Field ◽  
Silicone Oil ◽  
Nanofibrillated Cellulose

scholarly journals Electrical and Magnetodielectric Properties of Magneto-Active Fabrics for Electromagnetic Shielding and Health Monitoring

2020 ◽  
Vol 21 (13) ◽  
pp. 4785
Author(s):  
Madalin Bunoiu ◽  
Eugen Mircea Anitas ◽  
Gabriel Pascu ◽  
Larisa Marina Elisabeth Chirigiu ◽  
Ioan Bica
Keyword(s):  
Electrical Properties ◽  
Electric Fields ◽  
Health Monitoring ◽  
Silicone Oil ◽  
Low Cost ◽  
Relaxation Times ◽  
Dielectric Materials ◽  
Medium Frequency ◽  
Mass Fractions ◽  
Electromagnetic Pollution

An efficient, low-cost and environmental-friendly method to fabricate magneto-active fabrics (MAFs) based on cotton fibers soaked with silicone oil and iron oxide microfibers (mFe) at mass fractions 2 wt.%, 4 wt.% and 8 wt.% is presented. It is shown that mFe induce good magnetic properties in MAFs, which are subsequently used as dielectric materials for capacitor fabrication. The electrical properties of MAFs are investigated in a static magnetic field with intensities of 0 kA/m, 160 kA/m and 320 kA/m, superimposed on a medium-frequency electric field. The influence of mFe on the electrical capacitance and dielectric loss tangent is determined, and it can be observed that the electrical conductivity, dielectric relaxation times and magnetodielectric effects are sensibly influenced by the applied magnetic and electric fields. The results indicate that the MAFs have electrical properties which could be useful for protection against electromagnetic pollution or for health monitoring.

Structural and electrical properties of an Au film system deposited on silicone oil surfaces

2002 ◽  
Vol 14 (43) ◽  
pp. 10051-10062 ◽  
Author(s):  
Bo Yang ◽  
A-Gen Xia ◽  
Jin-Sheng Jin ◽  
Quan-Lin Ye ◽  
Yan-Feng Lao ◽  
...  
Keyword(s):  
Electrical Properties ◽  
Silicone Oil ◽  
Film System ◽  
Au Film ◽  
Structural And Electrical Properties

Preparation and Application of the Amino Silicone Oil / Acrylic Emulsion

2012 ◽  
Vol 581-582 ◽  
pp. 129-132
Author(s):  
Yan Jun Tan ◽  
Chang Nan Liu ◽  
Xiu Na Chen
Keyword(s):  
Emulsion Polymerization ◽  
Influencing Factors ◽  
Silicone Oil ◽  
Synthesis Process ◽  
Acrylic Emulsion ◽  
Printing Process ◽  
Amino Silicone

To solve the problem of pigment printing’s hard handle and poor fastness, we have synthesized an amino silicone oil / acrylic emulsion blending adhesive to improve the printing handle and fastness in the paper. We studied the synthetic monomers and influencing factors to explore the best synthesis process of the acrylic emulsion polymerization. The synthetic acrylic emulsion and amino silicone were blended to explore the best printing process. We find that the printed fabrics have a good handle and significantly better rubbing fastness.

Sign in / Sign up

Export Citation Format

Share Document