The Measurement of the Apparent Nuclear Spin-Spin Relaxation Times of N.Q.R. Signals in the Very-High-Frequency Region

1979 ◽  
Vol 32 (2) ◽  
pp. 243 ◽  
Author(s):  
PJ Bryant ◽  
S Hacobian

The Doolan-Hacobian n.q.r. double pulse detection technique is described for the measurement of n.q.r, apparent spin-spin relaxation times as applied to a v.h.f. lecher line super-regenerative spectrometer. Results are presented for the linewidths of the 79Br and 81Br resonances in p-dibromobenzene. It was found that crystal-field inhomogeneities produce significant broadening of the n.q.r. signal.

1981 ◽  
Vol 34 (3) ◽  
pp. 641 ◽  
Author(s):  
PJ Bryant ◽  
S Hacobian

Apparent spin-spin relaxation times, T2*, for the 127I nuclear quadrupole resonances of a series of substituted iodobenzenes were measured by the Doolan-Hacobian double-pulse detection technique. A coaxial line oscillator capable of operation to 800 MHz was used to obtain the signals of the higher frequency transitions. It is shown that the ratio of the T2* measurements of the lower to the upper transition in spin 5/2 systems is of the order of two. This is in accordance with the assumption that the broadening is mainly electrical in nature and arises from the spread in the principal component of the electric field gradients produced by crystal defects.


The arc spectrum of cæsium was investigated with the object of finding whether any of its lines possessed hyperfine structure, resulting from a nuclear magnetic moment, due to a quantised nuclear spin. The lines belonging to the principal series should, owing to the greater degree of penetration of the electron in the (1 s or 6 1 ) orbit, and the correspondingly greater interaction, show the greatest effect. The lines of the principal series are very easily broadened if the vapour pressure of the metal becomes high, so that great care had to be used in obtaining the spectrum of cæsium at a sufficiently low temperature. The most satisfactory method of excitation was found to be the application by means of external electrodes of a very high frequency alternating current to a tube filled with helium at about 2 mm. pressure containing a small quantity of cæsium. The tube required slight heating to bring out the cæsium lines; without this the helium spectrum was very much stronger than the metallic spectrum. At a very low vapour pressures of cæsium the discharge was blue in colour. Under these conditions the lines of the principal series showed no broadening greater than that due to thermal agitation, but at a slightly higher temperature the colour of the discharge became purple and the lines broadened. The lines belonging to the principal series were found to be very close doublets with very nearly constant frequencies differences. A theory is worked out which explains the origin of these doublets, assuming a nuclear spin of one half quantum; by correlating the difference in the separation of the hyperfine structure doublets in the 1 s — m 2 p 3/2 lines and the 1 s — m 2 p 1/2 lines, it is shown that a ratio of the magnetic to the mechanical moment of the nucleus about twice as great as the corresponding ratio for the electron would account for the observed frequency differences. The spectral notation used throughout is that of Hund. The results are compared with those found for the hyperfine structure of some of the bismuth lines by Back and Goudsmid, and are found to be in satisfactory agreement. A selection principle is found which applies both to the bismuth and the cæsium spectrum.


1977 ◽  
Author(s):  
D. V. Campbell ◽  
William Kennebeck ◽  
A. Zanella ◽  
Paul Sexton

2021 ◽  
pp. 1-16
Author(s):  
Xu Hu ◽  
Bin Lin ◽  
Ping Wang ◽  
Hongguang Lyu ◽  
Tie-Shan Li

Abstract The very high frequency data exchange system (VDES) is promising in promoting electronic navigation (E-navigation) and improving navigation safety. The multiple access control (MAC) protocol is crucial to the transmission performance of VDES. The self-organising time division multiple access (SOTDMA) protocol, as the only access mode given by current recommendations, leads to a high rate of transmission collisions in the traditional automatic identification system (AIS), especially with heavy traffic loads. This paper proposes a novel feedback based time division multiple access (FBTDMA) protocol to address the problems caused by SOTDMA, such that collision of transmissions can be avoided in information transmission among vessels. Simulation results demonstrate that the proposed FBTDMA outperforms the traditional SOTDMA in terms of channel utilisation and throughput, and significantly reduces the transmission collision rate. The study is expected to provide insights into VDES standardisation and E-navigation modernisation.


Materials ◽  
2021 ◽  
Vol 14 (12) ◽  
pp. 3360
Author(s):  
Yakir Dahan ◽  
Eldad Holdengreber ◽  
Elichai Glassner ◽  
Oz Sorkin ◽  
Shmuel E. Schacham ◽  
...  

A new measurement technique of electrical parameters of superconducting thin films at the Very High Frequency (VHF) range is described, based on resonators with microstrip (MS) structures. The design of an optimal resonator was achieved, based on a thorough theoretical analysis, which is required for derivation of the exact configuration of the MS. A theoretical model is presented, from which an expression for the attenuation of a MS line can be derived. Accordingly, simulations were performed, and an optimal resonator for the VHF range was designed and implemented. Production constraints of YBa2Cu3O7 (YBCO) limited the diameter of the sapphire substrate to 3″. Therefore, a meander configuration was formed to fit the long λ/4 MS line on the wafer. By measuring the complex input reflection coefficients of a λ/4 resonator, we extracted the quality factor, which is mainly affected by the dielectric and conductor attenuations. The experimental results are well fitted by the theoretical model. The dielectric attenuation was calculated using the quasi-static analysis of the MS line. An identical copper resonator was produced and measured to compare the properties of the YBCO resonator in reference to the copper one. A quality factor of ~6·105 was calculated for the YBCO resonator, three orders of magnitude larger than that of the copper resonator. The attenuation per unit length of the YBCO layer was smaller by more than five orders of magnitude than that of the copper.


Sign in / Sign up

Export Citation Format

Share Document