Decrease in evaporative loss of volatile fuels using new mixture of surfactants

Author(s):  
Fateme Beiranvand ◽  
Hesam Najibi
Keyword(s):  
2015 ◽  
Vol 523 ◽  
pp. 781-789 ◽  
Author(s):  
Grzegorz Skrzypek ◽  
Adam Mydłowski ◽  
Shawan Dogramaci ◽  
Paul Hedley ◽  
John J. Gibson ◽  
...  

2018 ◽  
Vol 115 (43) ◽  
pp. 10920-10925 ◽  
Author(s):  
Paolo A. Sossi ◽  
Frédéric Moynier ◽  
Kirsten van Zuilen

Terrestrial and lunar rocks share chemical and isotopic similarities in refractory elements, suggestive of a common precursor. By contrast, the marked depletion of volatile elements in lunar rocks together with their enrichment in heavy isotopes compared with Earth’s mantle suggests that the Moon underwent evaporative loss of volatiles. However, whether equilibrium prevailed during evaporation and, if so, at what conditions (temperature, pressure, and oxygen fugacity) remain unconstrained. Chromium may shed light on this question, as it has several thermodynamically stable, oxidized gas species that can distinguish between kinetic and equilibrium regimes. Here, we present high-precision Cr isotope measurements in terrestrial and lunar rocks that reveal an enrichment in the lighter isotopes of Cr in the Moon compared with Earth’s mantle by 100 ± 40 ppm per atomic mass unit. This observation is consistent with Cr partitioning into an oxygen-rich vapor phase in equilibrium with the proto-Moon, thereby stabilizing the CrO2 species that is isotopically heavy compared with CrO in a lunar melt. Temperatures of 1,600–1,800 K and oxygen fugacities near the fayalite–magnetite–quartz buffer are required to explain the elemental and isotopic difference of Cr between Earth’s mantle and the Moon. These temperatures are far lower than modeled in the aftermath of a giant impact, implying that volatile loss did not occur contemporaneously with impact but following cooling and accretion of the Moon.


2019 ◽  
Vol 62 (5) ◽  
pp. 1377-1393
Author(s):  
Steven R. Evett ◽  
Gary W. Marek ◽  
Paul D. Colaizzi ◽  
David K. Brauer ◽  
Susan A. O’Shaughnessy

Abstract. Greater than 80% of the irrigated area in the Southern High Plains is served by center-pivot irrigation, but the area served by subsurface drip irrigation (SDI) is increasing due to several factors including declining well yields and improved yields and crop water productivity (CWP), particularly for cotton. Not as well established is the degree to which the reduced soil water evaporation (E) in SDI systems affects the soil water balance, water available to the crop, and overall water savings. Grain corn ( L.) and sorghum ( L. Moench) were grown on four large weighing lysimeters at Bushland, Texas, in 2013 (corn), 2014 and 2015 (sorghum), and 2016 (corn). Evapotranspiration (ET) was measured using the lysimeters and using a neutron probe in the surrounding fields. Two of the lysimeters and surrounding fields were irrigated with SDI, and the other two were irrigated with mid-elevation spray application (MESA). The lysimeter-measured evaporative losses were 149 to 151 mm greater from sprinkler-irrigated corn fields than from SDI fields. When growing sorghum, the lysimeter-measured evaporative losses were 44 to 71 mm greater from sprinkler-irrigated fields than from SDI fields. The differences were affected by plant height and became smaller when plant height reached the height of the spray nozzles, indicating that the use of LEPA or LESA nozzles could decrease the evaporative losses from sprinkler-irrigated fields in this region with its high evaporative demand. Annual weather patterns also influenced the differences in evaporative loss, with increased differences in dry years. SDI reduced overall corn water use by 13% to 15%, as determined by neutron probe, while either not significantly affecting yield (2016) or increasing yield by up to 19% (2013) and increasing CWP by 37% (2013) to 13% (2016) as compared with MESA full irrigation. However, sorghum yield decreased by 15% and CWP decreased by 14% in 2014 when using SDI compared with MESA full irrigation due to an overly wet soil profile in the SDI fields and deep percolation that likely caused nutrient losses. In 2015, there were no significant sorghum yield differences between irrigation methods. Sorghum CWP was significantly greater (by 14%) in one SDI field in 2015 compared with MESA fully irrigated sorghum. Overall, sorghum CWP increased by 8% for SDI compared with MESA full irrigation in 2015. These results indicate that SDI will be successful for corn production in the Texas High Plains, but SDI is unlikely to benefit sorghum production. Keywords: Corn, Crop water productivity, Evaporative loss, Evapotranspiration, Irrigation application method, Sorghum, Water use efficiency, Weighing lysimeter.


2020 ◽  
Vol 38 (4) ◽  
pp. 841-866
Author(s):  
Qiulin Guo ◽  
Xiaoming Chen ◽  
Xiaoxue Liuzhuang ◽  
Zhi Yang ◽  
Man Zheng ◽  
...  

The widely distributed, thick Chang 7 Shale is the richest shale oil formation in China. A calculation method for the evaporative hydrocarbon recovery coefficient based on formation volume factor is proposed considering the correction of heterogeneity-based total organic carbon differences to improve the adsorbed oil calculation method, and light hydrocarbon evaporative sampling losses, which can make mobile and total oil calculations more accurate. The adsorbed oil, S1 evaporative loss, total oil yield, and movable oil yield of 200 shale samples from the Chang 7 Member were calculated using the new methods. Results show that S1 evaporative loss accounts for 29% of S1, total oil yield is 3.5 times S1, and movable oil yield accounts for 37% of total oil yield. Based on the calculated total oil yield and movable oil yield results, the relationships among total oil yield, movable oil yield, and total organic carbon of the Chang 7 were established yielding total oil yield and movable oil yield estimates of 11.12 × 109 t and 4.01 × 109 t, respectively, revealing its tremendous shale exploration potential.


2020 ◽  
pp. 088532822096752
Author(s):  
Petar Borisov Eftimov ◽  
Norihiko Yokoi ◽  
Nikola Peev ◽  
Yasen Paunski ◽  
Georgi Asenov Georgiev

Silicone hydrogels (SiHy), represent composite matrices composed of hydrophobic gas permeable silicone (Si) rich core and a surface enriched with hydrophilic polymer moieties. Their utilization in contact lens design requires number of SiHy properties (hydration, wettability, lubricity) to be optimized for the challenging conditions at the ocular surface. Typical limitations in literature are that (i) these properties are studied in isolation, monitoring only one parameter but not the rest of them, and (ii) measurements are performed with hydrated samples immediately after removal from storage solutions. Here we study the simultaneous evolution of critical material properties (evaporative loss of water, water contact angle, coefficient of friction) of different SiHy subjected to continuous blink-like desiccation/rehydration cycling. SiHy with wetting agents incorporated in their core (narafilcon A, senofilcon A) were particularly susceptible to extended desiccation. Stenfilcon A, a material with only 3% bulk Si content maintained its performance for 4 h of cycling, and delefilcon A (80% surface water content) resisted extended 8 h of desiccation/rehydration runs. Strong correlation exists between the evolution of SiHy wettability and lubricity at ≥4 h of blink-like cycling. Understanding the interplay between SiHy properties bears insights for knowledge based design of novel ophthalmic materials.


2009 ◽  
Vol 7 (4) ◽  
pp. 186-198 ◽  
Author(s):  
Alan Tomlinson ◽  
Marshall G. Doane ◽  
Angus Mcfadyen

2006 ◽  
Vol 6 (3) ◽  
pp. 3687-3707 ◽  
Author(s):  
W. Y. Tsai ◽  
L. Y. Chan ◽  
D. R. Blake ◽  
K. W. Chu

Abstract. Vehicular emission is an important source of air pollutants in urban cities in the Pearl River Delta (PRD) region of South China. In order to study the impact of vehicular fuel on air quality, several commonly used fuel samples were collected in four main cities in the PRD region – Hong Kong, Guangzhou, Macau and Zhuhai, and analyzed for their volatile organic compounds (VOCs) composition. Source profiles of the vehicular fuels used in these cities were constructed and are believed to be the first reported for the PRD region. The C8–C10 hydrocarbons were the main constituents of diesel. Different from diesel, gasoline used in the PRD region was mainly comprised of lighter C4–C7 hydrocarbons, with toluene and i-pentane being the two most abundant species. The benzene content in the Guangzhou and Zhuhai gasoline samples were higher than that in Hong Kong and Macau and exceeded the maximum benzene levels for Mainland China unleaded gasoline. Liquefied Petroleum Gas (LPG) samples were collected only in Hong Kong and were comprised mainly of n-butane, propane and i-butane. Traffic samples indicated that evaporative loss and vehicular combustion were the primary contributors to elevated VOC levels in roadside atmospheres. Significant i-pentane and toluene concentrations were observed in roadside atmospheres in all four cities. Ratio of i-pentane in gasoline samples to that in roadside samples were calculated and this showed that the degree of evaporative loss was higher in Guangzhou and Zhuhai than that in Hong Kong and Macau. We suggest the difference is due to the better maintenance and more new cars in Hong Kong and Macau. From tunnel samples collected in Hong Kong in two different years, we found that the relative amount of propane, i-butane, and n-butane increased between 2001 to 2003, consistent with the 40% increase in LPG fueled vehicles. Propane to butanes ratios were calculated for LPG and tunnels samples, and the comparable ratios illustrated the LPG leakages from LPG fueled vehicles crossing the tunnel.


Sign in / Sign up

Export Citation Format

Share Document