The rheological properties of magnetic field excited magnetic powders sheared between two parallel plates

2013 ◽  
Vol 22 (11) ◽  
pp. 115036 ◽  
Author(s):  
Kaikai Chen ◽  
Yu Tian ◽  
Lei Shan ◽  
Xiangjun Zhang ◽  
Yonggang Meng
Keyword(s):  
Magnetic Field ◽  
Rheological Properties ◽  
Parallel Plates

scholarly journals Rheological Properties of Cement Paste with Nano-Fe3O4 under Magnetic Field: Flow Curve and Nanoparticle Agglomeration

Materials ◽  
2020 ◽  
Vol 13 (22) ◽  
pp. 5164
Author(s):  
Dengwu Jiao ◽  
Karel Lesage ◽  
Mert Yucel Yardimci ◽  
Khadija El Cheikh ◽  
Caijun Shi ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Rheological Properties ◽  
Cement Paste ◽  
High Rate ◽  
Parallel Plates ◽  
Nanoparticle Agglomeration ◽  
High Magnetic Field Strength ◽  
Concrete Pumping ◽  
Underlying Mechanisms ◽  
Nano Fe3o4

Understanding the influence of magnetic fields on the rheological behavior of flowing cement paste is of great importance to achieve active rheology control during concrete pumping. In this study, the rheological properties of cementitious paste with water-to-cement (w/c) ratio of 0.4 and nano-Fe3O4 content of 3% are first measured under magnetic field. Experimental results show that the shear stress of the cementitious paste under an external magnetic field of 0.5 T is lower than that obtained without magnetic field. After the rheological test, obvious nanoparticle agglomeration and bleeding are observed on the interface between the cementitious paste and the upper rotating plate, and results indicate that this behavior is induced by the high magnetic field strength and high-rate shearing. Subsequently, the hypothesis about the underlying mechanisms of nanoparticles migration in cementitious paste is illustrated. The distribution of the nanoparticles in the cementitious paste between parallel plates is examined by the magnetic properties of the powder as determined by a vibrating sample magnetometer. It is revealed that the magnetization of cementitious powders at different sections and layers provides a solid verification of the hypothesis.

Magnetohydrodynamic Squeeze Film Characteristics Between Parallel Circular Plates Containing a Single Central Air Bubble in the Inertial Flow Regime

1999 ◽  
Vol 66 (4) ◽  
pp. 1021-1023 ◽  
Author(s):  
R. Usha ◽  
P. Vimala
Keyword(s):  
Magnetic Field ◽  
Differential Equation ◽  
Nonlinear Differential Equation ◽  
Bubble Radius ◽  
Fluid Film ◽  
Squeeze Film ◽  
Parallel Plates ◽  
Circular Plates ◽  
Air Bubble ◽  
Approximate Analytical Solutions

In this paper, the magnetic effects on the Newtonian squeeze film between two circular parallel plates, containing a single central air bubble of cylindrical shape are theoretically investigated. A uniform magnetic field is applied perpendicular to the circular plates, which are in sinusoidal relative motion, and fluid film inertia effects are included in the analysis. Assuming an ideal gas under isothermal condition for an air bubble, a nonlinear differential equation for the bubble radius is obtained by approximating the momentum equation governing the magnetohydrodynamic squeeze film by the mean value averaged across the film thickness. Approximate analytical solutions for the air bubble radius, pressure distribution, and squeeze film force are determined by a perturbation method for small amplitude of sinusoidal motion and are compared with the numerical solution obtained by solving the nonlinear differential equation. The combined effects of air bubble, fluid film inertia, and magnetic field on the squeeze film force are analyzed.

Numerical study of unsteady MHD Couette flow and heat transfer of nanofluids in a rotating system with convective cooling

2016 ◽  
Vol 26 (5) ◽  
pp. 1567-1579 ◽  
Author(s):  
Ahmada Omar Ali ◽  
Oluwole Daniel Makinde ◽  
Yaw Nkansah-Gyekye
Keyword(s):  
Magnetic Field ◽  
Heat Transfer ◽  
Couette Flow ◽  
Numerical Study ◽  
Integration Scheme ◽  
Parallel Plates ◽  
Content Type ◽  
Flow And Heat Transfer ◽  
Mhd Couette Flow ◽  
Rotating Channel

Purpose – The purpose of this paper is to investigate numerically the unsteady MHD Couette flow and heat transfer of viscous, incompressible and electrically conducting nanofluids between two parallel plates in a rotating channel. Design/methodology/approach – The nanofluid is set in motion by the combined action of moving upper plate, Coriolis force and the constant pressure gradient. The channel rotates in unison about an axis normal to the plates. The nonlinear governing equations for velocity and heat transfer are obtained and solved numerically using semi-discretization, shooting and collocation (bvp4c) techniques together with Runge-Kutta Fehlberg integration scheme. Findings – Results show that both magnetic field and rotation rate demonstrate significant effect on velocity and heat transfer profiles in the system with Cu-water nanofluid demonstrating the highest velocity and heat transfer efficiency. These numerical results are in excellent agreements with the results obtained by other methods. Practical implications – This paper provides a very useful source of information for researchers on the subject of hydromagnetic nanofluid flow in rotating systems. Originality/value – Couette flow of nanofluid in the presence of applied magnetic field in a rotating channel is investigated.

scholarly journals Corrigendum by Simeon Oka, Editor-in-Chief of the Journal Thermal Science requested to replace .pdf file of the paper The effect of variable magnetic field on heat transfer and flow analysis of unsteady squeezing nanofluid flow between parallel plates using Galerkin method by Mohammad Rahimi-Gorji Oveis Pourmehran, Mofid Gorji-Bandpy and Davood Domiri Ganji, Published in the Journal Thermal Science, year 2017, vol. 21, no. 5, pp. 2057-2067; https://doi.org/10.2298/TSCI160524180R

2017 ◽  
Vol 21 (6 Part B) ◽  
pp. 3062-3062
Author(s):  
E Editorial
Keyword(s):  
Magnetic Field ◽  
Heat Transfer ◽  
Review Process ◽  
Peer Review Process ◽  
Flow Analysis ◽  
Editorial Staff ◽  
Variable Magnetic Field ◽  
Parallel Plates ◽  
Nanofluid Flow ◽  
Font Color

Due to error of the Editorial staff, unrevised manuscript has been published instead of the REVISED MANUSCRIPT sent by authors after peer review process. The corrected version of this article is printed in this issue on pages pp. 3063-3073<br><br><font color="red"><b> Link to the corrected article <u><a href="http://dx.doi.org/10.2298/TSCI160524180R">10.2298/TSCI160524180R</a></b></u>

Visualizing Rheological Mechanism of Magnetorheological Fluids

2021 ◽  
Author(s):  
Yurui Shen ◽  
Dezheng Hua ◽  
Xinhua Liu ◽  
Weihua Li ◽  
Grzegorz Krolczyk ◽  
...  
Keyword(s):  
Magnetic Field ◽  
Rheological Properties ◽  
Magnetic Dipole ◽  
Laser Scanning ◽  
Magnetic Particles ◽  
Three Dimensional ◽  
Confocal Laser Scanning Microscope ◽  
Magnetorheological Fluids ◽  
Confocal Laser ◽  
Observation Method

Abstract In order to study the rheological properties of aqueous magnetorheological fluids (MRFs) from microscopic point of view, an experimental observation method based on the fluorescence confocal laser scanning microscope is proposed to clearly produce the chain shape of the magnetic particles. Firstly, the mathematical model of the magnetic particles is established in a magnetic field using the magnetic dipole theory, and the MRFs with different fraction volumes and different magnetic fields are investigated. Furthermore, an aqueous MRFs experiment is prepared, in which the magnetic particles are combined with Alexa 488 fluorescent probe. On this basis, an observation method is innovatively developed using two-dimensional (2D) and three-dimensional (3D) image analysis by the fluorescence confocal microscope. The rheological mechanism of the aqueous MRFs is investigated using four different types of MRFs in an external magnetic field. The analysis results demonstrate that the simulation and experimental rheological properties of the MRFs are consistent with the magnetic dipole theory. Moreover, the proposed method is able to real-time observe the rheological process of the MRFs with a very high resolution, which ensures the correctness of the analysis results of the rheological mechanism.

ANALYSIS OF THE POTENTIAL USAGE OF SELECTED MAGNETIC FLUIDS IN THRUST SLIDE BEARINGS

Tribologia ◽  
2016 ◽  
Vol 269 (5) ◽  
pp. 41-49 ◽  
Author(s):  
Wojciech HORAK ◽  
Józef SALWIŃSKI ◽  
Marcin SZCZĘCH
Keyword(s):  
Magnetic Field ◽  
Rheological Properties ◽  
Mechanical Energy ◽  
Magnetic Fluids ◽  
Magnetorheological Fluids ◽  
Machine Design ◽  
Rheological Characteristics ◽  
New Horizons ◽  
Controlled Systems ◽  
Ferromagnetic Fluids

Magnetic fluids are substances whose rheological properties can be actively influenced by treatment with a magnetic field. Two main types of magnetic fluids can be distinguished: ferromagnetic fluids, and magnetorheological fluids. Ferrofluids are mostly used in sealing engineering, whereas magnetorheological fluids are usually applied in controlled systems for the dissipation of mechanical energy, like brakes and dampers. The ability to control the rheological properties of magnetic fluids opens new horizons for development in machine design, among others in the areas of bearing engineering. The paper presents a comparative analysis of the rheological characteristics of selected magnetic fluids with a focus on the possible areas of the application of these substances in bearing engineering.

MAGNETORHEOLOGICAL FLUIDS AND THEIR PROPERTIES

2005 ◽  
Vol 19 (01n03) ◽  
pp. 593-596 ◽  
Author(s):  
J. M. HE ◽  
J. HUANG
Keyword(s):  
Magnetic Field ◽  
Yield Strength ◽  
Rheological Properties ◽  
Yield Stress ◽  
Applied Magnetic Field ◽  
Magnetorheological Fluids ◽  
Mr Fluid ◽  
Variable Yield ◽  
Mr Fluids

Magnetorheological (MR) fluids are materials that respond to an applied magnetic field with a change in their rheological properties. Upon application of a magnetic field, MR fluids have a variable yield strength. Altering the strength of the applied magnetic field will control the yield stress of these fluids. In this paper, the method for measuring the yield stress of MR fluids is proposed. The curves between the yield stress of the MR fluid and the applied magnetic field are obtained from the experiment. The result indicates that with the increase of the applied magnetic field the yield stress of the MR fluids goes up rapidly.

Sign in / Sign up

Export Citation Format

Share Document