Splitting of laser-induced neutral and plasma plumes: Hydrodynamic origin of bimodal distributions of vapor density and plasma emission intensity

Author(s):  
Alexey Volkov
Coatings ◽  
2020 ◽  
Vol 10 (7) ◽  
pp. 608
Author(s):  
Guang Li ◽  
Yi Xu ◽  
Yuan Xia

A pulsed-dc (direct current) magnetron sputtering with a plasma emission monitor (PEM) system was applied to synthesize Cr-containing hydrogenated amorphous diamond-like carbon (Cr-DLC) films using a large-size industrial Cr target. The plasma emission intensity of a Cr atom at 358 nm wavelength was characterized by optical emission spectrometer (OES). C2H2 gas flow rate was precisely adjusted to obtain a stable plasma emission intensity. The relationships between Cr atom plasma emission intensity and the element concentration, cross-sectional morphology, deposition rate, microstructure, mechanical properties, and tribological properties of Cr-DLC films were investigated. Scanning electron microscope and Raman spectra were employed to analyze the chemical composition and microstructure, respectively. The mechanical and tribological behaviors were characterized and analyzed by using the nano-indentation, scratch test instrument, and ball-on-disk reciprocating friction/wear tester. The results indicate that the PEM system was successfully used in magnetron sputtering for a more stable Cr-DLC deposition process.


2012 ◽  
Vol 14 (4) ◽  
pp. 333-337 ◽  
Author(s):  
Khurram Siraj ◽  
Muhammad Zakria Butt ◽  
Muhammad Khaleeq-Urrahman ◽  
Muhammad Shahid Rafique ◽  
Saima Rafique ◽  
...  

2018 ◽  
Vol 940 ◽  
pp. 114-119
Author(s):  
Chien Jen Tang ◽  
Wei Hsuan Hsu ◽  
Ching Tang Li

The vanadium dioxide films were deposited by reactive high-power impulse magnetron sputtering for different plasma emission intensity at the substrate temperature of 310 °C. The setpoint of plasma emission intensity was controlled by a PID controller with plasma-emission-monitoring. The vanadium dioxide films characteristics were measured by optical spectrophotometer, X-ray diffraction and electrical source meter.


1997 ◽  
Vol 61 (10) ◽  
pp. 1108-1114 ◽  
Author(s):  
Shozo Inoue ◽  
Hitoshi Uchida ◽  
Takaaki Ohba ◽  
Keiji Koterazawa ◽  
Akiyoshi Chayahara ◽  
...  

1983 ◽  
Vol 37 (4) ◽  
pp. 379-384 ◽  
Author(s):  
David E. Dobb ◽  
Dennis R. Jenke

Memory effects or sample carry over characteristics of five pneumatic nebulizers routinely used for sample introduction into plasma emission spectrometers are studied. It is observed that the primary source of the memory noted for the nebulizers studied is the dissipation rate of the fog produced by the nebulizer during introduction of the previous sample or samples. Contributions to memory from the aspiration tube, salt deposition at the nebulizer tip, and a chromatographic effect at the torch tip are minimal. In terms of operational stability, detection capability, tolerance for particulates, and low memory, a concentric nebulizer with a Pt: Ir needle, Teflon nose cone, and an extended spray director is superior to the others tested. Even under the most optimum conditions, the washout time required to reduce sample emission to 0.1% of its maximum intensity varies from 2 to 4 min, thereby greatly increasing per sample analysis time. The memory effect phenomena can be accurately modeled by a hyperbolic curve and can, therefore, be easily corrected for in routine analysis. The memory correction value, which is subtracted from a sample's net emission intensity, is calculated from the product of an empirically defined correction constant and the emission intensity of previously run samples divided by the washout time. Examples of the utilization of the correction are shown.


1996 ◽  
Vol 03 (01) ◽  
pp. 499-504
Author(s):  
Y. SASAKI ◽  
J. SATO ◽  
A. KASUYA ◽  
Y. NISHINA

We have observed light emission from Ar atoms [Ar(I)], Ge atoms [Ge(I)]/clusters[Ge2], and Ge ions [Ge(II)] during the evaporation process of Ge in an Ar-gas atmosphere of a few Torr. The Ar(I) lines are observed regardless of whether the crucible is empty or filled with Ge. Ar atoms are excited through discharge initiated by electrons thermionically emitted from the hot W wire heating the crucible and accelerated by the potential applied to the wire. Since the emission due to Ge is observed only when the Ar(I) lines are observed, it is concluded that Ge atoms are excited by excited Ar atoms and possibly ions. Intensities of Ar(I) lines decrease by transferring energy to Ge atoms/clusters if the density of Ge vapor is high. Emission intensity diminishes with distance from the crucible surrounded by a heat reflector and a water-cooled shroud, dropping most rapidly for Ge(II), and progressively less rapidly for Ge(I), Ar(I), and Ge2. The Ge(II) lines are stronger for lower Ar pressures and for lower Ge vapor density, while the Ge2 line is stronger for higher Ar pressures. The relative intensities of Ar(I), Ge(I), GE(II), and Ge2 also depend on the structure of the evaporation source. Reabsorption of emitted light by Ge clusters modifies the profile of the emission spectrum at ~3.7 and 4.3 eV.


Author(s):  
Y. F. Lu ◽  
X. K. Shen ◽  
H. Ling

Laser-induced breakdown spectroscopy (LIBS) with spatial confinement effects and LIBS combined with laser-induced fluorescence (LIBS-LIF) have been investigated to improve the detection sensitivity and element-selectivity of LIBS. An obvious enhancement in the emission intensity of aluminum (Al) atomic lines was observed when a cylindrical wall was placed to spatially confine the plasma plumes. The maximum enhance factor for the emission intensity of Al atomic lines was measured to be around 10. Assuming local thermodynamic equilibrium conditions, the plasma temperatures are estimated to be in a range from 4,000 to 5,800 K. It shows that the plasma temperature increased by around 1,000 K when the cylindrical confinement was applied. Fast images of the laser-induced Al plasmas show that the plasmas were compressed into a smaller volume with a pipe presented. LIBS-LIF has been investigated to overcome the matrix effects of LIBS for the detection of trace uranium (U) in solids. An optical parametric oscillator wavelength-tunable laser was used to resonantly excite the uranium atoms and ions within the plasma plumes generated by a Q-switched Nd:YAG laser. Both atomic and ionic lines can be selected to detect their fluorescence lines. A U concentration of 462 ppm in a glass sample can be detected using this technique at an excitation wavelength of 385.96 nm for resonant excitation of U II and a fluorescence line wavelength of 409.01 nm from U II. The mechanism of spatial confinement effects and the influence of relevant operational parameters of LIBS-LIF are discussed. In this work, detection in open air of trace phosphorus (P) in steels using LIBS-LIF has also been investigated. The optical parametric oscillator laser was used to resonantly excite the P atoms within plasma plumes generated by the Q-switched Nd:YAG laser. A set of steel samples with P concentrations from 3.9 to 720 ppm were analyzed using LIBS-LIF at wavelengths of 253.40 and 253.56 nm for resonant excitation of P atoms and fluorescence lines at wavelengths of 213.55 and 213.62 nm. The calibration curves were measured to determine the limit of detection for P in steels, which is estimated to be around 0.7 ppm.


Sign in / Sign up

Export Citation Format

Share Document