Effect of microwave radiation on the stability of frozen cefoxitin sodium solution in plastic bags

1981 ◽  
Vol 38 (11) ◽  
pp. 1743-1745
Author(s):  
M. Lou Stiles
1980 ◽  
Vol 37 (2) ◽  
pp. 211-215
Author(s):  
G. William Tomecko ◽  
Michael L. Kleinberg ◽  
Clifton J. Latiolais ◽  
Richard B. Prior ◽  
Lawrence J. Pesko ◽  
...  

1990 ◽  
Vol 10 (2) ◽  
pp. 157-160 ◽  
Author(s):  
Sandra E. Holmes ◽  
Stephen Aldous

This study examines the stability of both components of the antibacterial combination, cotrimoxazole (trimethoprim and sulphamethoxazole) in peritoneal dialysis fluid stored in polyvinyl chloride bags and glass ampoules at room temperature for up to nine days. Greater than 10% loss of trimethoprim occurred within three days for admixtures stored in plastic bags, whereas the original concentration remained virtually unchanged after nine days for similar solutions stored in glass ampoules. This indicated that the loss of trimethoprim observed in solutions stored in plastic bags was associated primarily with the nature of the container, presumably due to some form of uptake by or loss through the plastic. Greater than 10% loss of sulphamethoxazole occurred within two days for all admixtures examined, stored in either glass or plastic containers. This degree of loss was achieved within 12 h for one admixture stored in plastic. There was also the time-dependent appearance of an additional peak in HPLC analyses of these solutions, indicating that loss of sulphamethoxazole was due to chemical decomposition of the drug in the peritoneal dialysis fluid. The shelf-life of such admixtures would be limited by the stability of the sulphamethoxazole component, with the available data suggesting a shelf-life of 12 h for solutions stored at room temperature.


2017 ◽  
Vol 730 ◽  
pp. 272-281
Author(s):  
Li Cong Zheng ◽  
Zhan Wei Liu ◽  
Ke Qiang Xie ◽  
Wen Hui Ma ◽  
Kui Xian Wei

There are many different types of valence of sufur in aluminate sodium solution during the process of the bauxite dissolution, which mainly including S2-, S22-, S, S2O32-, SO32-, SO42- and it may have an effect on the mineral dissolution process. Therefore, it is necessary that the thermodynamic properties of S-H2O system were investigated in sodium aluminate solution. In this paper, the reactions between different valence states of sulfur and lye (with or without oxygen participation) were studied in sodium aluminate solution. The thermodynamic software Factsage 7.0 was carried out to calculate the standard reaction Gibbs free energy (ΔGTθ). The results showed that S2- and SO42- are the most stability in terms of the autoreactive reaction of different valence states at 298-573 K, and that the stability of different valence states of sufur order is “S22- >(S2O32-, SO32-) >S”. At 523 K, SO32- is more stable than S2O32-. On the other hand, the low-valent sulfur was more likely to be oxidized into SO42- under oxidizing conditions at 298-573 K. Besides, it was also found that S22- is most susceptible to oxidation because of the lowest stability. Finally, the stability of the other valence states of sulfur under oxidizing conditions order is “SO32- >S2O32- >S2- >S”.


1982 ◽  
Vol 39 (1) ◽  
pp. 104-108 ◽  
Author(s):  
Clifford J. Holmes ◽  
Robert K. Ausman ◽  
Ruth B. Kundsin ◽  
Carl W. Walter
Keyword(s):  

2018 ◽  
Vol 2018 (8) ◽  
Author(s):  
V. L. Vesnin ◽  
◽  
V. A. Sergeev ◽  
A. M. Hodakov ◽  
I. V. Frolov ◽  
...  

2017 ◽  
Vol 1 (3) ◽  
pp. 255-260
Author(s):  
J. A. De Jong ◽  
J. C. Woodworth ◽  
J. M. DeRouchey ◽  
R. D. Goodband ◽  
M. D. Tokach ◽  
...  

Abstract Phytase is a feed-grade enzyme frequently added to swine diets to help improve the digestibility of phytate phosphorus. However, like any enzyme, it may be subject to heat damage when exposed to thermal processing. Therefore the objective of this experiment was to determine the stability of 4 commercial phytase products exposed to increasing thermal conditioning temperatures in the pelleting process. The 4 commercial products used were: Quantum Blue G (AB Vista, Plantation, FL); Ronozyme Hi Phos GT (DSM Nutritional Products, Parsippany, NJ); Axtra Phy TPT (Dupont, Wilmington, DE), and Microtech 5000 Plus (Guangdong Vtr Bio-Tech Co., Ltd., Guangdong, China). The phytase products were mixed as part of a corn-soybean meal-based swine diet at a concentration recommended by the manufacturer to provide a 0.12% aP release. Diets were exposed to each of 4 thermal conditioning temperatures (65, 75, 85, and 95°C) and the entire process repeated on 4 consecutive days to create 4 replicates. Samples were taken while feed exited the conditioner and before entering the pellet die. Samples were cooled to room temperature before being stored in plastic bags until analysis. Phytase stability was measured as the residual phytase activity (% of initial) at each conditioning temperature. There were no product × temperature interactions observed for conditioning temperature, conditioner throughput, or residual phytase activity. As target temperature increased, conditioner throughput decreased (linear; P < 0.001) and phytase activity decreased (linear; P < 0.001) for each product. Residual phytase activity decreased as conditioning temperature increased from 65 to 95°C at a rate of –1.9% for every 1°C increase in conditioning temperature. There was a significant phytase product (P < 0.001) main effect which was mainly driven by Microtech 5000 Plus having decreased (P < 0.05) phytase activity when compared to all other products at 65, 75, and 85°C. However at 95°C Axtra Phy TPT had greater (P < 0.05) residual phytase activity compared with Microtech 5000 Plus, with Quantum Blue G and Ronozyme Hi Phos intermediate. Increasing target conditioning temperatures decreased phytase stability regardless of product. In addition, Microtech 5000 Plus had decreased residual phytase activity (% of initial) when compared to all other products at 65, 75, and 85°C.


Transport ◽  
2019 ◽  
Vol 34 (1) ◽  
pp. 52-66 ◽  
Author(s):  
Željko Stević ◽  
Marko Vasiljević ◽  
Adis Puška ◽  
Ilija Tanackov ◽  
Raimundas Junevičius ◽  
...  

A decision-making process requires a prior definition and fulfilment of certain factors, especially when it refers to complex fields such as supply chain management. One of the most important items in the initial stage of a supply chain, which strongly influences its further flow, is making a decision on the most suitable supplier. In this paper, a model for evaluation and supplier selection has been proposed, which has been considered in more than ten different production areas. The model consists of twenty quantitative and qualitative criteria, which are reduced to a total of nine by the application of the fuzzy AHP and the assessment of managers in production companies. The verification of the model has been presented throughout a selection of suppliers in a company for the production of plastic bags and foils, where the Fuzzy Analytic Hierarchy Process (Fuzzy AHP) method has been used to determine the significance of the criteria, and the Fuzzy Evaluation based on Distance from Average Solution (Fuzzy EDAS) to evaluate and select suppliers. The obtained results have been considered throughout a sensitivity analysis in which a total of 15 different scenarios have been formed and where the stability of the model has been determined, since the supplier one is the best solution in all the cases.


2006 ◽  
Author(s):  
Sergey Ryabchun ◽  
Cheuk-yu E. Tong ◽  
Raymond Blundell ◽  
Robert Kimberk ◽  
Gregory Gol'tsman

2019 ◽  
Vol 26 (4) ◽  
pp. 665-674
Author(s):  
Aleksandra Kłos-Witkowska ◽  
Vasyl Martsenyuk

Abstract The analysis of UV-VIS spectrum was used for testing changes through 36 days and the impact of external conditions (reduced temperature (R), microwave radiation (M) and normal conditions (NC) for comparisons) on the stability of: BSA and BSA-Fe2+ complexes after different treating procedure. The increase of BSA absorption with increasing concentration of Fe2+ was observed. Increased absorption of BSA, and BSA-Fe2+ with time, related probably to conformational changes present in the protein and changes in electrostatic reactions within the BSA-Fe2+ complexes. Examination of the impact of an external factor on stabilization of the protein and complexes showed a tendency to keep the stability under reduced temperature and a trend with accelerated protein and complex aging under microwave radiation. The observed tendencies to changes under the influence of external factors became more significant in time. These effects were most probably related to changes of the protein structure and time, while the observed trend of accelerating the changes was impacted by the applied external factors.


Sign in / Sign up

Export Citation Format

Share Document