Intertextual Precision Expectations

2019 ◽  
pp. 107-116
Author(s):  
Karin Kukkonen
Keyword(s):  
Third Order ◽  
Structural Patterns ◽  
First Order ◽  
The Third ◽  
Order Probability

In the chapters that follow, the third-order probability design is developed. The third-order probability design revolves around how expectations about second- and first-order predictions are developed through structural patterns yielded by genre (III.1), textual gaps and shadow stories (III.2), and intertextual references to unfamiliar texts (III.3). The final chapter of the section, then, traces the tension between flexibility and constraint in probability designs.

scholarly journals Achieving Seventh-Order Amplitude Accuracy in Leapfrog Integrations

2013 ◽  
Vol 141 (9) ◽  
pp. 3037-3051 ◽  
Author(s):  
Paul D. Williams
Keyword(s):  
Nonlinear System ◽  
Third Order ◽  
First Order ◽  
Time Stepping ◽  
The Third ◽  
Numerical Integrations ◽  
Seventh Order ◽  
Ocean Models ◽  
Stability And Accuracy ◽  
Fifth Order

Abstract The leapfrog time-stepping scheme makes no amplitude errors when integrating linear oscillations. Unfortunately, the Robert–Asselin filter, which is used to damp the computational mode, introduces first-order amplitude errors. The Robert–Asselin–Williams (RAW) filter, which was recently proposed as an improvement, eliminates the first-order amplitude errors and yields third-order amplitude accuracy. However, it has not previously been shown how to further improve the accuracy by eliminating the third- and higher-order amplitude errors. Here, it is shown that leapfrogging over a suitably weighted blend of the filtered and unfiltered tendencies eliminates the third-order amplitude errors and yields fifth-order amplitude accuracy. It is further shown that the use of a more discriminating (1, −4, 6, −4, 1) filter instead of a (1, −2, 1) filter eliminates the fifth-order amplitude errors and yields seventh-order amplitude accuracy. Other related schemes are obtained by varying the values of the filter parameters, and it is found that several combinations offer an appealing compromise of stability and accuracy. The proposed new schemes are tested in numerical integrations of a simple nonlinear system. They appear to be attractive alternatives to the filtered leapfrog schemes currently used in many atmosphere and ocean models.

scholarly journals Positive Solutions for Third-Order Boundary-Value Problems with the Integral Boundary Conditions and Dependence on the First-Order Derivatives

2013 ◽  
Vol 2013 ◽  
pp. 1-6 ◽  
Author(s):  
Yanping Guo ◽  
Fei Yang
Keyword(s):  
Fixed Point ◽  
Green Function ◽  
Boundary Conditions ◽  
Boundary Value ◽  
Integral Boundary Conditions ◽  
Third Order ◽  
Integral Boundary ◽  
First Order ◽  
The Third ◽  
Nonnegative Continuous Function

By using a fixed point theorem in a cone and the nonlocal third-order BVP's Green function, the existence of at least one positive solution for the third-order boundary-value problem with the integral boundary conditionsx′′′(t)+f(t,x(t),x′(t))=0,t∈J,x(0)=0,x′′(0)=0, andx(1)=∫01g(t)x(t)dtis considered, wherefis a nonnegative continuous function,J=[0,1], andg∈L[0,1].The emphasis here is thatfdepends on the first-order derivatives.

scholarly journals MODIFIED WAVE EQUATION FOR SPINLESS PARTICLES AND ITS SOLUTIONS IN AN EXTERNAL MAGNETIC FIELD

2013 ◽  
Vol 28 (06) ◽  
pp. 1350014 ◽  
Author(s):  
S. I. KRUGLOV
Keyword(s):  
Magnetic Field ◽  
Wave Equation ◽  
External Magnetic Field ◽  
Quantum Mechanical ◽  
Third Order ◽  
Modified Dispersion Relation ◽  
First Order ◽  
The Third ◽  
Uniform External Magnetic Field ◽  
Schrödinger Form

The wave equation for spinless particles with the Lorentz violating term is considered. We formulate the third-order in derivatives wave equation leading to the modified dispersion relation. The first-order formalism is considered and the density matrix is obtained. The Schrödinger form of equations is presented and the quantum-mechanical Hamiltonian is found. Exact solutions of the wave equation are obtained for particles in the constant and uniform external magnetic field. The change of the synchrotron radiation radius due to quantum gravity corrections is calculated.

Perturbation treatment of the Hartree–Fock equations for the ground states of the boron-like ions

1969 ◽  
Vol 47 (7) ◽  
pp. 699-705 ◽  
Author(s):  
C. S. Sharma ◽  
R. G. Wilson
Keyword(s):  
Ground State ◽  
Atomic System ◽  
Ground States ◽  
Great Accuracy ◽  
Second Order ◽  
Expectation Values ◽  
Third Order ◽  
First Order ◽  
Hartree Fock ◽  
The Third

The first-order Hartree–Fock and unrestricted Hartree–Fock equations for the ground state of a five electron atomic system are solved exactly. The solutions are used to evaluate the corresponding second-order energies exactly and the third-order energies with great accuracy. The first-order terms in the expectation values of 1/r, r, r2, and δ(r) are also calculated.

scholarly journals Solitons, Rogues and Interaction Behaviors of Third-Order Nonlinear Schrodinger Equation

2022 ◽  
Author(s):  
Ren Bo ◽  
Shi Kai-Zhong ◽  
Shou-Feng Shen ◽  
Wang Guo-Fang ◽  
Peng Jun-Da ◽  
...  
Keyword(s):  
Bilinear Form ◽  
Rogue Wave ◽  
Soliton Solutions ◽  
Ultrashort Pulses ◽  
Rogue Waves ◽  
Third Order ◽  
First Order ◽  
The Third ◽  
Femtosecond Regime ◽  
Wave Limit

Abstract In this paper, we investigate the third-order nonlinear Schr\"{o}dinger equation which is used to describe the propagation of ultrashort pulses in the subpicosecond or femtosecond regime. Based on the independent transformation, the bilinear form of the third-order NLSE is constructed. The multiple soliton solutions are constructed by solving the bilinear form. The multi-order rogue waves and interaction between one-soliton and first-order rogue wave are obtained by the long wave limit in multi-solitons. The dynamics of the first-order rogue wave, second-order rogue wave and interaction between one-soliton and first-order rogue wave are presented by selecting the appropriate parameters. In particular parameters, the positions and the maximum of amplitude of rogue wave can be confirmed by the detail calculations.PACS numbers: 02.30.Ik, 05.45.Yv.

scholarly journals Influence on The Level Riders Motorcycle Accident Traffic with Traffic Methods of Conflict Technique (TCT) (Case Study: Jalan Raya Narogong Bekasi City)

2020 ◽  
Vol 2 (2) ◽  
pp. 184-189
Author(s):  
Andri Irfan Rifai ◽  
Finsa Aziz Fernanda
Keyword(s):  
Traffic Accidents ◽  
Observation Data ◽  
Third Order ◽  
First Order ◽  
The Third ◽  
Motorcycle Accident ◽  
Transportation Sector ◽  
Side Collision ◽  
Traffic Rules

The increasing number of traffic accidents can be caused by drivers, vehicles, highways, and the environment. In Indonesia, traffic accidents become one of the problems in the transportation sector. Prevention is done during this time to anticipate accidents only based on the data of the accident quantity that has occurred. Though factors or incidents that can cause accidents to become the biggest contributor in the event of accidents. For example, driving a vehicle in an unorderly manner, the pace of the vehicle with the above-average velocity set traffic rules, and sudden vehicle maneuvers. This research is done by identifying and analyzing the behavior of motorcyclists who affect accidents and applying TCT methods to observation data at points that become potential locations Against accidents. The research location is on the Narogong Highway which is divided into 2 segments. In Segment 1 begins at junction four Cipendawa (after the flyover Simpang Cipendawa) until the junction of the three Gg. Sawo (Bantar Gebang Market). Next, in Segment 2 starts from junction three of Gg. Sawo (Bantar Gebang Market) until the three houses of Vida housing. The results showed that the research location had potential that could cause the accident to be front-side on the first order, collision front-front on the second-order, and side-by-side collision on the third order. The speed of vehicles has an impact on accidents.

scholarly journals The "third"-order barrier for technology-integration instruction: Implications for teacher education

2012 ◽  
Vol 28 (6) ◽  
Author(s):  
Chin-Chung Tsai ◽  
Ching Sing Chai
Keyword(s):  
Technology Integration ◽  
Design Thinking ◽  
Second Order ◽  
Access Time ◽  
Pedagogical Beliefs ◽  
Third Order ◽  
Education Practice ◽  
First Order ◽  
The Third ◽  
Technology Beliefs

<span>Technology integration is a major trend in contemporary education practice. When undertaking technology integration in classrooms, a first-order barrier and a second-order barrier, as proposed by Ertmer (1999), can hinder its implementation. The first-order barrier is external, such as lack of adequate access, time, training and institutional support. The second-order barrier includes teachers' personal and fundamental beliefs such as teachers' pedagogical beliefs, technology beliefs, willingness to change. This paper argues that the lack of design thinking by teachers may be the "third"-order barrier for technology integration.</span>

The Investigation of Temperature Effect on Dynamic Characteristics of Rubber Isolator

2011 ◽  
Vol 138-139 ◽  
pp. 575-580
Author(s):  
De Bao Han
Keyword(s):  
Interpolation Method ◽  
Dynamic Properties ◽  
Low Frequency ◽  
Model Parameters ◽  
Force Model ◽  
Third Order ◽  
Restoring Force ◽  
First Order ◽  
The Third ◽  
Rubber Isolator

This article focuses on the temperature dependent dynamic properties of rubber isolator. First, a set of experimental device was designed to conduct the experimental investigation. Then, a polynomial model of hysteretic used as an isolator restoring force model was proposed and the model parameters were identified using the displacement-restoring force loop from experiment by the optimal least-squares arithmetic. Finally, the Hermite interpolation method was utilized to add the number of identified parameters, such that curvatures that represent the first order stiffness, the third order stiffness and damping varied with frequency, amplitude under different temperature were obtained. The analysis results indicated that the first order stiffness varies weakly with the temperature increasing, and there is an area of the first order stiffness varied drastically. The third order stiffness have a strong nonlinear area within the low frequency and little amplitude, the third order stiffness magnitude increases with the temperature increasing firstly, then decreases while the temperature over 50°C. There is a sensitive area as the amplitude less than 1.5mm, the damping decreases rapidly with the augmenting of vibration amplitude, and the rate of decreasing is less gradually with the temperature rising.

Contributions of ability and attainment testing in Africa to a general theory of intellect

1969 ◽  
Vol 1 (S1) ◽  
pp. 91-102 ◽  
Author(s):  
S. H. Irvine
Keyword(s):  
General Theory ◽  
Cross Cultural ◽  
Third Order ◽  
Order Analysis ◽  
First Order ◽  
Reasoning Abilities ◽  
The Third ◽  
Factor Analytic ◽  
Similarities And Differences ◽  
Perceptual Styles

SummaryFactor analytic studies in Africa are compared with other cross-cultural investigations into the structure of abilities in different ethnic groups. Similarities and differences are noted; and environmental influences on the acquisition of skills are also summarized. A correlational study of wrong answers to a battery of thirty marker tests given to a group of predominantly Mashona students indicates that efficiency skills of numerical facility and memory remain at the first order of factor extraction, reasoning abilities emerge in second-order analysis, while perceptual styles are present in the third-order level. This study is used to hypothesize, in the context of African systems of thought, the existence of a primary thought mode that asserts itself in conditions involving repeated errors.

Functional hyperemia in striated muscle is reduced following blockade of ATP-sensitive potassium channels

1996 ◽  
Vol 270 (5) ◽  
pp. H1649-H1654 ◽  
Author(s):  
Y. Saito ◽  
M. McKay ◽  
A. Eraslan ◽  
R. L. Hester
Keyword(s):  
Potassium Channels ◽  
Topical Application ◽  
Muscle Stimulation ◽  
Functional Hyperemia ◽  
Cremaster Muscle ◽  
Third Order ◽  
First Order ◽  
The Third ◽  
Arteriolar Diameter

This study was designed to determine the role of ATP-sensitive potassium channels in the control of the arteriolar diameter during functional hyperemia. The hamster cremaster muscle was prepared for in vivo microscopy and stimulated electrically for 1 min before and after topical application of 10 microM glibenclamide to block ATP-sensitive potassium channels. Glibenclamide treatment resulted in a small, though not significant, decrease in resting arteriolar diameter (P > 0.05). Glibenclamide almost completely inhibited the vasodilation of the first-order and the third-order arterioles in response to topical application of 1 microM cromakalim (P < 0.05). During muscle stimulation, the first-order arterioles dilated from 69 +/- 3 to 89 +/- 3 microns (n = 7), and the third-order arterioles dilated from 16 +/- 1 to 35 +/- 2 microns (n = 7). In this set of experiments glibenclamide treatment resulted in a significant decrease (approximately 4 microns) in the resting diameters of the first-order arterioles, but had no significant effect on the resting diameter of third-order arterioles. Glibenclamide treatment significantly attenuated the vasodilation associated with muscle contraction to 72 +/- 3 and to 21 +/- 3 microns, respectively (P < 0.05). These results suggests that ATP-sensitive potassium channels are an important mediator in the vasodilatory response to muscle stimulation in the hamster cremaster muscle.

Sign in / Sign up

Export Citation Format

Share Document