scholarly journals High-sensitivity study of levels in Al30 following β decay of Mg30

2016 ◽  
Vol 94 (5) ◽  
Author(s):  
B. Olaizola ◽  
H. Mach ◽  
L. M. Fraile ◽  
J. Benito ◽  
M. J. G. Borge ◽  
...  
2018 ◽  
Vol 19 (10) ◽  
pp. 1583-1598 ◽  
Author(s):  
Leo Pio D’Adderio ◽  
Gianfranco Vulpiani ◽  
Federico Porcù ◽  
Ali Tokay ◽  
Robert Meneghini

Abstract One of the main goals of the National Aeronautics and Space Administration (NASA) Global Precipitation Measurement (GPM) mission is to retrieve parameters of the raindrop size distribution (DSD) globally. As a standard product of the Dual-Frequency Precipitation Radar (DPR) on board the GPM Core Observatory satellite, the mass-weighted mean diameter Dm and the normalized intercept parameter Nw are estimated in three dimensions at the resolution of the radar. These are two parameters of the three-parameter gamma model DSD adopted by the GPM algorithms. This study investigates the accuracy of the Dm retrieval through a comparative study of C-band ground radars (GRs) and GPM products over Italy. The reliability of the ground reference is tested by using two different approaches to estimate Dm. The results show good agreement between the ground-based and spaceborne-derived Dm, with an absolute bias being generally lower than 0.5 mm over land in stratiform precipitation for the DPR algorithm and the combined DPR–GMI algorithm. For the DPR–GMI algorithm, the good agreement extends to convective precipitation as well. Estimates of Dm from the DPR high-sensitivity (HS) Ka-band data show slightly worse results. A sensitivity study indicates that the accuracy of the Dm estimation is independent of the height above surface (not shown) and the distance from the ground radar. On the other hand, a nonuniform precipitation pattern (interpreted both as high variability and as a patchy spatial distribution) within the DPR footprint is usually associated with a significant error in the DPR-derived estimate of Dm.


1966 ◽  
Vol 21 (1-2) ◽  
pp. 84-90 ◽  
Author(s):  
N. Takaoka ◽  
K. Ogata

In order to determine the half-life of the 130Te double β-decay, the amounts and isotopic composition of xenon extracted from tellurium ores, from the Oya gold mine in Japan, have been measured with a high-sensitivity mass spectrometer. Compared with atmospheric xenon an excess was definitely found at mass numbers 129, 130 and 131 in the extracted xenon. The excess of 130Xe is predominant, the average amount in three samples being (1.32 ± 0.09) × 10-11 ccSTP/g 130Te. Attributing the excess 130Xe to the double β-decay of 130Te, the half-life is estimated to be (8.20 ± 0.64) × 1020 years, assuming an age of (9.06 ± 0.29) × 107 years for the Te ores. The latter value is the K-Ar age of porphyrite, which is in close geological connection with the Te ores.In order to investigate the other excesses than that of 130Xe, isotopic analyses were also carried out on Xe from three other Te ores from the same mine. The ratios (129Xe/131Xe) excess=1.58 and (129Xe/130Xe) excess = 2.1 were found to be the same for all samples. The origin of these excesses is discussed.In addition a small excess of 128Xe was found. If this is attributed to 128Te double β-decay, the half-life of 128Te is estimated to be 3 × 1022 years, a value shorter by about three orders of magnitude than the theoretically expected half-life. The above estimated half-life may be a lower limit of the 128Te half-life.The general tendency of the isotopic abundances (except for the above excesses), of the xenon extracted from Te ores seems to be to slightly increase in excess as one moves toward the lighter isotopes (as compared with atmospheric xenon).


1974 ◽  
Vol 52 (13) ◽  
pp. 1215-1227 ◽  
Author(s):  
A. H. Colenbrander ◽  
T. J. Kennett

The results of a high sensitivity study of the 203Tl(n,γ)204Tl reaction are reported. Attention was focussed upon the detection of low intensity components and the establishment of the absolute intensity for the observed transitions. A technique for deconvolving the spectrum was employed which allows one to transform each spectral component into a simple Gaussian response and to thereby obtain a true representation of the gross spectral shape. The marked deviation of the spectrum from that expected using a simple statistical model is clearly revealed. The neutron separation energy was found to be 6655.8 ± 0.3 keV for 204Tl and 6503.4 ± 0.4 keV for 206Tl.


2021 ◽  
Vol 16 (1) ◽  
Author(s):  
Chen Chong ◽  
Hongxia Liu ◽  
Shulong Wang ◽  
Shupeng Chen

AbstractIn this paper, a dielectric modulated double source trench gate tunnel FET (DM-DSTGTFET) based on biosensor is proposed for the detection of biomolecules. DM-DSTGTFET adopts double source and trench gate to enhance the on-state current and to generate bidirectional current. In the proposed structure, two cavities are etched over 1 nm gate oxide for biomolecules filling. A 2D simulation in the Technology Computer-Aided Design (TCAD) is adopted for the analysis of sensitivity study. The results show that under low supply voltage, the current sensitivity of the DM-DSTGTFET is as high as 1.38 × 105, and the threshold voltage sensitivity can reach 1.2 V. Therefore, the DM-DSTGTFET biosensor has good application prospects due to its low power consumption and high sensitivity.


2011 ◽  
Vol 57 (206) ◽  
pp. 1158-1170 ◽  
Author(s):  
Ondřej Souček ◽  
Zdenék Martinec

AbstractWe revisit the results of the ISMIP-HEINO benchmark by first analyzing the differences in various model outputs using a wavelet-based spectral technique. Second, the ISMIP-HEINO benchmark experiments are recomputed with a novel numerical ice-sheet model based on the SIA-I algorithm that enables both the shallow-ice and a higher-order approximation of the ice-flow equations to be performed. To assess the significance of the higher-order approximation in the ISMIP-HEINO experiment, a numerical sensitivity study for the shallow-ice approximation (SIA) simulations is also carried out. A high sensitivity of the SIA model response to surface temperature perturbations is found. We conclude that the variations in ISMIP-HEINO results are due to the differences in (1) simulated basal temperatures and (2) numerical treatment of the basal sliding condition.


2006 ◽  
Vol 45 ◽  
pp. 1834-1836 ◽  
Author(s):  
A. Borisov ◽  
O. Ivanova ◽  
S. Krutovertsev ◽  
A. Pislyakov

Comparative study of WO3 thick film sensing features obtained by two different methods to ozone content in the air is presented. The thin films of 0.1-0.3 μ were obtained at evaporation temperature of 1100°C and pressure in chamber 1,33x10-8 bar. Films were formed by thick film technology from WO3 based paste. The films sensitivity to ozone is determined by working temperature of sensors. At the same time the characteristic stability depends on time and magnitude of temperature impulse. It was shown, that measurement sensor samples have high sensitivity to 70 ppb of ozone in the air.


1993 ◽  
Vol 47 (5) ◽  
pp. 4219-4226 ◽  
Author(s):  
S. Cavalieri ◽  
M. Matera ◽  
F. S. Pavone ◽  
Jian Zhang ◽  
P. Lambropoulos ◽  
...  

2021 ◽  
Author(s):  
Michelle Anne M. Encinas-Latoy ◽  
Marvin C. Masalunga ◽  
Roland Reuben B. Angeles ◽  
Anna Katrina G. Tojino

Objectives. To determine the overall diagnostic yield of bronchoscopy-guided sampling methods in detecting lung cancer at the University of the Philippines, Philippine General Hospital. The diagnostic yield, equivalent to sensitivity, is defined as the number of bronchoscopic sampling or biopsy procedures with a diagnosis of malignancy divided by the total number of confirmed malignant cases.Methods. This is a cross-sectional, retrospective sensitivity study involving bronchoscopy procedures from January 2014 to December 2018. Surgical Pathology and Cytology Reports of eligible cases were accessed through the institutional Laboratory Information System. Sensitive patient information was omitted, and each case was assigned a unique code. The overall diagnostic yield/sensitivity of bronchoscopy and the diagnostic yield/sensitivity of each technique were calculated.Results. A total of 100 patients satisfied the inclusion and exclusion criteria. Primary lung malignancies are more common in males and the elderly. The most common primary lung cancer is adenocarcinoma (33%). Bronchoscopy, regardless of whether single or multiple techniques were used, has a diagnostic yield of 86% (CI: 77.6-92.1%). Of the individual techniques, those that obtain solid tissues (endobronchial and transbronchial biopsies; 88.2% [CI: 78.1-94.8%] and 80.0% [CI: 28.4-99.5%], respectively) have higher yields compared to techniques that obtain cytologic samples (bronchial washing and brushing; 54.2% [43.7-64.4%] and 70.1% [58.6-80%], respectively).Conclusion. Bronchoscopy, as a diagnostic procedure for pulmonary malignancies, has relatively high sensitivity and may be used for lesions located centrally and can be inspected visually. A multidisciplinary approach to patient selection for bronchoscopy helps improve the utility of the various bronchoscopic techniques.


Sign in / Sign up

Export Citation Format

Share Document