A Switching Control Scheme for the Synchronization of Serially Connected Multi-Stage System

Author(s):  
Lu Di ◽  
Shen Tielong ◽  
Fu Minyue
1990 ◽  
Vol 22 (3-4) ◽  
pp. 65-72 ◽  
Author(s):  
H.-H. Schierup ◽  
H. Brix

Since 1983 approximately 150 full-scale emergent hydrophyte based wastewater treatment plants (reed beds) have been constructed in Denmark to serve small wastewater producers. The development of purification performance for 21 plants representing different soil types, vegetation, and hydraulic loading rates has been recorded. Cleaning efficiencies were typically in the range of 60-80% reduction for BOD, 25-50% reduction for total nitrogen, and 20-40% reduction for total phosphorus. The mean effluent BOD, total nitrogen and total phosphorus concentrations of the reed beds were 19 ± 10, 22 ± 9 and 6.7 ± 3.2 mg/l (mean ± SD), respectively. Thus, the general Danish effluent standards of 8 mg/l for N and 1.5 mg/l for P for sewage plants greater than 5,000 PE cannot be met by the present realised design of EHTS. The main problem observed in most systems is a poor development of horizontal hydraulic conductivity in the soil which results in surface run-off. Since the political demands for effluent quality will be more strict in the future, it is important to improve the performance of small decentral sewage treatment plants. On the basis of experiences from different types of macrophyte based and conventional low-technology wastewater treatment systems, a multi-stage system is suggested, consisting of sedimentation and sand filtration facilities followed by basins planted with emergent and submergent species of macrophytes and algal ponds.


Processes ◽  
2021 ◽  
Vol 9 (2) ◽  
pp. 395
Author(s):  
Feng Cheng ◽  
Boqing Ding ◽  
Xiuwei Li

An absorption air-conditioning system is a good choice for green buildings. It has the superiority in the utilization of renewable energy and the refrigerant is environment-friendly. However, the performance of the traditional absorption system has been restricted by the energy waste in the thermal regeneration process. Capacitive deionization (CDI) regeneration is proposed as a potential method to improve system efficiency. In the new method-based air-conditioning system, strong absorbent solutions and pure water are acquired with the joint work of two CDI units. Nevertheless, the practical CDI device is composed of a lot of CDI units, which is quite different from the theoretical model. To reveal the performance of multiple CDI units, the model of the double/multi-stage CDI system has been developed. Analysis has been made to expose the influence of some key parameters. The results show the double-stage system has better performance than the single-stage system under certain conditions. The coefficient of performance (COP) could exceed 4.5, which is higher than the traditional thermal energy-driven system, or even as competitive as the vapor compression system. More stages with proper voltage distribution better the performance. It also provides the optimization method for the multi-stage CDI system.


2020 ◽  
Vol 53 (2) ◽  
pp. 6428-6433
Author(s):  
Zongyi Guo ◽  
David Henry ◽  
Jianguo Guo ◽  
Zheng Wang ◽  
Jérôme Cieslak ◽  
...  

Automatica ◽  
2017 ◽  
Vol 84 ◽  
pp. 190-198 ◽  
Author(s):  
Chang Tan ◽  
Gang Tao ◽  
Ruiyun Qi ◽  
Hui Yang

Author(s):  
Bo Zhu ◽  
Kai-Yuan Cai

In the paper, we show that for a class of linear plants, although the common linear control can be used to stabilize them, the step responses of the resulting closed-loop systems must have overshoot; however, a simple switching between them may avoid the overshoot. This indicates that switching control may overcome the performance limitation of linear feedback control in the overshoot-avoidance respect. A simple switching control scheme with such a quality is exploited and the conditions for its existence are presented. In the scheme, two common controllers are needed and they are only required to guarantee no overshoot on the time intervals [0, ts) and [ts, ∞), respectively, where ts denotes the switching time. For actual implementation, a state-dependent version of the switching control law is developed. Two examples are presented to show its effectiveness.


1978 ◽  
Vol 10 (2) ◽  
pp. 208-213 ◽  
Author(s):  
Andrew Z. Szendrovits ◽  
Suresh K. Goyal
Keyword(s):  

Author(s):  
Yonit Barron

Fork-Join queue networks (F-J) have received increasing attention during the last Decade, due to their ability to model parallel and distributed computer processing, supply chains and assembly systems. However, most research is focused on a single stage processing, and only scant work exists on F-J with two or more stages. In this paper, the author investigates (through simulation) the performance behavior of a multi-stage system; in particular, the performance of a synchronized system is compared to an unsynchronized system regarding three major factors: (1) the number of parallel tasks; (2) the number of serial stages and (3) the utilization.


Symmetry ◽  
2019 ◽  
Vol 11 (4) ◽  
pp. 565 ◽  
Author(s):  
Krmac ◽  
Djordjević

Supply Chain Management (SCM) represents an example of a complex multi-stage system. The SCM involves and connects different activities, from customer’s orders to received services, all with the aim of satisfying customers. The evaluation of a particular SCM is a complex problem because of the internally linked hierarchical activities and multiple entities. In this paper, the introduction of a non-radial DEA (Data Envelopment Analysis) model for the evaluation of different components of SCM, primarily in terms of sustainability, is the main contribution. However, in order to confirm the novelty and benefits of this new model in the field of SCM, a literature review of past applications of DEA-based models and methods are also presented. The non-radial DEA model was applied for the selection and evaluation of the environmental efficiency of suppliers considering undesirable inputs and outputs resulting in a better ranking of suppliers. Via perturbation of the data used, behavior, as well as the benefits and weaknesses of the introduced model are presented through sensitivity analysis.


Sign in / Sign up

Export Citation Format

Share Document