Finite-time settling control scheme of low pass filter-related state variables for current-source three-phase PWM PFC converter and its performance evaluations

2002 ◽  
Author(s):  
K. Nishida ◽  
Y. Konishi ◽  
M. Nakaoka
Keyword(s):  
Finite Time ◽  
Current Source ◽  
Performance Evaluations ◽  
State Variables ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Three Phase ◽  
Control Scheme ◽  
Low Pass

scholarly journals Improvement of DSOGI PLL Synchronization Algorithm with Filter on Three-Phase Grid-connected Photovoltaic System

2018 ◽  
Vol 18 (1) ◽  
pp. 35 ◽  
Author(s):  
Rofiatul Izah ◽  
Subiyanto Subiyanto ◽  
Dhidik Prastiyanto
Keyword(s):  
Reference Frame ◽  
Frequency Estimation ◽  
Photovoltaic System ◽  
Positive Sequence ◽  
Pv System ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Synchronous Reference Frame ◽  
Three Phase ◽  
Low Pass

Synchronous Reference Frame Phase Locked Loop (SRF PLL) has been widely used for synchronization three-phase grid-connected photovoltaic (PV) system. On the grid fault, SRF PLL distorted by negative sequence component and grid harmonic that caused an error in estimating parameter because of ripple and oscillation. This work combined SRF PLL with Dual Second Order Generalized Integrator (DSOGI) and filter to minimize ripple and minimize oscillation in the phase estimation and frequency estimation. DSOGI was used for filtering and obtaining the 90o shifted versions from the vαβ signals. These signals (vαβ) were generated from three phase grid voltage signal using Clarke transform. The vαβ signal was the inputs to the positive-sequence calculator (PSC). The positive-sequence vαβ was transformed to the dq synchronous reference frame and became an input to SRF-PLL to create the estimation frequency. This estimation frequency from SRF PLL was filtered by the low-pass filter to decrease grid harmonic. Moreover, the output of low-pass filter was a frequency adaptive. The performance of DSOGI PLL with filter is compared with DSOGI PLL, SRF PLL, and IEEE standard 1547(TM)-2003. The improvement of DSOGI PLL with filter gave better performances than DSOGI PLL and SRF PLLbecause it minimized ripples and oscillations in the phase and frequency estimations.

Adaptive Low-Pass Filter Based DC Offset Removal Technique for Three-Phase PLLs

2018 ◽  
Vol 65 (11) ◽  
pp. 9025-9029 ◽  
Author(s):  
Parag Kanjiya ◽  
Vinod Khadkikar ◽  
Mohamed Shawky El Moursi
Keyword(s):  
Pass Filter ◽  
Low Pass Filter ◽  
Dc Offset ◽  
Three Phase ◽  
Low Pass ◽  
Removal Technique

Fuzzy Logic Controller for Dynamic Positioning of an Offshore Supply Vessel

2017 ◽  
Author(s):  
Kunal N. Tiwari ◽  
Parameswaran Krishnankutty
Keyword(s):  
Fuzzy Logic Controller ◽  
Fuzzy Controller ◽  
Dynamic Positioning ◽  
Positioning System ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Dynamic Positioning System ◽  
Wave Disturbances ◽  
Control Scheme ◽  
Low Pass

The purpose of this paper is to examine the performance of fuzzy controller applied to a dynamic positioning system of ship by numerical simulation. By definition, dynamic positioning system is computer controlled system which uses the active thrusters to automatically maintain the position and heading of the ship. The proposed control scheme consist of low pass filter in cascade with three proportional derivative type fuzzy controller with Mamdani type inference scheme. Feed-forward compensation decoupling scheme is employed to reduce coupling between sway and yaw. Robustness of control scheme is assessed for Cybership II in presence of wave disturbances.

Design of a Sine Sweeping Constant Current Source Based FPGA and DDS

2014 ◽  
Vol 936 ◽  
pp. 2230-2234
Author(s):  
Ya Ping Yu ◽  
Hui Zhao ◽  
Yuan Liu ◽  
Ren Jie Yang ◽  
Gui Mei Dong ◽  
...  
Keyword(s):  
Frequency Control ◽  
Current Source ◽  
Sine Wave ◽  
Constant Current ◽  
Constant Current Source ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Low Pass ◽  
Fpga Chip ◽  
Sine Wave Generator

This paper designed a range of 0.1 ~ 250 kHz sine wave sweeping constant current source, which sine wave generator based on FPGA chip and DDS technology, the desired sine wave frequency was obtained by controlling the frequency control words. Low-pass filter circuit was realized by using the LTC1560-1, conversion circuit from the voltage to the current was consisted of a Howland current pump. The constant current source shows a good spectral impedance purity and amplitude.

The Analysis and Design of Three-Phase Static Inverter Deadband Effect and Harmonic Suppression

2013 ◽  
Vol 575-576 ◽  
pp. 293-296
Author(s):  
Qun Min Yan
Keyword(s):  
Control Method ◽  
Design Method ◽  
Harmonic Suppression ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Analysis And Design ◽  
Three Phase ◽  
Low Pass ◽  
Harmonic Components ◽  
Simulated Analysis

in order to solve the problem of three-phase static inverter output waveform distortion, detailed analyzed of the voltage distortion caused by the deadband effect and the resulting harmonic components. The control method is proposed to set the deadband time combining with the voltage compensation, while in order to improve the inverter output, the converter output to design a trap filter and a low pass filter cascaded filtering circuit. Simulated analysis the entire system though Saber, using the digital chip TMS320F2812 to achieve appropriate compensation strategies, simulation results and experimental results have all proved the effectiveness of the design method.

scholarly journals Adaptive anti-disturbance control for a class of unknown pure feedback switched nonlinear systems

2021 ◽  
Author(s):  
Longsheng Chen
Keyword(s):  
Nonlinear Systems ◽  
Design Method ◽  
Tracking Error ◽  
Average Dwell Time ◽  
Switched Nonlinear Systems ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Control Scheme ◽  
Low Pass ◽  
Set Up

Abstract In this study, an adaptive anti-disturbance control scheme is investigated for a class of unknown pure feedback switched nonlinear systems subjected to immeasurable states and external disturbances. Radial basis function neural networks (RBFNNs) are employed to identify the switched unknown nonlinearities, and a Butterworth low-pass filter is adopted to remove the algebraic loop problem. Subsequently, a novel switched neural state observer and a novel switched disturbance are presented via the coupled design method to estimate the immeasurable states and compounded disturbances. Then, an improved adaptive control strategy for the studied problem is designed with the help of a filtering method to eliminate the “explosion of complexity” problem, and certain compensating signals are set up to compensate for the filter errors, where switched updated laws are constructed to lessen the conservativeness caused by adoption of a common updated law for all subsystems. By utilizing the Lyapunov stability theorem, the developed control scheme can guarantee that all signals in the closed-loop system are bounded under a class of switching signals with the average dwell time (ADT), while the tracking error can converge to a small neighbourhood of origin. Finally, simulation results are provided to demonstrate the effectiveness of the presented approach.

Relay Feedback Oscillator Design for Modeling Circadian Rhythms in Cyanobacteria

2011 ◽  
Author(s):  
Jaromir Fiser ◽  
Pavel Zitek ◽  
Jan Cerveny
Keyword(s):  
Circadian Rhythms ◽  
Negative Feedback ◽  
Stability Margin ◽  
State Variables ◽  
Relay Feedback ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Single Loop ◽  
Low Pass ◽  
Autoregulatory Mechanism

The paper introduces a relay feedback oscillator for modeling circadian rhythms in cyanobacteria. The relay feedback oscillator is equipped with low pass filter F(jω), hysteresis-type relay and negative feedback. This negative feedback represents an autoregulatory mechanism of the circadian clock and the notion of this autoregulatory mechanism is based on the well-known Goodwin biochemical oscillator [1]. The relay is responsible for the mediation of both the activation and degradation of oscillator state variables (protein concentrations) and in this way the pacemaker is constituted. Later on, low pass filter poles are identified for the purpose of modeling auto-oscillations with the free running period of 24h and the method of the pole identification consists in an ultimate frequency test providing stability margin of a single-loop composed of the filter and the relay in the feedback. Next, a relay output / input ratio of amplitudes and hysteresis are found out by the graphical test of the single-loop on the stability margin which is carried out in Bode graph. Finally, the output correspondence of relay feedback oscillator model with Miyoshi oscillator [2] is provided because the Miyoshi oscillator is well recognized among biochemical oscillators for species of cyanobacteria.

DC-Bus Voltage Control Strategy Based on Low-Pass Filter for Three-Phase Four-Wire APF

2013 ◽  
Vol 732-733 ◽  
pp. 1167-1170
Author(s):  
Xia Feng ◽  
Xiao Jian Zhong ◽  
Qun Wei Xu ◽  
Guo Zhu Chen
Keyword(s):  
Voltage Control ◽  
Stable Operation ◽  
Voltage Control Strategy ◽  
Signal Model ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Three Phase ◽  
Low Pass ◽  
Dc Bus ◽  
Bus Voltage

The DC-bus voltage control is critical for stable operation of the three-phase four-wire Active Power Filter. DC-bus stable voltage loop and balance voltage loop are established based on the small signal model. Considering the disadvantages of the traditional PI control, second-order low-pass filter is introduced into the proposed controller. Simulation and experimental results are conducted to validate the effectiveness of the proposed strategy.

scholarly journals Higher-Order Sliding Mode Observer for Speed and Position Estimation in PMSM

2014 ◽  
Vol 2014 ◽  
pp. 1-12 ◽  
Author(s):  
Suneel K. Kommuri ◽  
Kalyana C. Veluvolu ◽  
M. Defoort ◽  
Yeng C. Soh
Keyword(s):  
Sliding Mode ◽  
Permanent Magnet Synchronous Motor ◽  
Estimation Method ◽  
Higher Order ◽  
Position Estimation ◽  
Accurate Estimation ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Three Phase ◽  
Low Pass

This paper presents a speed and position estimation method for the permanent magnet synchronous motor (PMSM) based on higher-order sliding mode (HOSM) observer. The back electromotive forces (EMFs) in the PMSM are treated as unknown inputs and are estimated with the HOSM observer without the need of low-pass filter and phase compensation modules. With the estimation of back EMFs, an accurate estimation of speed and rotor position can be obtained. Further, the proposed method completely eliminates chattering. Experimental results with a 26 W three-phase PMSM demonstrate the effectiveness of the proposed method.

Sign in / Sign up

Export Citation Format

Share Document