Two-dimensional Pulmonary Artery Velocity Profiles Tn Growing Lambs

Author(s):  
B. Ha ◽  
C.L. Lucas ◽  
G.W. Henry ◽  
A.P. Yoganathan ◽  
J.I. Ferreiro ◽  
...  
1969 ◽  
Vol 35 (2) ◽  
pp. 225-241 ◽  
Author(s):  
M. A. Badri Narayanan ◽  
V. Ramjee

Experiments on reverse transition were conducted in two-dimensional accelerated incompressible turbulent boundary layers. Mean velocity profiles, longitudinal velocity fluctuations $\tilde{u}^{\prime}(=(\overline{u^{\prime 2}})^{\frac{1}{2}})$ and the wall-shearing stress (TW) were measured. The mean velocity profiles show that the wall region adjusts itself to laminar conditions earlier than the outer region. During the reverse transition process, increases in the shape parameter (H) are accompanied by a decrease in the skin friction coefficient (Cf). Profiles of turbulent intensity (u’2) exhibit near similarity in the turbulence decay region. The breakdown of the law of the wall is characterized by the parameter \[ \Delta_p (=\nu[dP/dx]/\rho U^{*3}) = - 0.02, \] where U* is the friction velocity. Downstream of this region the decay of $\tilde{u}^{\prime}$ fluctuations occurred when the momentum thickness Reynolds number (R) decreased roughly below 400.


Author(s):  
M. M. Al-Mudhafar ◽  
M. Ilyas ◽  
F. S. Bhinder

The results of an experimental study on the influence of severely distorted velocity profiles on the performance of a straight two-dimensional diffuser are reported. The data cover entry Mach numbers ranging from 0.1 to 0.6 and several inlet distortion levels. The pressure recovery progressively deteriorates as the inlet velocity is distorted.


1974 ◽  
Vol 56 (5) ◽  
pp. 1389-1390
Author(s):  
L. P. Solomon ◽  
A. Barnes ◽  
S. Port

1994 ◽  
Vol 24 (2) ◽  
pp. 532-545 ◽  
Author(s):  
W.Yong Kim ◽  
Thue Bisgaard ◽  
Sten L. Nielsen ◽  
Jens K. Poulsen ◽  
Erik M. Pedersen ◽  
...  

1964 ◽  
Vol 20 (2) ◽  
pp. 201-208 ◽  
Author(s):  
J. L. Livesey ◽  
J. T. Turner

The logical design method of Owen & Zienkiewicz (1957), for the generation of linear shear flow, is successfully applied to the case of symmetrical velocity profiles in a two-dimensional duct. Shear parameters as high as 0·8 (corresponding to $\hat{V}| \overline {V} = 1\cdot4$) are obtained experimentally. Some slight modification to the theoretical grid spacing is required because of the non-uniformity of the upstream flow.The decay of the profiles is confined to that due to the developing boundary layer and to the breakdown of the physically impossible condition at the centre, where symmetry implies a change in sign of the uniform shear.


A phenomenon of boundary-layer instability is discussed from the theoretical and experimental points of view. The china-clay evaporation technique shows streaks on the surface, denoting a vortex system generated in the region of flow upstream of transition. Experiments on a swept wing are described briefly, while experiments on the flow due to a rotating disk receive much greater attention. In the latter case, the axes of the disturbance vortices take the form of equi-angular spirals, bounded by radii of instability and of transition. A frequency analysis of the disturbances shows that there is a narrow band of disturbance components of high amplitude, some frequencies within this band corresponding to disturbances fixed relative to the surface and others corresponding to moving waves. Furthermore, the determination of velocity profiles for the rotating-disk flow is described, the agreement with the theoretical solution for laminar flow being quite satisfactory; for turbulent flow, however, the empirical theories are not very satisfactory. In order to explain the vortex phenomenon just discussed, the general equations of motion in orthogonal curvilinear co-ordinates are examined by superimposing an infinitesimal disturbance periodic in space and time on the main flow, and linearizing for small disturbances. An important result is that, within the range of certain approximations, the velocity component in the direction of propagation of the disturbance may be regarded as a two-dimensional flow for stability purposes; then the problem of stability formally resembles the well-known two dimensional problem. However, it is important to emphasize that this result—namely, that the flow curvature has little influence on stability—is applicable only to the possible modes of instability in a local region. The nature of three-dimensional flows is discussed, and the importance of co-ordinates along and normal to the stream-lines outside the boundary layer is examined. In accord with the formal two-dimensional nature of the instability, there is a whole class of velocity distributions, corresponding to different directions, which may exhibit instability. The question of stability at infinite Reynolds number is examined in detail for these profiles. As for ordinary two-dimensional flows, the wave velocity of the disturbance must lie somewhere between the maximum and minimum of the velocity profile considered. The points where the wave velocity equals the fluid velocity are called critical points, of which most of the profiles considered have two. Then Tollmien’s criterion that velocity profiles with a point of inflexion are unstable at infinite Reynolds number is extended to the case of profiles with two critical points. One particular profile—namely, that for which the point of inflexion lies at the point of zero velocity—may generate neutral disturbances of zero phase velocity, corresponding to the disturbances visualized by the china-clay technique. A variational method for the solution of certain of the eigenvalue problems associated with stability at infinite Reynolds number is derived, found by comparison with an exact solution to be very accurate, and applied to the rotating disk. The fixed vortices predicted by the theory have as their axes equi-angular spirals of angle 103°, in good agreement with experiment, but the agreement between theoretical and experimental wave number is not good, the discrepancy being attributed to viscosity. Finally, the correlation between the experimentally observed and theoretically possible disturbances is discussed and certain conclusions drawn therefrom. The streamlines of the disturbed boundary layer show the existence of a double row of vortices, one row of which produces the streaks in the china clay. Application of the theory to other physical phenomena is described.


2009 ◽  
Vol 131 (12) ◽  
Author(s):  
Gopi Krishnan ◽  
Kamran Mohseni

In this paper the flow field of a rectangular synthetic jet driven by a piezoelectric membrane issuing into a quiescent environment is studied. The similarities exhibited by synthetic and continuous turbulent jets lead to the hypothesis that a rectangular synthetic jet within a limited region downstream of the orifice be modeled using similarity analysis just as a continuous planar jet. Accordingly, the jet is modeled using the classic two-dimensional solution to a continuous jet, where the virtual viscosity coefficient of the continuous turbulent jet is replaced with that measured for a synthetic jet. The virtual viscosity of the synthetic jet at a particular axial location is related to the spreading rate and velocity decay rate of the jet. Hot-wire anemometry is used to characterize the flow downstream of the orifice. The flow field of rectangular synthetic jets is thought to consist of four regions as distinguished by the centerline velocity decay. The regions are the developing, the quasi-two-dimensional, the transitional, and the axisymmetric regions. It is in the quasi-two-dimensional region that the planar model applies, and where indeed the jet exhibits self-similar behavior as distinguished by the collapse of the lateral time average velocity profiles when scaled. Furthermore, within this region the spanwise velocity profiles display a saddleback profile that is attributed to the secondary flow generated at the smaller edges of the rectangular orifice. The scaled spreading and decay rates are seen to increase with stroke ratio and be independent of Reynolds number. However, the geometry of the actuator is seen to additionally affect the external characteristics of the jet. The eddy viscosities of the synthetic jets under consideration are shown to be larger than equivalent continuous turbulent jets. This enhanced eddy viscosity is attributed to the additional mixing brought about by the introduction of the periodic vortical structures in synthetic jets and their ensuing break down and transition to turbulence. Further, a semi-empirical modeling approach is proposed, the final objective of which is to obtain a functional relationship between the parameters that describe the external flow field of the synthetic jet and the input operational parameters to the system.


1976 ◽  
Vol 76 (2) ◽  
pp. 383-399 ◽  
Author(s):  
K. G. Ranga Raju ◽  
J. Loeser ◽  
E. J. Plate

The properties of a turbulent boundary layer were investigated as they relate to the form drag on a two-dimensional fence. Detailed measurements were performed at zero pressure gradient of velocity profiles along smooth, rough and transitional flat plates. Upon comparison with other published data, these measurements resulted in simple formulae for the displacement thickness and the local shear coefficient and in a modification to the universal velocity defect law for equilibrium boundary layers.With these boundary layers, experiments were performed to determine the drag on a two-dimensional fence. These data were analysed along with data from previous investigations. It was found that after suitable blockage corrections all form-drag coefficients for two-dimensional fences collapsed on a single curve if they were calculated with the shear velocity as the reference velocity and plotted against the ratio of the fence height to the characteristic roughness parameter of the approaching flow.


Sign in / Sign up

Export Citation Format

Share Document