Combined modeling for electrical load forecasting with particle swarm optimization

Author(s):  
Liye Xiao ◽  
Liyang Xiao
2021 ◽  
Vol 2021 ◽  
pp. 1-10
Author(s):  
Zahra Shafiei Chafi ◽  
Hossein Afrakhte

Electrical load forecasting plays a key role in power system planning and operation procedures. So far, a variety of techniques have been employed for electrical load forecasting. Meanwhile, neural-network-based methods led to fewer prediction errors due to their ability to adapt properly to the consuming load's hidden characteristic. Therefore, these methods were widely accepted by the researchers. As the parameters of the neural network have a significant impact on its performance, in this paper, a short-term electrical load forecasting method using neural network and particle swarm optimization (PSO) algorithm is proposed, in which some neural network parameters including learning rate and number of hidden layers are determined in order to forecast electrical load using the PSO algorithm precisely. Then, the neural network with these optimized parameters is used to predict the short-term electrical load. In this method, a three-layer feedforward neural network trained by backpropagation algorithm is used beside an improved gbest PSO algorithm. Also, the neural network prediction error is defined as the PSO algorithm cost function. The proposed approach has been tested on the Iranian power grid using MATLAB software. The average of three indices beside graphical results has been considered to evaluate the performance of the proposed method. The simulation results reflect the capabilities of the proposed method in accurately predicting the electrical load.


2018 ◽  
Vol 13 ◽  
pp. 174830181879706 ◽  
Author(s):  
Song Qiang ◽  
Yang Pu

In this work, we summarized the characteristics and influencing factors of load forecasting based on its application status. The common methods of the short-term load forecasting were analyzed to derive their advantages and disadvantages. According to the historical load and meteorological data in a certain region of Taizhou, Zhejiang Province, a least squares support vector machine model was used to discuss the influencing factors of forecasting. The regularity of the load change was concluded to correct the “abnormal data” in the historical load data, thus normalizing the relevant factors in load forecasting. The two parameters are as follows Gauss kernel function and Eigen parameter C in LSSVM had a significant impact on the model, which was still solved by empirical methods. Therefore, the particle swarm optimization was used to optimize the model parameters. Taking the error of test set as the basis of judgment, the optimization of model parameters was achieved to improve forecast accuracy. The practical examples showed that the method in the work had good convergence, forecast accuracy, and training speed.


2018 ◽  
Vol 173 ◽  
pp. 02016
Author(s):  
Jin Liang ◽  
Wang Yongzhi ◽  
Bao Xiaodong

The common method of power load forecasting is the least squares support vector machine, but this method is very dependent on the selection of parameters. Particle swarm optimization algorithm is an algorithm suitable for optimizing the selection of support vector parameters, but it is easy to fall into the local optimum. In this paper, we propose a new particle swarm optimization algorithm, it uses non-linear inertial factor change that is used to optimize the algorithm least squares support vector machine to avoid falling into the local optimum. It aims to make the prediction accuracy of the algorithm reach the highest. The experimental results show this method is correct and effective.


Sign in / Sign up

Export Citation Format

Share Document