scholarly journals SimRIS Channel Simulator for Reconfigurable Intelligent Surface-Empowered Communication Systems

2020 ◽  
Author(s):  
Ertugrul Basar ◽  
Ibrahim Yildirim
Keyword(s):  
Communication Systems ◽  
Channel Simulator

scholarly journals Statistical Modeling, Simulation, and Experimental Verification of Wideband Indoor Mobile Radio Channels

2018 ◽  
Vol 2018 ◽  
pp. 1-13
Author(s):  
Yuanyuan Ma ◽  
Bjørn Olav Hogstad ◽  
Matthias Pätzold ◽  
Pedro M. Crespo
Keyword(s):  
Fading Channels ◽  
Experimental Verification ◽  
Communication Systems ◽  
Channel Model ◽  
Reference Model ◽  
Propagation Path ◽  
60 Ghz ◽  
Angle Of Arrival ◽  
Modeling Simulation ◽  
Channel Simulator

This paper focuses on the modeling, simulation, and experimental verification of wideband single-input single-output (SISO) mobile fading channels for indoor propagation environments. The indoor reference channel model is derived from a geometrical rectangle scattering model, which consists of an infinite number of scatterers. It is assumed that the scatterers are exponentially distributed over the two-dimensional (2D) horizontal plane of a rectangular room. Analytical expressions are derived for the probability density function (PDF) of the angle of arrival (AOA), the PDF of the propagation path length, the power delay profile (PDP), and the frequency correlation function (FCF). An efficient sum-of-cisoids (SOC) channel simulator is derived from the nonrealizable reference model by employing the SOC principle. It is shown that the SOC channel simulator approximates closely the reference model with respect to the FCF. The SOC channel simulator enables the performance evaluation of wideband indoor wireless communication systems with reduced realization expenditure. Moreover, the rationality and usefulness of the derived indoor channel model is confirmed by various measurements at 2.4, 5, and 60 GHz.

scholarly journals Design of Wideband MIMO Car-to-Car Channel Models Based on the Geometrical Street Scattering Model

2012 ◽  
Vol 2012 ◽  
pp. 1-11 ◽  
Author(s):  
Nurilla Avazov ◽  
Matthias Pätzold
Keyword(s):  
Correlation Function ◽  
Communication Systems ◽  
Channel Model ◽  
Reference Model ◽  
Multiple Input Multiple Output ◽  
Measurement Data ◽  
Scattering Model ◽  
Time Frequency ◽  
Comparison Results ◽  
Channel Simulator

We propose a wideband multiple-input multiple-output (MIMO) car-to-car (C2C) channel model based on the geometrical street scattering model. Starting from the geometrical model, a MIMO reference channel model is derived under the assumption of single-bounce scattering in line-of-sight (LOS) and non-LOS (NLOS) propagation environments. The proposed channel model assumes an infinite number of scatterers, which are uniformly distributed in two rectangular areas located on both sides of the street. Analytical solutions are presented for the space-time-frequency cross-correlation function (STF-CCF), the two-dimensional (2D) space CCF, the time-frequency CCF (TF-CCF), the temporal autocorrelation function (ACF), and the frequency correlation function (FCF). An efficient sum-of-cisoids (SOCs) channel simulator is derived from the reference model. It is shown that the temporal ACF and the FCF of the SOC channel simulator fit very well to the corresponding correlation functions of the reference model. To validate the proposed channel model, the mean Doppler shift and the Doppler spread of the reference model have been matched to real-world measurement data. The comparison results demonstrate an excellent agreement between theory and measurements, which confirms the validity of the derived reference model. The proposed geometry-based channel simulator allows us to study the effect of nearby street scatterers on the performance of C2C communication systems.

scholarly journals A Non-WSSUS Channel Simulator for V2X Communication Systems

Electronics ◽  
2020 ◽  
Vol 9 (8) ◽  
pp. 1190
Author(s):  
José Jimmy Jaime-Rodríguez ◽  
Carlos Antonio Gómez-Vega ◽  
Carlos A. Gutiérrez ◽  
José Martín Luna-Rivera ◽  
Daniel Ulises Campos-Delgado ◽  
...  
Keyword(s):  
Fading Channels ◽  
Communication Systems ◽  
Multipath Fading ◽  
Ieee 802.11P ◽  
Isotropic Scattering ◽  
Wide Sense ◽  
Multicarrier Transmission ◽  
Temporal Averaging ◽  
Ber Performance ◽  
Channel Simulator

This paper presents a simulator of non-wide sense stationary uncorrelated scattering (non-WSSUS) multipath fading channels for the performance analysis of vehicle-to-everything (V2X) communication systems. The proposed simulator is constructed with the combination of the Monte Carlo and sum-of-cisoids (SOC) principles, and it is suitable for multicarrier transmission schemes such as those defined for dedicated short-range communications (DSRC) and cellular-based V2X (C-V2X) communications. The channel simulator provides an accurate and flexible solution to reproduce the time and frequency (TF) correlation properties of non-WSSUS vehicular channels under arbitrary isotropic and non-isotropic scattering conditions. Furthermore, the proposed simulator allows velocity variations and non-linear trajectories of the mobile stations (MSs). To demonstrate the practical value of the presented simulator, we evaluate the bit error rate (BER) performance of two channel estimation techniques that are considered for IEEE 802.11p transceivers, namely the least squares (LS) estimator and the spectral temporal averaging (STA) technique. The BER performance of both channel estimators was analyzed by considering three propagating scenarios for road safety applications. Our results show that the non-stationary characteristics of the vehicular multipath fading channel have nearly no effects on the LS estimator’s BER performance. In contrast, the performance of the STA estimator is significantly affected by the channel’s non-stationary characteristics. A variation of the original STA technique that applies only a temporal averaging is introduced in this work to improve the system’s BER in non-WSSUS channels.

Plant peptide hormone signalling

2015 ◽  
Vol 58 ◽  
pp. 115-131 ◽  
Author(s):  
Ayane Motomitsu ◽  
Shinichiro Sawa ◽  
Takashi Ishida
Keyword(s):  
Communication Systems ◽  
Cell Communication ◽  
Peptide Hormone ◽  
Peptide Hormones ◽  
Target Cells ◽  
Signalling Molecules ◽  
Receptor Complexes ◽  
Environmental Responses ◽  
Plant Life Cycle ◽  
Multicellular Organisms

The ligand–receptor-based cell-to-cell communication system is one of the most important molecular bases for the establishment of complex multicellular organisms. Plants have evolved highly complex intercellular communication systems. Historical studies have identified several molecules, designated phytohormones, that function in these processes. Recent advances in molecular biological analyses have identified phytohormone receptors and signalling mediators, and have led to the discovery of numerous peptide-based signalling molecules. Subsequent analyses have revealed the involvement in and contribution of these peptides to multiple aspects of the plant life cycle, including development and environmental responses, similar to the functions of canonical phytohormones. On the basis of this knowledge, the view that these peptide hormones are pivotal regulators in plants is becoming increasingly accepted. Peptide hormones are transcribed from the genome and translated into peptides. However, these peptides generally undergo further post-translational modifications to enable them to exert their function. Peptide hormones are expressed in and secreted from specific cells or tissues. Apoplastic peptides are perceived by specialized receptors that are located at the surface of target cells. Peptide hormone–receptor complexes activate intracellular signalling through downstream molecules, including kinases and transcription factors, which then trigger cellular events. In this chapter we provide a comprehensive summary of the biological functions of peptide hormones, focusing on how they mature and the ways in which they modulate plant functions.

Instruction Using Augmentative and Alternative Communication Supports: Description of Current Practices by Speech-Language Pathologists Who Work With Children With Autism Spectrum Disorder

2020 ◽  
Vol 29 (2) ◽  
pp. 586-596 ◽  
Author(s):  
Kaitlyn A. Clarke ◽  
Diane L. Williams
Keyword(s):  
Autism Spectrum Disorder ◽  
Augmentative And Alternative Communication ◽  
Communication Systems ◽  
Diagnostic Category ◽  
Children With Autism ◽  
Autism Spectrum ◽  
Spectrum Disorder ◽  
Alternative Communication ◽  
Speech Language Pathologists ◽  
Processing Differences

Purpose The aim of this research study was to examine common practices of speech-language pathologists (SLPs) who work with children with autism spectrum disorder (ASD) with respect to whether or not SLPs consider processing differences in ASD or the effects of input during their instruction. Method Following a qualitative research method, how SLPs instruct and present augmentative and alternative communication systems to individuals with ASD, their rationale for method selection, and their perception of the efficacy of selected interventions were probed. Semistructured interviews were conducted as part of an in-depth case report with content analysis. Results Based on completed interviews, 4 primary themes were identified: (a) instructional method , (b) input provided , (c) decision-making process , and (d) perceived efficacy of treatment . Additionally, one secondary theme, training and education received , was identified . Conclusions Clinicians reported making decisions based on the needs of the child; however, they also reported making decisions based on the diagnostic category that characterized the child (i.e., ASD). The use of modeling when teaching augmentative and alternative communication to individuals with ASD emerged as a theme, but variations in the method of modeling were noted. SLPs did not report regularly considering processing differences in ASD, nor did they consider the effects of input during instruction.

Sign in / Sign up

Export Citation Format

Share Document