Nuclear Radiation Damage to Ruby Lasers

1970 ◽  
Vol 17 (6) ◽  
pp. 222-226 ◽  
Author(s):  
J. J. Halpin ◽  
R. F. Wenzel
1961 ◽  
Vol 34 (1) ◽  
pp. 250-264 ◽  
Author(s):  
W. E. Shelberg ◽  
L. H. Gevantman

Abstract This paper describes the use of an x-ray diffraction technique to correlate rubber radiation damage with rubber composition. Correlations between radiation damage and composition are useful as guides for the development of superior radiation resistant elastomers to be used as components of mechanical devices installed in high nuclear radiation fields. Rubber which is stretched and irradiated in an inert atmosphere is readily damaged by chain cleavage, manifested by loss of crystallinity, possible thinning, decreased x-ray diffraction intensities and eventual rupture (Figure 1). Loss of diffraction spot intensity was used to measure radiation damage in stretched rubber, and was tantamount to loss of crystallinity with little specimen thinning until just before rupture. Crystalline longevity was determined fur an irradiated “standard” rubber under standardized conditions and for other rubbers which were similar to the standard except for an added or substituted ingredient. A greater crystalline longevity connoted a greater radiation resistance, and the standard was used as 3 basis for comparing radiation resistance and composition.


Author(s):  
M. Isaacson ◽  
M.L. Collins ◽  
M. Listvan

Over the past five years it has become evident that radiation damage provides the fundamental limit to the study of blomolecular structure by electron microscopy. In some special cases structural determinations at very low doses can be achieved through superposition techniques to study periodic (Unwin & Henderson, 1975) and nonperiodic (Saxton & Frank, 1977) specimens. In addition, protection methods such as glucose embedding (Unwin & Henderson, 1975) and maintenance of specimen hydration at low temperatures (Taylor & Glaeser, 1976) have also shown promise. Despite these successes, the basic nature of radiation damage in the electron microscope is far from clear. In general we cannot predict exactly how different structures will behave during electron Irradiation at high dose rates. Moreover, with the rapid rise of analytical electron microscopy over the last few years, nvicroscopists are becoming concerned with questions of compositional as well as structural integrity. It is important to measure changes in elemental composition arising from atom migration in or loss from the specimen as a result of electron bombardment.


Author(s):  
T. E. Mitchell ◽  
M. R. Pascucci ◽  
R. A. Youngman

1. Introduction. Studies of radiation damage in ceramics are of interest not only from a fundamental point of view but also because it is important to understand the behavior of ceramics in various practical radiation enyironments- fission and fusion reactors, nuclear waste storage media, ion-implantation devices, outer space, etc. A great deal of work has been done on the spectroscopy of point defects and small defect clusters in ceramics, but relatively little has been performed on defect agglomeration using transmission electron microscopy (TEM) in the same kind of detail that has been so successful in metals. This article will assess our present understanding of radiation damage in ceramics with illustrations using results obtained from the authors' work.


Sign in / Sign up

Export Citation Format

Share Document