As a renewable energy source, biogas produced from anaerobic digestion seems to play an important role in the energy market. Unlike wind and solar, which are intermittent, gas turbines fueled by biogas provide dispatchable renewable energy that can be ramped up and down to match the demand. If post-combustion carbon capture systems are implemented, they can also result in negative CO2 emissions. However, one of the major challenges here is the energy needed for CO2 chemical absorption in post-combustion capture, which is closely related to the concentration of CO2 in the exhaust gas upstream of the capture unit. This paper presents an evaluation of the effects of biogas and exhaust gas recirculation use on the performance of the gas turbine cycle for post-combustion CO2 capture application. The study is based on a combined heat and power micro gas turbine, Turbec T100, delivering 100kWe. The thermodynamic model of the gas turbine has been validated against experimental data obtained from test facilities in Norway and the United Kingdom. Based on the validated model, performance calculations for the baseline micro gas turbine (fueled by natural gas), biogas-fired cases and the cycle with exhaust gas recirculation have been carried out at various operational conditions and compared together. A wide range of biogas composition with varying methane content was assumed for this study. Necessary minor modifications to fuel valves and compressor were assumed to allow the engine operation with different biogas composition. The methodology and results are fully discussed in this paper.