Two-Dimensional, Combined-Mode Heat Transfer by Conduction, Convection, and Radiation in Emitting, Absorbing, and Scattering Media-Solution by Finite Elements

1984 ◽  
Vol 106 (2) ◽  
pp. 448-452 ◽  
Author(s):  
T. J. Chung ◽  
J. Y. Kim
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Finite Elements ◽  
Prandtl Number ◽  
Gaussian Quadrature ◽  
Two Dimensional ◽  
Scattering Media ◽  
Converging Channel ◽  
Isoparametric Finite Elements ◽  
Combined Mode

This paper is concerned with a two-dimensional analysis of combined mode heat transfer using finite elements. Conduction, convection, and radiation are coupled in the emitting, absorbing, and scattering medium. The standard Galerkin finite elements can be used if the product of Reynolds number and Prandtl number is equal to or less than 1000. It is shown that the two-dimensional heat flux integration can be efficiently performed via Gaussian quadrature applied to isoparametric finite elements where no limitations to optical thicknesses are imposed. Numerical results are demonstrated for a diverging or converging channel. It is observed that the radiation effect on the temperature profile is more significant in the diverging than in the converging channel. Effects of Reynolds number, Prandtl number, albedo, and optical thickness upon temperature distributions are also investigated.

Numerical Study of Convective Heat Transfer From Expanding Annular Pipe Flows

2016 ◽  
Author(s):  
Khaled J. Hammad
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Prandtl Number ◽  
Convective Heat Transfer ◽  
Diameter Ratio ◽  
Wall Heat Transfer ◽  
Reattachment Point ◽  
Transfer Rates ◽  
Pipe Flows ◽  
Annular Pipe

Convective heat transfer from suddenly expanding annular pipe flows are numerically investigated within the steady laminar flow regime. A parametric study is performed to reveal the influence of the annular diameter ratio, k, the Prandtl number, Pr, and the Reynolds number, Re, over the following range of parameters: k = {0, 0.5, 0.7}, Pr = {0.7, 1, 7, 100}, and Re = {25, 50, 100}. Heat transfer enhancement downstream of the expansion plane is only observed for Pr > 1. Peak wall-heat-transfer-rates always appear downstream of the flow reattachment point, in the case of suddenly expanding round pipe flows, i.e. k = 0. However, for suddenly expanding annular pipe flows, i.e., k = 0.5 and 0.7, peak wall-heat-transfer-rates always appear upstream of the flow reattachment point. The observed heat transfer augmentation is more dramatic for suddenly expanding annular flows, in comparison with the one observed for suddenly expanding pipe flows. For a given annular diameter ratio and Reynolds number, increasing the Prandtl number, always results in higher wall-heat-transfer-rates downstream the expansion plane.

Effects of Heat Transfer During Peristaltic Transport in Nonuniform Channel With Permeable Walls

2016 ◽  
Vol 139 (1) ◽  
Author(s):  
Siddharth Shankar Bhatt ◽  
Amit Medhavi ◽  
R. S. Gupta ◽  
U. P. Singh
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Incompressible Fluid ◽  
Friction Force ◽  
Viscous Incompressible Fluid ◽  
Peristaltic Transport ◽  
Two Dimensional ◽  
Peristaltic Motion ◽  
Long Wavelength ◽  
Permeable Walls

In the present investigation, problem of heat transfer has been studied during peristaltic motion of a viscous incompressible fluid for two-dimensional nonuniform channel with permeable walls under long wavelength and low Reynolds number approximation. Expressions for pressure, friction force, and temperature are obtained. The effects of different parameters on pressure, friction force, and temperature have been discussed through graphs.

Numerical Study on Heat Transfer Characteristics From Parallel Plates With Cavities Swept by a Visco-Elastic Fluid

2010 ◽  
Author(s):  
Hiroshi Suzuki ◽  
Shinpei Maeda ◽  
Yoshiyuki Komoda
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Thermal Field ◽  
Numerical Study ◽  
Geometric Parameters ◽  
Two Dimensional ◽  
Parallel Plates ◽  
Heat Transfer Characteristics ◽  
Elastic Fluid ◽  
Heat Transfer Augmentation

Two-dimensional numerical computations have been performed in order to investigate the development characteristics of flow and thermal field in a flow between parallel plates swept by a visco-elastic fluid. In the present study, the effect of the cavity number in the domain and of Reynolds number was focused on when the geometric parameters were set constant. From the results, it is found that the flow penetration into the cavities effectively causes the heat transfer augmentation in the cavities in any cavity region compared with that of water case. It is also found that the development of thermal field in cases of the present visco-elastic fluid is quicker compared with that of water cases. The present heat transfer augmentation technique using Barus effect of a visco-elastic fluid is effective in the range of low Reynolds number.

Heat transfer from a circular cylinder by acoustic streaming

1967 ◽  
Vol 30 (2) ◽  
pp. 337-355 ◽  
Author(s):  
Peter D. Richardson
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Natural Convection ◽  
Circular Cylinder ◽  
Prandtl Number ◽  
Acoustic Streaming ◽  
Mean Flow ◽  
Wide Range ◽  
Transverse Oscillations ◽  
Streaming Flow

An analysis is described for convection from a circular cylinder subjected to transverse oscillations relative to the fluid in which it is immersed. The analysis is based upon use of the acoustic streaming flow field. It is assumed that the frequency involved is sufficiently small that the acoustic wavelength in the fluid is much larger than the cylinder diameter, and that there is no externally imposed mean flow across or along the cylinder. Solutions are presented which are appropriate for a wide range of Prandtl number, and the cases of small and of large streaming Reynolds number are distinguished. The analysis compares favourably with experiments when the influence of natural convection is small.

Numerical Analysis of Heat Transfer Enhancement in a Micro-Channel Due to Mechanical Stirrers

2020 ◽  
Vol 13 (1) ◽  
Author(s):  
M. Sreejith ◽  
S. Chetan ◽  
S. N. Khaderi
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Heat Transfer Enhancement ◽  
Peclet Number ◽  
Periodic Case ◽  
Two Dimensional ◽  
Transfer Enhancement ◽  
Fluidic Channel ◽  
Enhancement Of Heat Transfer ◽  
Péclet Number

Abstract Using two-dimensional numerical simulations of the momentum, mass, and energy conservation equations, we investigate the enhancement of heat transfer in a rectangular micro-fluidic channel. The fluid inside the channel is assumed to be stationary initially and actuated by the motion imparted by mechanical stirrers, which are attached to the bottom of the channel. Based on the direction of the oscillation of the stirrers, the boundary conditions can be classified as either no-slip (when the oscillation is perpendicular to the length of the channel) or periodic (when the oscillation is along the length of the channel). The heat transfer enhancement due to the motion of the stirrers (with respect to the stationary stirrer situation) is analyzed in terms of the Reynolds number (ranging from 0.7 to 1000) and the Peclet number (ranging from 10 to 100). We find that the heat transfer first increases and then decreases with an increase in the Reynolds number for any given Peclet number. The heat transferred is maximum at a Reynolds number of 20 for the no-slip case and at a Reynolds number of 40 for the periodic case. For a given Peclet and Reynolds number, the heat flux for the periodic case is always larger than the no-slip case. We explain the reason for these trends using time-averaged flow velocity profiles induced by the oscillation of the mechanical stirrers.

Low Reynolds number heat transfer from a circular cylinder

1968 ◽  
Vol 32 (1) ◽  
pp. 21-28 ◽  
Author(s):  
C. A. Hieber ◽  
B. Gebhart
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Number Theory ◽  
Circular Cylinder ◽  
Prandtl Number ◽  
Experimental Work ◽  
Reynolds Numbers ◽  
Low Reynolds Numbers ◽  
Low Reynolds ◽  
Theoretical Results

Theoretical results are obtained for forced heat convection from a circular cylinder at low Reynolds numbers. Consideration is given to the cases of a moderate and a large Prandtl number, the analysis in each case being based upon the method of matched asymptotic expansions. Comparison between the moderate Prandtl number theory and known experimental results indicates excellent agreement; no relevant experimental work has been found for comparison with the large Prandtl number theory.

Heat transfer to pulsating turbulent flow in an abrupt pipe expansion

2003 ◽  
Vol 13 (3) ◽  
pp. 286-308 ◽  
Author(s):  
S.A.M. Said ◽  
M.A. Habib ◽  
M.O. Iqbal
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Nusselt Number ◽  
Prandtl Number ◽  
Turbulent Flow ◽  
Pulsation Frequency ◽  
Pipe Expansion ◽  
Cent Increase ◽  
The Mean ◽  
Mean Time

A numerical investigation aimed at understanding the flow and heat transfer characteristics of pulsating turbulent flow in an abrupt pipe expansion was carried out. The flow patterns are classified by four parameters; the Reynolds number, the Prandtl number, the abrupt expansion ratio and the pulsation frequency. The influence of these parameters on the flow was studied in the range 104<Re<5×104, 0.7<Pr<7.0, 0.2<d/D<0.6 and 5<f<35. It was found that the influence of pulsation on the mean time‐averaged Nusselt number is insignificant (around 10 per cent increase) for fluids having a Prandtl number less than unity. This effect is appreciable (around 30 per cent increase) for fluids having Prandtl number greater than unity. For all pulsation frequencies, the variation in the mean time‐averaged Nusselt number, maximum Nusselt number and its location with Reynolds number and diameter ratio exhibit similar characteristics to steady flows.

Viscous Dissipation and Variable Properties Effect on Two Dimensional Conjugate Heat Transfer of Nanofluids in Microchannels

2011 ◽  
Author(s):  
A. Ramiar ◽  
A. A. Ranjbar
Keyword(s):  
Heat Transfer ◽  
Reynolds Number ◽  
Nusselt Number ◽  
Viscous Dissipation ◽  
Conjugate Heat Transfer ◽  
Energy Equation ◽  
Critical Reynolds Number ◽  
Two Dimensional ◽  
Variable Properties ◽  
Enhance Heat Transfer

Laminar two dimensional forced convective heat transfer of Al2O3–water nanofluid in a horizontal microchannel has been studied numerically, considering axial conduction, viscous dissipation and variable properties effects. The existing criteria in the literature for considering viscous dissipation in energy equation are compared for different cases and the most proper one is applied for the rest of the paper. The results showed that nanoparticles enhance heat transfer characteristics of the channel and inversely, viscous dissipation causes the Nusselt number and friction factor to decrease. The viscous dissipation effect may be emphasized by increasing Reynolds number and decreased by raising the exerted heat flux. Also, it was found that there is a critical Reynolds number below which the average Nusselt number of the nanofluid changes abnormally with Reynolds number as a result of variable properties effect.

Direct Numerical Simulation of Turbulent Channel Flow With Heat Transfer for Low Prandtl and High Reynolds and Comparison With Algebraic Heat Flux Model

2015 ◽  
Author(s):  
Haomin Yuan ◽  
Elia Merzari
Keyword(s):  
Heat Transfer ◽  
Numerical Simulation ◽  
Heat Flux ◽  
Reynolds Number ◽  
Prandtl Number ◽  
Direct Numerical Simulation ◽  
Liquid Metals ◽  
Turbulent Channel Flow ◽  
Flux Model ◽  
Heat Flux Model

The flow characteristic of fluid at low Prandtl number is of continued interest in the nuclear industry because liquid metals are to be used in the next-generation nuclear power reactors. In this work we performed direct numerical simulation (DNS) for turbulent channel flow with fluid of low Prandtl number. The Prandtl number was set to 0.025, which is representative of the behavior of liquid metals. Constant heat flux was imposed on the walls to study heat transfer behavior, with different boundary conditions for temperature fluctuation. The bulk Reynolds number was set as high as 50,000, with a corresponding friction Reynolds number of 1,200, which is closer to the situation in a reactor or a heat exchanger than used in normally available databases. Budgets for turbulent variables were computed and compared with predictions from several RANS turbulence models. In particular, the Algebraic Heat Flux Model (AHFM) has been the focus of this comparison with DNS data. The comparisons highlight some shortcomings of AHFM along with potential improvements.

Sign in / Sign up

Export Citation Format

Share Document