Ecological Optimization for an Endoreversible Chemical Pump With Three Mass Reservoirs

2018 ◽  
Author(s):  
Lingen Chen ◽  
Dan Xia ◽  
Huijun Feng ◽  
Shaojun Xia

This paper firstly educes an energy-based ecological function (EF) which is a compromise between energy pumping rate (EPR) and dissipation of EPR for an endoreversible chemical pump (CP) cycle. By solving the equations of Euler Lagrange, the fundamental optimization relationships of the EF and coefficient of performance (COP) for the CP cycles with linear mass transfer (MT) law and diffusive MT law are derived. The numerical calculations to analyze the influences of the cycle parameters on the relationship between the EF and COP are provided, and the influence of two different MT laws on the EF and COP characteristic is discussed in detail. The maximum EF of the cycle with the linear MT law is bigger than that with the diffusive MT law. The results obtained in this paper can be applied to design a class of devices, such as photochemical, electrochemical and solid-state apparatus as well as mass exchangers, etc.

Author(s):  
L Chen ◽  
D Xia ◽  
F Sun

A new cyclic model of a four-reservoir chemical pump with irreversible mass transfer, mass leakage, and internal dissipation is proposed in this paper. The optimal relation between the coefficient of performance (COP) and the rate of energy pumping of the generalized irreversible four-reservoir chemical pump is derived by using finite-time thermodynamics or thermodynamic optimization. The maximum COP and the corresponding rate of energy pumping, as well as the optimal time parameters of the four mass transfer processes and the optimal chemical potentials of the working fluid are also obtained. Moreover, the influences of these irreversibilities on the optimal performance of the chemical pump are revealed. It is found that the mass leakage affects the optimal performance qualitatively, and the characteristic curve changes from a monotonic decreasing function without mass leakage to a parabolic-like one with mass leakage; while the internal dissipation affects the optimal performance quantitatively, it does not change the shape of the characteristic curve but only decreases the peak value. The results obtained herein can provide some new theoretical guidelines for the optimal design and development of a class of chemical pumps.


Author(s):  
Dan Xia ◽  
Lingen Chen ◽  
Fengrui Sun

An isothermal endoreversible four-reservoir chemical pump cycle operating between a finite potential capacity high-chemical-potential mass reservoir and three infinite potential capacity mass reservoirs is established in this paper. Optimal control theory is applied to determine the optimal cycle configuration corresponding to the maximum energy output per cycle for the fixed total cycle time and transferred energy of high-chemical-potential mass reservoir in which the mass transfer between working fluid and mass reservoirs obey linear mass transfer law. The optimal cycle configuration is an isothermal endoreversible four-reservoir chemical pump cycle, in which the chemical potential (the concentration) of the key component in the finite potential capacity high-chemical-potential mass reservoir and that in the working fluid change nonlinearly with time and the difference between the chemical potential (the ratio of the concentration) of the key component in the finite potential capacity mass reservoir and (to) that in the working fluid is a constant, and the chemical potentials (the concentration) of the key component in the working fluid at the infinite potential capacity mass reservoir sides are also constants. Moreover, the numerical example is provided to reveal the influences of concentration and chemical potential change of the finite potential capacity high-chemical-potential mass reservoir on the optimal configuration of the four-reservoir chemical pump cycle. Then, a unified description of various isothermal endoreversible chemical cycles with linear mass transfer law is obtained. They include ten type of isothermal endoreversible chemical cycles: four-reservoir chemical pumps with finite potential capacity mass reservoirs and infinite potential capacity mass reservoirs, four-reservoir chemical potential transformers with finite potential capacity mass reservoir and infinite potential capacity mass reservoirs, three- reservoir chemical pumps with finite potential capacity mass reservoirs and infinite potential capacity mass reservoirs, three-reservoir chemical potential transformers with finite potential capacity mass reservoir and infinite potential capacity mass reservoirs, two-reservoir chemical pump with infinite potential capacity mass reservoirs, and chemical engine with infinite potential capacity mass reservoirs. The results can provide some guidelines for optimal design and operation of real chemical cycles and devices.


Author(s):  
D Xia ◽  
L Chen ◽  
F Sun

A new cyclic model of a four-mass-reservoir diffusion transformer with irreversible mass transfer, mass leakage, and internal dissipation is established in this paper. The optimal relation between the coefficient of performance (COP) and the rate of energy pumping of the generalized irreversible four-mass-reservoir diffusion transformer is derived by using finite-time thermodynamics. The maximum COP and the corresponding rate of energy pumping, as well as the maximum rate of energy pumping and the corresponding COP, are also obtained. Moreover, the influences of these irreversibilities on the optimal performance of the four-mass-reservoir diffusion transformer are revealed. It is found that the mass leakage affects the optimal performance both qualitatively and quantitatively, whereas the internal dissipation affects the optimal performance quantitatively. The results obtained herein can provide some new theoretical guidance for the optimal design and development of a class of four-mass-reservoir diffusion transformers.


Author(s):  
Jonathan Diesselhorst

This article discusses the struggles of urban social movements for a de-neoliberalisation of housing policies in Poulantzian terms as a “condensation of the relationship of forces”. Drawing on an empirical analysis of the “Berliner Mietenvolksentscheid” (Berlin rent referendum), which was partially successful in forcing the city government of Berlin to adopt a more progressive housing policy, the article argues that urban social movements have the capacity to challenge neoliberal housing regimes. However, the specific materiality of the state apparatus and its strategic selectivity both limit the scope of intervention for social movements aiming at empowerment and non-hierarchical decision-making.


1965 ◽  
Vol 5 (01) ◽  
pp. 15-24 ◽  
Author(s):  
Norman R. Morrow ◽  
Colin C. Harris

Abstract The experimental points which describe capillary pressure curves are determined at apparent equilibria which are observed after hydrodynamic flow has ceased. For most systems, the time required to obtain equalization of pressure throughout the discontinuous part of a phase is prohibitive. To permit experimental points to be described as equilibria, a model of capillary behavior is proposed where mass transfer is restricted to bulk fluid flow. Model capillary pressure curves follow if the path described by such points is independent of the rate at which the saturation was changed to attain a capillary pressure point. A modified suction potential technique is used to study cyclic relationships between capillary pressure and moisture content for a porous mass. The time taken to complete an experiment was greatly reduced by using small samples. Introduction Capillary retention of liquid by porous materials has been investigated in the fields of hydrology, soil science, oil reservoir engineering, chemical engineering, soil mechanics, textiles, paper making and building materials. In studies of the immiscible displacement of one fluid by another within a porous bed, drainage columns and suction potential techniques have been used to obtain relationships between pressure deficiency and saturation (Fig. 1). Except where there is no hysteresis of contact angle and the solid is of simple geometry, such as a tube of uniform cross section, there is hysteresis in the relationship between capillary pressure and saturation. The relationship which has received most attention is displacement of fluid from an initially saturated bed (Fig. 1, Curve Ro), the final condition being an irreducible minimum fluid saturation Swr. Imbibition (Fig. 1, Curve A), further desaturation (Fig. 1, Curve R), and intermediate scanning curves have been studied to a lesser but increasing extent. This paper first considers the nature of the experimental points tracing the capillary pressure curves with respect to the modes and rates of mass transfer which are operative during the course of measurement. There are clear indications that the experimental points which describe these curves are obtained at apparent equilibria which are observed when viscous fluid flow has ceased; and any further changes in the fluid distribution are the result of much slower mass transfer processes, such as diffusion. Unless stated otherwise, this discussion applies to a stable packing of equal, smooth, hydrophilic spheres supported by a suction plate with water as the wetting phase and air as the nonwetting phase. SPEJ P. 15ˆ


2012 ◽  
Vol 614-615 ◽  
pp. 64-68
Author(s):  
Tuo Wang ◽  
Feng Wu ◽  
Jin Hua Fei ◽  
Ming Fang Liu

Thermo-acoustic refrigerator is a new type of engine, which is based on the thermo-acoustic effect. A new model which expresses as an ellipse in pressure-volume diagram is established to investigate the thermodynamic performance of an actual thermo-acoustic refrigeration micro-cycle. The demarcation points of endothermic processes and exothermic processes in the actual micro-cycle are found. The analytic expressions of the dimensionless cooling load and the coefficient of performance (COP) are deduced. The relationship between the dimensionless cooling load and the COP are investigated by numerical examples. The results show that the dimensionless cooling load is a monotonically increasing function of the COP and the pressure amplitude.


2011 ◽  
Vol 399-401 ◽  
pp. 2222-2225 ◽  
Author(s):  
Peng Qi ◽  
Jing Zhang ◽  
Zhi Rong Mei ◽  
Yue Xiu Wu

A mathematical models for the coupled problem is established by considering heat and mass transfer and phase change for rock mass at low temperature, according to the theory of heat and mass transfer for porous media. It is considered of the influences of fluid transfer on the heat conduction and the temperature gradient on the seepage. By adopting the finite element method, the numerical simulation is done to study the range of frost-thaw of surrounding rock and the effects of insulation material in cold regions, which analysis the influence of tunnel depth and surrounding rock class on the range of frost-thaw, the change law of the frost-thaw area of different insulation material and the relationship between the frost-thaw area and the thickness of insulation material.


Micromachines ◽  
2021 ◽  
Vol 12 (9) ◽  
pp. 1012
Author(s):  
Takuya Mabuchi ◽  
Koki Nakajima ◽  
Takashi Tokumasu

Atomistic analysis of the ion transport in polymer electrolytes for all-solid-state Li-ion batteries was performed using molecular dynamics simulations to investigate the relationship between Li-ion transport and polymer morphology. Polyethylene oxide (PEO) and poly(diethylene oxide-alt-oxymethylene), P(2EO-MO), were used as the electrolyte materials, and the effects of salt concentrations and polymer types on the ion transport properties were explored. The size and number of LiTFSI clusters were found to increase with increasing salt concentrations, leading to a decrease in ion diffusivity at high salt concentrations. The Li-ion transport mechanisms were further analyzed by calculating the inter/intra-hopping rate and distance at various ion concentrations in PEO and P(2EO-MO) polymers. While the balance between the rate and distance of inter-hopping was comparable for both PEO and P(2EO-MO), the intra-hopping rate and distance were found to be higher in PEO than in P(2EO-MO), leading to a higher diffusivity in PEO. The results of this study provide insights into the correlation between the nanoscopic structures of ion solvation and the dynamics of Li-ion transport in polymer electrolytes.


Sign in / Sign up

Export Citation Format

Share Document